IP Link® Device Interface
Communication Sheet
eclr_25_6096_1.pke
Revision: 9/20/2012
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user's manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Audio Processor
Ecler
N/A
CA40
Version History:
Driver
Version
1
Date
9/11/2012
IP Link
Compiler
GC
Version
1.5.1
3.3.2
Notes
Initial version.
Driver Notes:
 The driver has been optimized for Volume command
Page 1 of 4
IP Link® Device Interface
Communication Sheet
eclr_25_6096_1.pke
Revision: 9/20/2012
Control Commands & States:
Input
Line 1
Line 2
Line1 and Micro
Line2 and Micro
Line 1
0 to 64 in steps of 1
Line 2
0 to 64 in steps of 1
Master Volume (Discrete)
0 to 64 in steps of 1
Microphone
0 to 64 in steps of 1
Mute
On
Preset Recall
1 to 5
Preset Save
1 to 5
Microphone
Off
Status Available:
Connection Status
Connected
Disconnected
Input
Line 1
Line 2
Line1 and Micro
Line2 and Micro
Line 1
0 to 64 in steps of 1
Line 2
0 to 64 in steps of 1
Master Volume (Discrete)
0 to 64 in steps of 1
Microphone
0 to 64 in steps of 1
Mute
On
Preset Recall
1 to 5
Off
Page 2 of 4
Microphone
IP Link® Device Interface
Communication Sheet
eclr_25_6096_1.pke
Revision: 9/20/2012
MLC60 Series Supported Commands:
Input
Line 1
Line 2
Line1 and Micro
Line2 and Micro
Line 1
0 to 64 in steps of 1
Line 2
0 to 64 in steps of 1
Master Volume (Discrete)
0 to 64 in steps of 1
Microphone
0 to 64 in steps of 1
Mute
On
Preset Recall
1 to 5
Preset Save
1 to 5
Off
Page 3 of 4
Microphone
eclr_25_6096_1.pke
IP Link® Device Interface
Communication Sheet
Revision: 9/20/2012
Cable and Adapter Requirements:
RS232 to captive screw
Notes for the Device:
Serial communication:
Port Type: RS-232
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Pin Assignments Diagram:
Note: Captive screw connector may also be used as a serial connection.
General Notes:
Page 4 of 4