Assembly Instructions
HILLSDALE
Page 1 of 8
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE
Item No. 110522; 110523; 110524; 110525
KIDS & TEEN
SAFETY WARNINGS
All of Hillsdale's Bunkbeds were
designed and manufactured with
your child's safety as our top
priority.
Their unparalleled strength is a
bi-product of the safety design.
Our bunks meet all compliance
with ASTM F 1427-07 "Standard
Consumer Safety Specification
for Bunk Beds " and Code of
Federal Regulations (CFR) 1213
"Safety Standards for Entrapment
Hazards in Bunk Beds " and
(CFR)1513"Requirements for
Bunks Bed".
Safety is a cooperative effort
between us as the manufacturer,
and you as a guardian. Please
read and consider the
warnings listed on this page
when choosing a mattress and
discussing rules of use with your
child.
1. Follow the information on the warnings appearing on the upper Bunk end structure and on the
carton. Do not remove warning label from bed.
2. Always use the recommended size mattress or mattress support, or both, to help prevent
entrapment or falls.
3. Surface of mattress must be at least 5 inches (127mm) below the upper edge of guardrails.
4. Do not allow children under 6 years of age to use the upper Bunk.
5. Prohibit more than one person on the upper Bunk.
6. Periodically, check and ensure that the guardrail, ladder, and other components are in their proper
position, free from damage, and that all connectors are tight.
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the ladder for entering and leaving the upper Bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
10. Use of a nightlight may provide added safety precaution for a child using the upper Bunk.
11. Always use guardrails on both long sides of the upper Bunk. If bunk bed will be placed next to the
wall, the guardrail that runs the full length of the bed should be placed against the wall to prevent
entrapment between the bed and wall.
12. The use of water or sleep flotation mattresses is prohibited.
13. Keep these instructions for future reference.
STRANGULATION HAZARD
Never attach or hang items to any part of the bunk bed that are not designed for use with the bed;
including, but not limited to, hooks, belts and jump ropes.
REPLACEMENT PARTS
Replacement parts, including
additional guardrails, may be
obtained from any of Hillsdales'
dealers.
SIZE OF MATTRESS AND FOUNDATION
Ensure thickness of mattress does not exceed 8 inches and the mattress is at
least 5 inches below upper edge of guardrails.
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
Page 2 of 8
Assembly Instructions
HILLSDALE
KIDS & TEEN
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE
Item No. 110522; 110523; 110524; 110525
Enclosed please find simple step-by-step
instructions to help you quickly assemble
your product. Before you begin, we recommend
that you follow the steps below.
1.Please read the instructions thoroughly
2.Identify all parts and hardware
3.Gather the tool(s) necessarily
4.2 adults required for assembly
To protect your parts during assembly, please
place them on a soft surface. To clean surface, use
only water on a damp cloth. Do not use window
cleaners or cleaning abrasives as it will scratch
the surface and could damage the protective
coating.
CUSTOMER SUPPORT
If you are missing parts or need assistance with
your product, please contact the retailer from
whom you purchased the product. When you
call or email, please include the Product's Item
Number and PO Number which is located on
the Production Tracking Sticker. This sticker can
be found on the bottom, inside or back of your
product.
Fully Assembled
LOFT BED WITH TABLE
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
HILLSDALE PARTS LIST
Page 3 of 8
HARDWARE FOR LOFT BED
KIDS & TEEN
X 21
PARTS IDENTIFICATION
Front Leg (LEFT)
X1
Short Guard Rail
X2
Back Leg (LEFT)
X1
Long Guard Rail
X2
Front Leg (RIGHT)
X1
Guard Rail Support
X1
Back Leg (RIGHT)
X1
Shont Rail
X1
Small Cross Rail
X7
Ladder Slat (LEFT)
X1
X2
Barrel Nuts
X 23
X2
X7
Other Tools Required
(Not Included)
.Phillips Screwdriver
.Flathead Screwdriver
X 18
X 10
X 26
Big Cross Rail
X2
Ladder Slat (RIGHT)
X1
FRONT Side Rail
X1
Fught of Stairs
X5
BACK Side Rail
X1
Table Top
X1
Under Back Rail
X1
Table Leg
X1
X6
X 37
Bracket
X2
Allen Wrench
X1
Table Cross Rail
X1
Slat
X 13
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
Page 4 of 8
HILLSDALE
KIDS & TEEN
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
Page 5 of 8
HILLSDALE
KIDS & TEEN
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
Page 6 of 8
HILLSDALE
KIDS & TEEN
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
Page 7 of 8
HILLSDALE
KIDS & TEEN
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com
LOFT BED IN A BOX TWIN WOOD LOFT BED WITH TABLE - Assembly Instructions
HILLSDALE
KIDS & TEEN
Page 8 of 8
WARNING
To help prevent serious or fatal injuries SCREW BOTH SIDES
OF EACH SLAT TO THE SLAT ROLL SUPPORT. Failure to
do so could result in the collapse of the entire slat roll, and will
void your warranty.
Hillsdale Furniture | 3901 Bishop Lane . Louisville, KY 40218 | www.hillsdalefurniture.com