Warehouse of Tiffany RL8064 Instructions / Assembly


Add to my manuals
1 Pages

advertisement

Warehouse of Tiffany RL8064 Instructions / Assembly | Manualzz
- eee
-— m— a сть
ASSEMBLY INSTRUCTIONS
MODEL# : RL8064
NOTE: (iv the technical personnel ces be alioete fix Эла пота
IMPORTANT!
Make xtire thaï the power ix syiteh off ar the electricias mains mupply before
Comment ing work
FIXING INSTRUCTIONS
|. Wiredrawing laspshade (381 wid] be fixed on the Main body nipe 077 stove, it fixed
hornhocd (16), and eres on the cristal rings (7) |
2 Take cut seres (4) and rotate |v into crystal lifting ring (7) (nt least Bam) and
then tightened with washer (6) Zboxagonal nut iS).
3 Notate the cow not of screws) till close to the first nut and hes rolate screw
(4}into batten(13;. Make sore scree (4) should go through battent 13).
4, Use cuter box screws (34) to fix batten (13) on outlet box (1).
5 Take cut ring cover{®) from erystal lifting ving (7) and then let the cancpy (8)
through crysis! lifting ring (7), Adjust the crystal lifting ring to a cortaia
height.
© Tighten the nut to fix on batten (13) in the right position.
7. Ground Connection (See picture 1): there are one tapping hole A two dimples,
Wind the supply ground wire (2) on the green ground screw (15) and then put it into
tapping hole. Connect the fixture ground wire (3) with supply ground wire (2) by
connecting terminal (12). Caution: DO NOT connect ground wire with supply power
“ire
8-Connect fixture supply wire (10) with power supply wire {11}. Caution: Wesembez
to distinguish the positive and negative charges. (Sas picture 2)
S. Posh canopy (6) up to the ceiiing ’
10. Artach ving cover (9) on crystal lifting ring end fix can pv (8 as sell.
11. Put shade (15) on holder and tightened with out ring
12. Screw bulb in the holder.
REPLACEMENT BULB
Do not exceed the max ioum wattage.
Light bulls recossended: RLB064-El2-4050 Max, Type E
CLEANING CARE
Clean with a soft dry cloth,
SAFETY INFORMATION
1.Lamp used must in rated voltage. and de not 1och 16e bulb with bare hands _
Always switch off the electricity sopply and allos te cool for 10 mínures before
changing the Hight bulbs
LIT the external cables hove been desaped, PIs change or repair bi manufacturer or
Service agency or professional electrician, In order ta avoid the dista:
у nd Vite
mn
Cromding Detail) i
Pate or Ny
Toe
Vice Sopely Wire
Blech Flature Etre
Bla Supply Vice [2
e
[€

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement