Ariel SS-807A Installation Guide

D r a wing o f wate r c onne c t ion
As the“
”
“
”from the picture,please make the connection according to the serial number v1,v2,etc.
Top shower
Switch
valve
Movable
shower head
Cold/hot
water
switch 冷水管
Hot water connection
(red pipe)
Cold water connection
(blue pipe)
WS-807A
Switch
valve
Water fall
Foot
massage
Nozzle
Nozzle
Steam
generator
Do not dispose this product as unsorted municipal
waste. Collection of such waste separately for special
treatment is necessary.
Dear Guest,
Thank you very much for purchasing our sanitary ware. To
enable you to use this product safely and effectively, please
read this installation and operation manual carefully before
use.
CAUTIONS
1. Please ensure that the product installed reliable electric leakage
protection device, the power plug contains earth line, and make
sure it is reliable earth line. Check the protect system of leakage
protection each time before use.
2.Do not turn on water pump, heat pump or air bubble pump without
water.
3.Before turn on water pump, check if the water level over jets 10 to
20 mm or not, make sure regular usage of water pump otherwise it
will be destroy because of water leakage.
4.People with Hypertension symptom, after drink or heart disease
are not allowed to use the bathtub. Children have a bath must under
adult's guidance.
5.During use please noticed that don't blocked the jets and avoiding
the air adjustment valve overflowing. Also keep the bathtub clean
and don't let it blocked by hair or mess.
6.During use, please firstly adjust the water temperature or it will be
burned.
7.The bathtub is designed with ergonomic, rise and fall changes are
quite big so during usage pay more attention of be slipped.
8.Please shut down the system when not to use.
(STEP 5)
(STEP 6)
TECHNIQUE PARAMETER
Voltage
Frequency
Water
Volatge
Power of
steam
generator
Power of
water pump
Power of
heat pump
Power of
air pump
AC220V(±10%)
50/60H Z
0.1~0.2Mpa
3KW
0.75KW
1KW
0.2KW
01
CAUTIONS: Air pump and bottom light are required by customer.
06
SKETCH
Plastic pad
9
10
15
11
12
13
2
3
14
4
16
6
18
7
20
5
(STEP 2)
Chain wheel of glass door
17
19
21
8
22
1
Specification
SP 4x15
(STEP 3)
1.bottom bathtub
2.exhaust fan
3.moveable shower
4.handrail
5.control panel
6.foot massage
7.room body
8.steam out
Specification
M 6x15
Specification
SP 4x15
05
(STEP 4)
9.top lamp
10.roof
11.top shower
12.decorated light
13.speaker
14.temperature sensor
15.ozone
16.mirror
17.switch
18.cold/hot water switch
19.switch
20.nozzle
21.waist-shaped board
22.doorknob
02
1.tap
2.drainage switch
3.control panel
4.air conditioning
5.water in
6.nozzle
7.drainage
8.pillow
3
4
2
7
8
6
ILLUSTRATION OF INSTALLATION
1
9
5
9.air bubble jet
INSTALLATION SKETCH
The socket
of power and
the socket
of telephone
1.The products should be installed by technical guy who are got
the certificate or those technical who are assign by dealers. The
main power switch and electronic leakage device should be
installed.
2.The plug of electronic should be installed above the steam
generator and the length of electronic wire not less then
1800MM from the earth.
3.There are should be with main power switch for hot and cold
water pipe of steam room and the water pipe should be connect
to drainage water pipe.
4.Install the products according to the diagram of installation
When fixed the place for the products.
INSTALLATION PROCESS
90
0
1250
1500
Cold water pipe
400
The socket
of power
Hot water pipe
2250
150
200
1710
910
250
650
(STEP 1)
03
04