ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Installation Steps
1. Carefully unpack your new fixture and lay out all the
parts on a clear surface.
2. Thread Hex nut-2 onto the Nipple, place the Washer over
the end of Nipple, thread Nipple through Mounting bar
and secure with Hex nut-1 continue until tight.
3. Thread the Ground screw into the hole near the two dimples
of the Mounting bar. Secure the Mounting bar to the outlet box
with the Outlet box screws.
4. Weave the Fixture Wire and the Ground Wire through the
Chain links-1. (Remark: Two pairs of Chain links-2 are standbys,
they can be used to adjust the fixture’s high).
5. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to Black
Wire from power source.
---The ribbed wire (w/o marking) from Fixture to White
Wire from power source.
---Attach the Ground Wire and house ground wire to
the Mounting bar with the green Ground Screw.
Carefully tuck wires back into the Outlet Box.
6. Raise the Canopy onto the Nipple, and then secure with
the Ball nut.
7. Place the Glass shade, Cup onto the Socket, and secure
with the Socket ring.
8. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
9. Turn on the power at fuse or Circuit Box.