IP Link® Device Interface
Communication Sheet
eclr_25_6478_1.pke
Revision: 4/22/2013
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user's manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Audio Processor
Ecler
N/A
CA200Z
Version History:
Driver
Version
1
Date
4/3/2013
IP Link
Compiler
GC
Version
1.5.1
3.3.2
Notes
Initial version.
Driver Notes:
Driver has been optimized for Volume.
Page 1 of 4
IP Link® Device Interface
Communication Sheet
eclr_25_6478_1.pke
Control Commands & States:
Executive Mode
On
Off
IR Remote
On
Off
Power Control
On
Off
Preset Recall
1 to 5
Preset Save
1 to 5
Zone 1-2 Audio Mute
On
Off
Zone 1 Input 1-6
On
Off
Zone 1-2 Master Volume
(Discrete)
0 to 64 in steps of 1
Zone 1-2 Master Volume
(Step)
Up
Zone 1 Input 1-6 (Discrete)
0 to 64 in steps of 1
Zone 2 Input 1-6
On
Zone 2 Input 1-6 (Discrete)
0 to 64 in steps of 1
Down
Off
Page 2 of 4
Revision: 4/22/2013
IP Link® Device Interface
Communication Sheet
eclr_25_6478_1.pke
Status Available:
Connection Status
Connected
Disconnected
Executive Mode
On
Off
IR Remote
On
Off
Power Control
On
Off
Preset Recall
1 to 5
Preset Save
1 to 5
Zone 1-2 Audio Mute
On
Off
Zone 1 Input 1-6
On
Off
Zone 1-2 Master Volume
(Discrete)
0 to 64 in steps of 1
Zone 1 Input 1-6 (Discrete)
0 to 64 in steps of 1
Zone 2 Input 1-6
On
Zone 2 Input 1-6 (Discrete)
0 to 64 in steps of 1
Off
MLC60 Series Supported Commands:
Executive Mode
On
Off
IR Remote
On
Off
Power Control
On
Off
Preset Recall
1 to 5
Preset Save
1 to 5
Zone 1-2 Audio Mute
On
Off
Zone 1 Input 1-6
On
Off
Zone 1-2 Master Volume
(Step)
Up
Down
Zone 2 Input 1-6
On
Off
Page 3 of 4
Revision: 4/22/2013
eclr_25_6478_1.pke
IP Link® Device Interface
Communication Sheet
Revision: 4/22/2013
Cable and Adapter Requirements:
Contact manufacturer for pin diagram and cable and adapter requirements.
Notes for the Device:
Serial communication:
Port Type: RS-232
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Pin Assignments Diagram:
Please see cable and adapter requirements.
Note: Captive screw connector may also be used as a serial connection.
General Notes:
Page 4 of 4