EW-72 - Top Mobility

EW-72
Owner’s Manual
www.ewheelsdealers.com
0
(888) 305-0881 Service
(888) 571-2845
Table of Contents
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Before you operate your scooter…………………..…..
2
Scooter initial operation………………………….…...…..
2
Technical specification……………………………….……..
3
Mirror Assembly………………………………………………..
4
Safety Instruction……………………………………………… 6-7
Environment Condition………………………………………
7
Seat Adjustment………………………………………………..
8
Instrument Panel……………………………………………….
9
Storage Compartment……………………………………….
10
Key Fob…………………………………………….……………….
10
Batteries and Charger………………………………………… 11-12
EMC Statement………………………………………………….
12
1
Before you operate the scooter
Locate the below listed materials in rear basket:




Set of mirrors
Electric charger
Scooter Key
Owner’s manual
IT IS VERY IMPORTANT TO READ OWNER’S MANUAL BEFORE SCOOTER
OPERATION
Scooter Initial Operation









Read Owner’s manual
Buckle seat belt
Insert key into ignition (or activate scooter using key fob)
Set variable speed dial to lowest setting
Turn lights on
Adjust mirrors to desired positions
Place both hands on black hand grips
Twist the throttle slowly with your right hand
Enjoy the ride!
 Turn off scooter by simply turning key to the off position
2
Technical Specifications
Model
Weight Capacity
Speed:
Distance:
Front Seat: Type
Front seat: Size
Front Seat:
Rear Seat: Type
Rear Seat: Size
Steering Height
Rear Foot Rest:
Power:
Watts:
Motor Type:
Amps:
Volts:
Dimensions:
Floor Clearance:
Front Basket:
Batteries:
Forward/Reverse switch:
High/ Low Speed switch:
Front tire size:
Rear tire size:
Charger:
Throttle Type:
Key Start:
Braking System:
Drive System:
Headlight:
Rear lights:
Carton Size:
Scooter Weight:
Battery Indicator:
Front:
Rear:
Reflectors:
Warranty:
EW-72 Scooter
500Lbs.
Up to 15mph
43 miles per charge (distance varies on terrain, riders
weight, road surface, etc.)
Adjustable Folding Captains chair with backrest
18 ½ “ x 18 ½ “ x 30”
26 ½ “ from Ground
N/A
N/A
46” from Ground
N/A
Electric
700 Watt
Transaxle differential brushless
20 AH
48 Volts
56” x 27” x 52”
6”
N/A
(4) Sealed Lead Acid Maintenance Free
Yes
Adjustable Speed Knob / Rheo-Stat
14” tire type: 90/70-10 Tubeless
16” tire type: 3.0 – 10 Tubeless
48-volt Smart Charger included
Variable Speed Control – Twist Throttle
Yes
Front and Rear drum brakes
700 Watt Brushless Motor
12v LED Lights
12v Bulb
Shipped Fully assembled on Pallet – 63”x 36”x 54”
(LxWxH)
257lbs with batteries
Yes
Front Frame Suspension Bars
Rear Shock Absorbers
N/A
Limited – 3 Year Warranty
3
Mirror Assembly
Your power scooter is shipped partially disassembled for protection during
shipping. After unpacking, please check whether you have received the
following main components as our standard specification (See Fig 1)
1. Mirrors
Mirror Post
Fig 1
To attach the mirrors simply place each mirror threaded end into the mirror
post. Turn mirror clockwise and fasten mirror to scooter.
4
Operation of Scooter:
1. To prevent injury to yourself or others, always ensure that the power
is switched off when getting on or off the scooter, and that the
emergency brake tabs are set.
2. Always check that the variable speed control is set to the desired
speed setting.
Variable Speed Dial
3. Always check you have selected the correct forward or reverse button
when about to drive.
Forward/Reverse switch
4. Always reduce your speed when making sharp turns.
5. Do not switch off the power when the scooter is still moving forward
5
Ramps and Curbs
1. Check that ramp surface is toughened to prevent slipping. Never drive
across a slope of turn sharply on a slope.
2. When driving up curbs, always check the height of the curb to ensure
that it does not exceed 4” height.
General
1. Always use a seatbelt, and keep your feet on the scooter all the time.
2. Do not over load the scooter with its maximum weight capacity of
500lbs including accessories and carry ons.
3. Do not attempt to lift or move a power scooter by any of its
removable parts. Personal injury and damage to the power chair may
result.
4. Never try to use your scooter beyond its limitations as described in the
manual.
5. Do not operate your vehicle if it is not functioning properly.
6. Do not connect any electrical or mechanical device to the scooter.
Failure to obey this instruction may result in injury and will void
the warranty.
6
Use While Under the Influence of Medication or Alcohol
1. Check with your physician if you are taking any medication that may
affect your ability to operate your powered scooter safely.
2. Do not operate your scooter while you are under the influence of
alcohol as this may impair your ability to operate your power scooter
in a safe manner.
Environment Condition
Rain, Sleet and Snow
If exposed to water, your power scooter is susceptible to damage to
electronic or mechanical components. Water can cause electronic
malfunction or promote premature corrosion of electrical components and
frame.
Warranty
For valid warranty claims E-Wheels will, at their discretion,
replace/repair/refund items mutually agreed to be defective.
E-Wheels warranty as following:
1.
2.
3.
4.
5.
Frame: (2) Year limited warranty
Electronic component: (1) Year limited warranty
Controllers: (3) Year limited warranty
Batteries: Not warranted
Consumables: Wheel, tires, arm pads and seat cushions: Not
warranted
7
6. Labor costs are NOT covered by warranty
Any damage or defect of any nature occurring from the misuse of the
product is not to be covered. The warranty is to start from the date of
arrival of our products.
Seat Adjustment
1. Locate forward/reverse seat handle located under the seat
Forward/Reverse Handle
2. Locate the reclining seat lever located on side of seat.
Tilt Lever
Seat arm rest can be in an upright position or a down position.
8
Instrument Panel
Speedometer and Battery level indicator
Speedometer
Battery Indicator
Speed Control
Lights on/off
Horn
Key Ignition
High/Low Beam
Turn Signal
Horn
9
Trunk Key Insert
Insert Key into lock mechanism (as shown above) and turn while lifting so
seat will lift and tilt forward to gain access to storage compartment and
circuit breaker.
Key Fob
Press once to activate alarm
Press once to disarm alarm
Panic alarm button
Press twice to power scooter
Without putting key in ignition
10
Batteries and Charger
We recommend that you use deep-cycle batteries that are sealed and
maintenance free for your power scooter. Both are lead acid (SLA) and gel
cell are Deep cycle batteries that are similar in performance. Deep-cycle
batteries are specifically designed to provide power, drain down, and then
accept a relatively quick charge. Lead acid batteries should be charged as
often as possible.
Specification of the battery that we recommend:
Type:Deep Cycle Sealed lead acid or gel ell
Size:
20 AH
Voltage: 12 V Each (4) totals
Depending on the use, terrain and driving conditions, the batteries will
provide a range of 43 miles of travel. However, even if the power scooter is
not in use we recommend that the batteries be charged at least a month.
Note:
- Do not use any automotive batteries, they are not designed to handle
a long, deep discharge and are unsafe for use in power scooter.
- The useful life of a battery is quite often a reflection of the care it
receives.
- Always charge your batteries in well ventilated areas.
- The charger is intended for indoor use only.
- For maximum performance, it is recommended that you replace all
four batteries at the same time if the batteries are weak.
- If the vehicle will not be used for a long period of time. Arrange to
have batteries recharged at least once every month to avoid
deterioration.
Recharge Battery only when the key is in off position/ when indicator is
showing low status. This confirms batteries need to be recharged.
11
Charger Use
1. Plug charger into electric wall outlet.
2. Insert charger plug into the scooter’s charging port which is located
directly in front of the scooter’s main body directly under the seat.
3. Red charger light indicates scooter is charging
4. Green charger light indicates the scooter is fully charged.
EMC Statements
This portion of the content will provide the user with basic information that
describes the problems with EMI, known sources of EMI, protective
measures either to lessen the possibility or exposure or to minimize the
degree of exposure, and suggested action should unexpected or erratic
movement occur.
Caution: It is very important that you read this information regarding the
possible effects of electromagnetic interference on your electric P17RT
WHEELCHAIR.
■ ELECTROMAGNETIC INTERFERENCE (EMI) FROM RADIO WAVE
SOURCES Powered vehicle may be susceptible to electromagnetic
interference (EMI), which is interfering electromagnetic energy (EM)
emitted from sources such as radio stations, TV stations, amateur radio
(HAM) transmitters, two-way radios, and cellular phones. The interference
(from radio wave sources) can cause the powered vehicle to release its
brakes, move by itself, or move in unintended directions. It can also
permanently damage the powered vehicle’s control system. The intensity of
the interfering EM energy can be measured in volts per meter (V/m). Each
powered vehicle can resist EMI up to certain intensity. This is called its
“immunity level”. The higher the immunity level the greater the protection.
At this time, current technology is capable of achieving at least a 20 V/m
immunity level, which would provide useful protection from the more
common sources of radiated EMI.
12
This powered vehicle model as shipped, with no further modification, has
an immunity level of 20 V/m without any accessories.
There are a number of sources of relatively intense electromagnetic fields in
the everyday environment. Some of these sources are obvious and easy to
avoid. Others are not apparent and exposure is unavoidable. However, we
believe that by following the warning listed below, your risk to EMI will be
minimized.
The sources of radiated EMI can be broadly classified into three types:
1. Hand-held portable transceivers (transmitter-receivers with the antenna
mounted directly on the transmitting unit.
Examples include: citizens band (CB) radios, “walkie talkie”, security, fire,
and police transceivers, cellular telephones and other personal
communication devices.
Note: some cellular telephones and similar transmit signal while they are
ON, even when not being used; 24 Medium-range mobile transceivers, such
as those used in police cars, fire trucks, ambulances and taxis. These usually
have the antenna mounted on the outside of the vehicle; and
3. Long-range transmitters and transceivers, such as commercial broadcast
Transmitter (radio and TV broadcast antenna towers) and amateur (HAM)
radios.
Note: Other types of hand-held devices, such as cordless phones, laptop
Computers, AM/FM radios, TV sets, CD player, and cassette players, and
small appliances, such as electric shavers and hair dryers, so far as we know,
are not
Likely to cause EMI problems to your powered vehicle.
13
■ POWERED VEHICLE ELECTROMAGNETIC INTERFERENCE (EMI)
Because EM energy rapidly becomes more intense as one move closer to
the transmitting antenna (source), the EM fields from hand-held radio wave
sources (transceivers) are of special concern. It is possible to unintentionally
bring high levels of EM energy very closer to the powered vehicle’s vehicle
movement and braking. Therefore, the warnings listed below are
recommended to prevent possible interference with the control system of
the powered vehicle control system while using these devices. This can
affect powered
■ WARNINGS
Electromagnetic interference (EMI) from sources such as radio and TV
stations, amateur radio (HAM) transmitters, two-way radios, and cellular
phones can affect powered vehicles and motorized wheelchair. Following
the warnings listed below should reduce the 39 40 chance of unintended
brake release or powered vehicle movement, which could
Result in serious injury.
1. Do not operate hand-held transceivers-receivers), such as citizens
band (CB) radios, or turn ON personal communication devices, such as
cellular phones, while the powered vehicle is turned ON;
2. Be aware of nearby transmitters, such as radio or TV stations, and try
to avoid coming close to them;
3. If unintended movement or brake release occurs, turn the powered
vehicle OFF as soon as it is safe;
4. Be aware that adding accessories or components, or modifying the
powered vehicle, may make it more susceptible to EMI ( Note: There is
no easy way to evaluated their effect on the overall immunity of the
powered vehicle); and 25
5. Report all incidents of unintended movement or brake release to the
powered vehicle manufacturer, and note whether there is a source of
EMI nearby,
14
■
IMPORTANT INFORMATION
1. 20 Volts per meter ( V/m) is a generally achievable and useful
immunity level against EMI ( the higher the level, the greater the
protection);
2. This product has an immunity level of 20 V/m without any accessories
and connected to it.
15
Download PDF
Similar pages