Clarke RWL30 Operating instructions

Add to my manuals
4 Pages

advertisement

Clarke RWL30 Operating instructions | Manualzz

30 LED Rechargeable Worklight

Model No: RWL30

Part No: 4002830

OPERATING INSTRUCTIONS

GC01/12

DECLARATION OF CONFORMITY

2

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

INTRODUCTION

Thank you for purchasing this CLARKE product. Before using the worklight, be sure to read these instructions thoroughly. In doing so you will ensure the safety of yourself and of others around you, and you can look forward to the product giving you long and satisfactory service.

GUARANTEE

This CLARKE product is guaranteed against faulty manufacture for a period of

12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for its intended purpose.

Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights.

PACK CONTENTS

1 x 30 LED Worklight 1 x AC Mains Adaptor/Charger Assembly

1 x 12 Volt DC Charging Adaptor (car cigarette lighter plug type)

BATTERY CHARGING AND CARE

1. Always use only the charging adapters supplied. The mains charger is for indoor use only. The worklight should only be re-charged when switched off. Never turn the light on while charging as this may damage the unit.

2. When charging a low battery using the adaptor/charger, the red LED beside the charging jack will initially illuminate, before changing to the

Green LED when the unit is sufficiently charged for continued use.

3. The battery must be re-charged at least every three months. Failure to recharge the battery will lead to reduced performance of the worklight and to premature battery failure. Note that the batteries cannot be replaced.

4. If you plan to store the worklight (e.g. for emergencies), we recommend that the battery is fully charged before doing so, this will ensure the longest possible battery life.

5. Never abuse the charger cable or yank the cable to disconnect it. Keep the cable away from sharp edges/hot surfaces.

6. Never point the light directly at the face of another person or an animal.

AC CHARGING

1. Connect the AC charging adaptor to the charging jack of the worklight.

2. Connect the other end of the charger to the 230v mains power supply and charge for approximately 1 hour.

The worklight must NOT be operated when using the AC charger.

3

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

DC CHARGING

1. Connect the DC charging adaptor to the charging jack of the worklight.

2. Connect the other end of the charger to the vehicle cigarette lighter socket and charge for approximately one hour.

OPERATION

1. Press the on/off button to switch on the worklight.

• Up to 3 hours of light can be obtained before the batteries are drained.

2. Press the on/off button again to switch the worklight off.

3. Attach the worklight to a suitable support using the folding hook or attach to a ferrous metal surface using the magnetic retainer.

4. Never shine the light directly into anyones eyes.

CLEANING

To keep your worklight clean, wipe with a damp cloth only, DO NOT use detergents, chemicals or harmful abrasives. Never immerse in water.

ENVIRONMENTAL PROTECTION

Do not dispose of this product with general household waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of according to the laws governing Waste

Electrical and Electronic Equipment.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Questions and Answers

How long does the worklight take to charge?
Approximately 1 hour using either the AC or DC charging adapters.
How long will the worklight operate on a single charge?
Up to 3 hours of light can be obtained before the batteries are drained.
How often should the battery be recharged?
The battery must be recharged at least every three months, even if the worklight is not being used.
What is the recommended way to store the worklight?
Store the worklight with a fully charged battery to ensure the longest possible battery life.
How do I clean the worklight?
Wipe the worklight with a damp cloth only. Do not use detergents, chemicals, or harmful abrasives, and never immerse the worklight in water.
How do I dispose of the worklight?
Do not dispose of the worklight with general household waste. All tools, accessories, and packaging should be sorted, taken to a recycling center, and disposed of according to the laws governing Waste Electrical and Electronic Equipment.

Related manuals

Download PDF

advertisement