Installation Instructions, Universal Horizontal Cable Manager

iis-730130, SHEET 1 OF 2 - INSTALLATION INSTRUCTIONS, UNIV HORIZONTAL CABLE MANAGER - 1:4 - 1-3-02 - ISS. 1 - CPI/B. KRIETZMAN
SHEET 1
2
1
CENTER OPENING ALLOWS CABLE TO
PASS THROUGH TO REAR OF RACK
2
1
INSTALLATION
1. REMOVE THE COVER BY HOLDING THE PANEL AT ONE END WITH ONE HAND AND
WITH THE OTHER HAND GRASP THE UPPER AND LOWER HINGES BETWEEN THUMB
AND FINGER AND PULL UNTIL HINGES RELEASE. REPEAT THIS FOR THE HINGES AT
THE OTHER END OF COVER.
NOTE: DO NOT REMOVE COVER BY PULLING ON COVER PANEL.
3
2. MOUNT PANEL TO RACK USING THE FOUR SLOTS INDICATED.
3. REPLACE COVER ON PANEL BY ALIGNING HINGES OVER GAPS BETWEEN
CABLE GUIDE FINGERS . PUSH ON ALL FOUR HINGES EVENLY UNTIL THE
HINGES SNAP INTO PLACE. DO NOT PUSH ON COVER PANEL.
3
3
3
INSTALLATION INSTRUCTIONS,
UNIV HORIZONTAL
CABLE MANAGER
THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO
CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE
OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT
AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
iis-730130, SHEET 1 OF 2 - INSTALLATION INSTRUCTIONS, UNIV HORIZONTAL CABLE MANAGER - 1:4 - 1-3-02 - ISS. 1 - CPI/B. KRIETZMAN
SHEET 2
2
COVER OPERATION
TO GAIN ACCESS TO THE CABLES WITHIN THE PANEL THE COVER
CAN BE HINGED OPEN, EITHER FROM THE TOP OR BOTTOM, OR IT
CAN BE COMPLETELY REMOVED.
2
HOLD HINGE BY
CONCAVE SURFACES 1
1. WITH YOUR RIGHT HAND GRASP THE RIGHT HINGES, ON THE
CONCAVE SURFACES, BETWEEN YOUR THUMB AND FINGER.
GRASP THE LEFT HINGES WITH YOUR LEFT HAND.
TO HINGE THE COVER OPEN:
2. PULL ON EITHER THE TOP OR BOTTOM HINGES, ALLOWING
THE COVER TO PIVOT ON THE OPPOSITE HINGES, UNTIL
THEY RELEASE.
TO REMOVE THE COVER:
3. PULL ON ALL THE HINGES EVENLY UNTIL THEY RELEASE.
Download PDF
Similar pages