Advantech DLL Driver User Guide

Advantech DLL Driver User Guide

1.The following is the CD content.

2. First, we have to install the Advantech DeviceManager.

3. And install the Device Driver.

4. Insert the Device, (If PCI or ISA device, turn off the computer and insert the card.), then it will be detected atomically (For PCI or USB, if ISA device, we have to add it in Advantech

DeviceManager)

5. Wire the circuit, Configure and Test the Device in the DeviceManager.

6. We have to check what Software function this Device can support. So we check it in the

Device Driver manual.

7. There are full of information here.

8. It’s helpful if we can know what example can be used for our device. And there are hyperlinks to link with the Example instruction and locate the example path. Please note the example package have to been installed first.

8. Then we can operate the selected example and refer to the source code to write our own program.

The USB module doesn’t have the Interrupt Counter count.

The setting of PCI/ISA card is as following. (Suppose using PCI-1710)

The PCI/ISA Device have the Interrupt Counter count.

My signal source is 1Khz Square waveform.

When using 100Khz sampling rate to sample the waveform, there should be 100 data to present one cycle of Square waveform. So 50 points are in Low Level and 50 points are in High Level.

--End—