Design House 519660 Instructions / Assembly

ASSEMBLY AND INSTALLATION (CONT.)
AJAX PENDANT
ASSEMBLY/INSTALLATION INSTRUCTIONS
MOUNTING SCREWS
JUNCTION BOX
CROSS BAR
Item # 519660 (AJAX PENDANT GAL)
Item # 519678 (AJAX PENDANT BRZ)
FIXTURE
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
GROUND SCREW
SCREW HOLES
BALL NUTS
C
SHORT STEMS
WARNING: Risk of Fire. Min 75ºC supply conductors. Consult a qualified electrician to ensure correct
installtion.
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible
shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician.
B
A
FIXTURE SCREWS
WIRE NUTS
STEM
BOTTOM STEM
Remove the fixture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
Phillips screwdriver.
TOOLS REQUIRED
ASSEMBLY AND INSTALLATION
LAMP HOLDER
IRON RACK
Turn off the power at fuse or circuit breaker.
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS
and the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) MOUNTING
SCREWS.
2. Attach BOTTOM STEM to LAMP HOLDER. Then, install STEM and SHORT STEMS based on
the desired length of the item, adding FIXTURE once finished.
3. Make wire connections with WIRE NUTS:
A - Connect the black wire from Fixture to the black supply wire.
B - Connect the white wire from Fixture to the white supply wire.
C - Attach the fixture ground wire to the CROSS BAR with the green GROUND SCREW. Then
connect it to the supply ground wire with a WIRE NUT. Carefully tuck wires back into the JUNCTION
BOX.
4. Attach the FIXTURE to the CROSS BAR through SCREW HOLES as shown, and secure it with
BALL NUTS.
5. Attach the IRON RACK to the LAMP HOLDER and secure it with SOCKET RING.
6. Install BULB (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
7. Attach the IRON RACK (01) to the IRON RACK as shown, and secure it with DECORATIVE NUTS.
Turn on the power at fuse or circuit breaker.
SOCKET RING
BULB (not included)
IRON RACK (01)
DECORATIVE NUTS
#519660
#519678
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Customer Service 1-800-558-8700