ASSEMBLY INSTRUCTIONS STYLE# 21224 Careful unpack all lamp parts from the carton. 1.Take the lamp carefully out of the Carton,and place it on a flat surface. 2. Be sure the power to the installation point is power off 3. Put the marble into the shade, then put the stem on the marble to secure the marble tight. 4.Thread Stem into the coupling underside of the socket cluster, hand tighten until snug. 5.Place the Ceiling Canopy over the Mounting Screws and thread Mounting Balls onto the Mounting Screws to secure it , hand tighten until snug. 6.Located the following components over the end of the Center stem in turn Diffuser ,Rubber washer,Flat washer. 7.Thread the Hex Nut onto the end of the Center Stem and tighten until snug to secure the above parts,threaded Finial onto the end of the Stem and hand.tighten until snug. 8.Install bulbs (not included).See label located at socket area for type and maximum allowed wattage.