Laura Ashley PSY067 Installation Guide

Assembly Instructions

Selby Collection Pendant # PSY067

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Contents of Spare Parts:

Assembly Kit (1 SET)

(4297MM)

Outlet Box

House Grounding Wire

Wire Nut

Screw

Mounting Strap

Lock Nut

Mounting Screw

Canopy

Plastic Screw

Ball Nut

Cap Nut

Cord

1. Thread two screws through the mounting strap, then secure

them with two lock nuts. Adjust the length of the screws if

necessary.

2. Attach the mounting strap to the outlet box by using two

mounting screws.

3. Measure the desired length of the cord (A) from the canopy to

the top end of the cap nut. Leave additional 8" cord (B) above

the canopy, then cut off the unnecessary cord. (See Fig.2)

4. Mark the 3" cord (C) from the top of the cord. Use a knife to peel

off the insulation of the cord (C) carefully to show three inside

wires out. (See Fig.2)

Caution: Cutting too deep may cut off three inside wires and

destroy the insulation surface of the three inside wires.

5. Peel off the three wires from the top at about 5/8" length(D) to

expose the copper for wiring. (See Fig.2)

6. Pull the cord down slightly until the strain relief touches the

inside of the canopy. Then secure the plastic screw. (See Fig.1)

7. Pull out the outlet wires and the house grounding wire from

the outlet box. Make wire connections using the wire nuts:

a. The clear wire marked "L" from the fixture to the black

wire from the power source.

b. The clear wire with white line and marked "N" from the

fixture to the white wire from the power source.

c. The clear grounding wire with green line and marked

" " from the fixture to the green grounding wire from

power source.

Carefully put wires back into the

outlet box.

8. Attach the canopy to the mounting

strap by inserting the screws, then

secure it with the ball nuts.

9. Install a bulb (not included). Note

relamping label at socket or

packaging area for maximum

allowed wattage.

10. Turn on the power at the main

fuse or circuit breaker box.

Cap Nut

Fig.1

Cord

Strain Relief

Canopy

Plastic Screw

A

B (8")

D (5/8")

Cap Nut

Socket

Shade

Bulb Type B Max.60W

(not included)

Cord

Canopy

C (3")

Fig.2