advertisement
HD-250-U2 SERIES (Aluminum) USER MANUAL
I. Features
• USB 2.0 Interface, support high speed data transfer rates up to 480 Mbps
(Backward compatible with USB 1.1 specifications)
• Hot swappable and true Plug-n-Play
• Fully compatible with 2.5” SATA I and SATA II hard disk
• Suitable for Notebook and Desktop
• Insulating designed PCB
• Aluminum case
II. Specification
• HDD: 2.5” SATA I/II up to 500GB
• Interface type: USB 2.0
Transfer rates up to 480 Mbps
• Material Case: Aluminum/ABS
• USB Bus Powered
• Power LED/HDD LED
III. Installation Tutorial
Part I: Install Hard Disk (SATA HDD) - Can not support IDE HDD
1. Un-load 2 screws from front panel with led
2. Remove the front panel from case
3. Connect the SATA HDD to the SATA slot on the PCB board firmly
Part II: Instructions
The 2.5" HDD Enclosure connects to the host computer through Y-USB cable. This comes with Y-USB cable having xType A connector for connection to
2xUSB port on the host notebook or rear 2xUSB of your desktop; and Type B USB direct to the enclosure.
(Users of Windows 98 need to download the driver first)
IV. System requirements
Notebook/Desktop PC
- USB 2.0 Hi-Speed PCI card installed in your computer or the System built in
USB 2.0 host ports already
- Pentium X86 processor or above
- OS, Microsoft Windows 98 SE, 2000 Professional, Me, or XP Home,
XP Professional, Vista.
Note: Windows 98 user, please download the driver from
http://www.coolmaxusa.com/driver.asp
Mac OS Users
- Apple Macintosh G4 or G3 (blue and White G3 only) or iMac computer
with built-in USB controller
- Mac OS 8.6 or above with Mac OS USB V1.3.3 or above, including OS X
Mac OS uses FAT32 format only for hard drives
V. Materials included
1. 2.5" Aluminum HDD Enclosure
2. Zippy Bag for enclosure
3. Y-USB Cable
4. Accessories pack (screws)
5. Screw driver
4. Screw the front panel with the SATA drive back to the case
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project