Info sheet: NBS Javelin J230i Thermo Card Printer

INFO SHEET
NBS Javelin 230i Thermo Card Printer
Inserting the cleaning roll
•Clip the blue cleaning roll into the fixture as shown.
Inserting the colour roll
•Please note that an incorrectly locked printing cover causes problems
when printing. The cover closes incorrectly if the colour band is
incorrectly inserted.
Inserting identity cards
Errors
If there is an error, you must check the following points
1.
2.
3.
4.
5.
6.
Open the printer cover.
Is the colour band inserted correctly?
Close the printer cover.
Press EJECT to eject any cards that may be in the printer.
Press RIBBON SET.
Empty the printer queue.
Cleaning the NBS Javelin J230i card printer
Cleaning during every colour band change (small cleaning)
1.
2.
3.
4.
Switch the printer off and remove the cards and the colour band. Close the printer cover.
Switch the printer on. As soon as “Initialising” appears on the LCD display, please press the EJECT button for 20
seconds until the LCD display shows “Cleaning...”.
Insert the small cleaning card into the card entrance. Once the card is pulled in, the cleaning will start.
The cleaning card is routed through the printer and cleans it until the card is output.
Cleaning on every second or third colour band change (big cleaning)
1. Insert the long, T-shaped cleaning card in the card entrance (with the small side in front).
2. Press the EJECT button again. The T-shaped cleaning card is inserted and the printer begins the roller
cleaning.
3. If the cleaning card is output, “Ready” will appear on the LCD display and the cleaning is finished.
4. Please wait two to three minutes until the cleaning fluid has completely volatilised, then re-insert the
colour band and the cards.
Cleaning the blue cleaning roll during every colour band change
1. Remove the blue cleaning roll from the printer.
2. Clean the blue cleaning roll under running water.
3. After drying the cleaning roll, re-insert it into the printer.
Cleaning the thermal print head on every second or third colour band change
1. Switch the printer off.
2. Hold the cleaning rod in such a way that the pad is facing down and squeeze the cleaning rod in such a way that
the bad is saturated with the cleaning fluid.
3. Clean the print head by wiping over the print head. Only wipe between the green lines. Do not touch the print
head with your fingers.
4. Please wait two to three minutes until the cleaning fluid has completely volatilised, then re-insert the colour band.
IDENTA AUSWEISSYSTEME GMBH
Postbox 3040
78054 VS-Schwenningen,
Germany
IDENTA AG
Postbox 1065
8610 Uster 1,
Switzerland
www.identa.com
Please contact our customer service centre if you have any technical questions. Our call-back service times are: Monday through Friday, 9:00 am to 12:00 pm and
1:00 pm to 4:00 pm. You can reach the hotline at Phone +41 (0) 44 940 95 20 (in Switzerland) and at Phone +49 (0) 7720 3909-28 (in Germany).
Download PDF
Similar pages