Enviromate Products RMNDIYSLR Installation Guide

Enviro-Light LED Solar Light Source

Directions for Installation

1: Remove the black pull tab located below the three LEDs on the underside of the unit. This will activate the battery pack. The unit requires at least four complete day and night cycles to achieve maximum performance. (Fig. 1)

2: Loosen the existing screws holding your address plaque to the wall. (Fig. 2)

Fig. 2

3: Remove the locking screw from the back bracket, and remove the bracket from the cover.

(Note: Bracket is not required for this method of installation) (Fig. 3) Holding the address sign in position, place the solar cover onto the top of the address frame, placing the lip of the cover behind the frame itself. (Fig. 4)

Tighten the existing address plaque screws until they are secure. (Fig. 5)

Fig. 4

Fig. 1

Fig. 3

Fig. 5

Alternative mounting instructions

1: Remove the black pull tab located below the three LEDs on the underside of the unit. This will activate the battery pack. The unit requires at least four complete day and night cycles to achieve maximum performance. (Fig. 1) surface over the item that you want to illuminate.

Using the outer holes of the bracket as a template, mark and drill two holes into the surface making sure that the bracket is level. Use the supplied plugs and screws to secure the bracket to the mounting surface. (Fig. 7)

2: Remove the locking screw from the back bracket. Remove the bracket from the cover by sliding it downward. (Fig. 6)

3: Place the bracket in position on the mounting

4: Mount the Solar cover onto the bracket by aligning the slots in the cover over the two bracket guides, and pushing down on top of the cover.

Secure the cover with the locking screw provided.

(Fig. 8)

Fig. 7

Fig. 8

Fig. 6