Home Decorators Collection 1236020280 Installation Guide

HDC#: 1236020280 MFG#: PKW-5624

Please read over the instructions, it will be a time-saver in the long run.

Mounting Screw

Glass shade

Wire Cage

Socket

1.

2.

Pull out all wires(White, Black, and Ground) out of junction box.

Unscrew Compression Nut(F) from Canopy (E) and slide Canopy (E) down cord, Then unscrew Finial Nut(D) from the Crossbar(A). and slide the Crossbar(A) to suitable place to

3.

ease installation of Crossbar (A) to junction box.

Mount the Crossbar (A) to the junction box by using provided Mounting Screws (B) as shown

in the picture.

4.

Using Wire Nuts (C) connect black wire from fixture to black wire from junction box. Connect white wire from fixture to white wire from junction box. Connect green wire of fixture to green or copper ground wire from the junction box. NOTE: Some junction boxes may not have a ground wire. In this case, attach green wire from the fixture to the ground screw located on

Crossbar (A), as shown in the picture.

5.

Tuck wires back into junction box.

6.

Screw Finial Nut (D) onto Crossbar, Slide Canopy (E) back up cord and against the ceiling, then use Compression Nut (F) to fix the Canopy (E), pls don't over tighten the Compression

7.

Nut (F).

To install bulb into star cage, first open cage by grabbing pointed panel with small hook at bottom and pulling outward.Thread bulb into socket until secure. Then close panel back, making sure the bottom hook snaps back in place.

8.

Install bulb (not included).