Design House 519801 Instructions / Assembly

ASSEMBLY AND INSTALLATION (CONT.)
ESSEX 3LT ISLAND LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
MOUNTING SCREWS
JUNCTION BOX
Item # 519801 (ESSEX 3LT ISLAND LIGHT GAL)
Item # 519793 (ESSEX 3LT ISLAND LIGHT BRZ)
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
CROSS BAR
GROUND SCREW
CEILING PLATE
C
SCREW HOLES
BALL NUTS
B
installation.
A
FIXTURE SCREWS
WIRE NUTS
shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
referencing the illustrations on the installation instructions.
Phillips screwdriver.
TOOLS REQUIRED
STEMS
FIXTURE
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker.
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS and
the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) MOUNTING
SCREWS.
2. Install STEMS based on the desired length of the item, adding CEILING PLA
3. Make wire connections with WIRE NUTS:
A - Connect the black wire from Fixture to the black supply wire.
B - Connect the white wire from Fixture to the white supply wire.
connect it to the supply ground wire with a WIRE NUT. Carefully tuck wires back into the JUNCTION
BOX.
4. Attach the CEILING PLATE to the CROSS BAR through SCREW HOLES as shown, and secure it
with BALL NUTS.
5. Install BULBS (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
Turn on the power at fuse or circuit breaker.
SOCKET RING
BULB (not included)
#519801
#519793
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Customer Service 1-800-558-8700