STEP 3 Battery installation
Quick start guide
1. Align the two holes in the plug with the socket pins,
then snap the plug into place. Place the battery in the
compartment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it clicks into
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
Telephone outlet
STEP 1 Check package contents
1. Press TIME/SET to listen to the current setting.
2.Press TIME/SET again to indicate changes needed.
3.Press CHANGE to change the day, hour, minute, or year.
4.When you hear the correct setting, press TIME/SET to
advance to the next setting.
If you have caller ID service, the time will automatically
be updated with the first incoming call after you
program the year into the system.
Make sure your phone’s packaging includes the following:
Telephone base
Telephone line cord
Base power adaptor
Belt clip
Wall mount bracket
Set the clock
Record your outgoing announcement
1. Press SETUP, the system announces “Announcement.
Press PLAY or press RECORD. To continue setup, press
2.Press REC/MEMO and speak toward the MIC to record an
announcement for up to 90 seconds.
3.Press PLAY/STOP / ( when finished recording).
For complete feature instructions, please refer to your
user’s manual.
Quick start guide
User’s manual
STEP 2 Connect power to telephone base
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base.
STEP 4 Charge the battery
1. Place the handset in the telephone base.
STEP 6 Making and receiving calls
Making a call
or SPEAKER and listen for dial tone.
• Press
AC power outlet
If your product is not working properly:
1. Refer to your user’s manual.
2. Visit our website at or in Canada,
3. Call our customer service at 1-800-595-9511 or 1-800-2677377 in Canada.
• Dial the phone number.
-OR• Dial the phone number.
• Press
Receiving a call
• Use only the power adaptors supplied with your
VTech telephone.
, SPEAKER, or any dialing key except OFF.
Hanging up
Press OFF or place
the handset in its
telephone base.
Download PDF
Similar pages
Unison Mosaic Designer User Manual
Quick start guide
I6725 Quick Start Guide
VTech 6052 User`s manual
i6720 - VTech Communications