Vertical Limit Switch Adjustment Located at Left Internal Mechanism

Vertical Limit Switch Adjustment Located at Left Internal
Mechanism – Type E
Notice: It will be located on the left hand as you are facing the screen (back side).
Up Vertical Adjustment
Down Vertical Adjustment
Your screen has been set to drop 6 of the 18 inches and to rise all the way up. However, in the
event that your screen does not, please use the instructions below to adjust the drop/rise to the
desired position.
Caution: Screen may be severely damaged if viewing surface is allowed to run too far
UP/DOWN. The motor may exhaust if constant adjustments are being done.
Note: You will require a 5/32” Allen-wrench to perform the adjustments below.
UP Vertical Position Adjustment: Only if the screen will not retract to its original position.
1. Insert the Allen-wrench into the top keyhole, turning the Allen-wrench clockwise in increments
will allow the screen to stop further out of the screen’s case. (Weight bar flushes with housing)
Note to self: You will not notice a difference in this adjustment until you press the DOWN button
then UP to see the adjustment calibration difference.
2. Turning the Allen-wrench half a circle counterclockwise in increments will cause the screen to
retract flushing with the screen’s case.
Down Vertical position adjustment:
1. Insert the Allen-wrench into the bottom keyhole, turning the Allen-wrench counterclockwise in
increments will cause the screen to expose more of the top black masking.
Note to self: You will not notice a difference in this adjustment until you press the DOWN button
then UP to see the adjustment calibration difference.
2. Turning the Allen-wrench a full circle clockwise will cause the screen to retract, limiting the
top black masking.
Elite Screens Inc.•16410 Manning Way •Cerritos, CA 90701
service@elitescreens.com / www.elitescreens.com Toll free # (877) 511- 1211 Ext. 202 / 234
Download PDF
Similar pages