none 18102 Installation Guide

 el as a ай, LE eb PRE a ENE LE TAL
When using electrical equipment, basic safety precautions
shouid always be followed. These include the following:
2. Do not use outdoors.
3. Do not let power supply cords touch hot surfaces.
4. Do not mount near gas or electric heaters.
5. Use caution when handling batteries. Avoid possible shorting.
. Equipment should be mounted in locations and at heights where it will not readily b be
subjected to tampering by unauthorized personnel.
7. The use of accessory equipment not recommended by the manufacturer may cause an
unsafe condition.
8. Do not use this equipment for other than its intended use.
>
STRUCT ONS
1. Turn off AC power.
2. Extend unswitched AC line to unit location.
3. Remove both lenses by pulling away from housing.
Do not lift unit by lenses. (Diagram A)
4, Remove unit backplate by releasing two tabs at the |
bottom with a narrow screwdriver blade, and pull
away. (Diagram B)
5. For WALL OR CEILING MOUNTING, place screws
through appropriate keyhole slots and tighten. Be sûre
to crient the backplate, so the test switch faces the
bottom, or desired direction, if ceiling mounted.
FOR MOUNTING TO A JUNCTION BOX ,complete
wiring connections as per Step 6, and secure to box
by removing appropriate knockouts in backplate.
FOR CONDUIT ENTRY, secure backplate to wall or
ceiling with suitable anchors. Knock out the conduit
entry hole in the top of the unit housing, and install
conduit with bushing. ©
6. Attach unswitched AC circuit wires to unit AC input
wire with wirenuts. INSULATE UNUSED LEAD.
For 120 VAC input, follow Diagram C.
For 277 VAC input, follow Diagram D.
7. When ready to energize AC circuit, connect red
battery lead to battery positive terminal, Verify battery
negative terminal is connected to battery blue wire.
8. AC must be off when mating unit housing to back
plate. Align AC connector over circuit board and press
onto backplate until the retaining tabs snap through
the housing. Reinstall both lenses by slight squeezing
of the top and bottom mounting tabs.
TESTING:
Totest, depress test switch. The emergency lamps will
illuminate. When switch is released, lamps will go off.
Allow unit to charge for 48 hours before full load testing.
IMPORTANT NOTICE:
This equipment is furnished with a low voltage disconnect
circuit to prevent damage by over discharging the battery.
However, if the AC supply to the unit is to be disconnected
for prolonged periods of time the battery
MUST BE DISCONNECTED.
If unit fails to perform as described, disconnect AC and | battery
immediately, and contact either the factory or trained service
personnel for assistance.
RELAMPING:
To relamp, pull lenses from housing. Relamp only: with type
T-5 6V 5.4W, wedge- base lamp.
DIAGRAM A
DIAGRAM B
t
Ent - Keyhole Slots U
— Locking Tabs (2) — i
Conduit :
— = Entry KO :
> ko
DIAGRAM C
A
LINE RB — || RED
| |L BLACK
120 VAC
NEUTRAL WHITE ||| WHITE UNIT TOR
Ÿ
E
LINE ||| Во
BLACK B§————— 277 VAC
WHITE WHITE
NEUTRAL || CONNECTOR |