pushchair user manual

By Baby Elegance
pushchair
user manual
Baby Elegance, Dublin, Ireland
www.babyelegance.com
Please read the following
instructions and warnings
carefully before use and
keep for future reference.
baby elegance
venti pushchair user manual
Venti pushchair
Handle
Adjustable
Button
Bumper Bar
Canopy
Handle
Safety Buckle
Seat Unit
Foot Rest
Rear Wheel
Swivel Lock
Basket
Front Wheel
Folding Pedal
Care and maintenance
• Always store in a clean and dry place.
• Clean the frame by wiping with a damp cloth.
• Do not use abrasives, bleach or strong detergents.
• Spot clean fabrics with warm water and mild soap.
• Ensure fabric is dry before storing.
• Occasionally clean and lubricate wheels and axles with a light lubricating oil.
• Regularly check for loose parts and tighten when required.
• Damaged or broken parts should be replaced.
baby elegance
venti pushchair user manual
To unfold and assemble
1
4
A
B
C
D
To open stroller frame
To assemble and disassemble seat unit
1) (A) When you fold the stroller, the folding latch will lock into position automatically.
4) To assemble: attach the elastics in two positions on both left and right sides of seat
unit poles. Then align seat pegs with the holes on frame, insert into until hear clicks.
To disassemble: press in both buttons and pull up seat unit.
(B) Release the folding latch by pulling out with one hand.
(C) Grip the handle and lift up to unfold the stroller with the other hand.
Note: Seat unit is reversible
2
To assemble and
disassemble front wheels
latch
5
2) To assemble: insert front wheel set
peg into the plastic base until hear
a “click”. To disassemble: press down
the latch on the plastic base and pull
the wheel set out.
3
assemble
To assemble and
disassemble real wheels
3) To assemble: align the cog hole with
axle, push into until hear a “Click”.
To disassemble: pull out the latch
on the plastic house and pull rear
wheel set out.
disassemble
To assemble the canopy
5) Align the holes on the canopy fixture on the handles. Press the fixture onto the
handles.
baby elegance
venti pushchair user manual
9
6
To assemble and disassemble bumper bar
6) To assemble: align the bumper bar pegs with holes in the front of seat unit
and insert into until hear clicks. To disassemble: press down both buttons on
bumper bar and pull out.
To open third section canopy
Instructions for use
7
9) Unzip the zipper in the middle of the canopy to release the third section of the
canopy. Once the zipper is fully unzipped, pull the canopy out to the open position.
To close the third section of the canopy, zip the zipper completely closed.
To use front swivel lock
7) Press down on swivel lock lever to
swivel; pull back the swivel lock lever
and fix it into the base notch, the
wheel can only move steadly.
8
10
To use braking system
8) Drop down the brake pedal to brake
rear wheel, lift up the brake pedal to
release brake
Reclining the stroller seat-backrest
10) To adjust the recline postion of the seat, simply life the lever found at the top
the seat back, and tilt the seat to the desired postion. Releasing the lever will allow
the seat to lock into one of there positions.
baby elegance
venti pushchair user manual
11
14
22
A
A
11
B
B
To adjust foot rest
To fold the stroller
11) Press down both round small buttons under the joint part to adjust footrest.
Important: When use the seat as converted pram, adjust the footrest down as
fig A & fig B, it can suit for taller child.
14) Unlock locking mechanism by sliding the foot-fold pedal to left side first and
stepping down, fig 1 & 2, then press down the handle to fold. The stroller can self
stand after folding.
12
To use restraint system
15
12) To unlock buckle, press in on center
button and pull harness out from each
side. To lock buckle, push each side
of harness back into buckle until each
clicks in place.
13
Handle height adjustment
To Insert car seat into stroller
13) Press the buttons to adjust the handle
with different height.
15) The car seat has tabs located below the handle which fit into the adaptors.
Stand behind the stroller with the head of the car seat towards you and lower
the tabs into the attachment slots. Push the car seat until it clicks into place.
Once in place tug firmly upwards on the car seat to check that it is secured.
baby elegance
16
venti pushchair user manual
To fit the footcover
17) Fit the footcover by placing it over
the stroller foot area, zipper the
footcover first, then attach the
straps and toggles on both sides
of the front bar.
NOTE: The fott cover is
designed for use in carry
cot mode.
THESE INSTRUCTIONS DETAIL THE SAFE USE,
OPERATION AND MAINTENANCE OF THE STROLLER.
PLEASE READ THESE INSTRUCTIONS
CAREFULLY AND ENSURE THAT THEY ARE
FOLLOWED AT ALL TIMES.
WARNINGS
•
Follow the manufacturer’s instructions at all times.
•
Put on all the brakes whenever you park the stroller.
•
Do not leave children unattended.
•
Do not carry extra children or bags on this stroller, unless in an
approved accessory.
•
Make sure children are clear of any moving parts if you adjust
the stroller, otherwise they may be injured.
•
Please ensure that the safety harness is adjusted and used at
all times.
•
Check that the stroller is fully erected and that all safety locks
are engaged before placing a child in the stroller.
•
Do not carry more than 4 kg in the basket or 1 kg in any pocket.
(If supplied)
•
The weight of the child using this stroller should not be more than
15 kg.
•
Do not allow children to stand on the seat or footrest.
•
Suitable age: 0-36months.
•
Do not use on stairs or escalators.
•
Do not use the stroller near an open fire, barbecue, or exposed
flame.
•
Do not run or jog with this stroller.
•
Engage front wheel swivel lock, to lock front wheel / wheels when
travelling on rough or uneven surfaces.
•
Do not attempt to lift the stroller by the bumper bar / tray, it may
disengage.
•
This product is not intended for commercial use.
Download PDF
Similar pages