Cisco PDS3121 Set-Top Safety Sheet (English)

IMPORTANT SAFETY INSTRUCTIONS
Notice to Installers
The servicing instructions in this notice are for use by qualified
service personnel only. To reduce the risk of electric shock, do not
perform any servicing other than that contained in the operating
instructions, unless you are qualified to do so.
Note to System Installer
For this apparatus, the coaxial cable shield/screen
shall be grounded as close as practical to the point of
entry of the cable into the building.For products sold in
the US and Canada, this reminder is provided to call the
system installer's attention to Article 820-93 and Article
820-100 of the NEC (or Canadian Electrical Code Part
1), which provides guidelines for proper grounding of
the coaxial cable shield.
This symbol is intended to alert you that uninsulated
v o l t a g e w i t h i n t h i s p r o d u c t m a y h a v e s u ff i c i e n t
magnitude to cause electric shock.Therefore, it is
dangerous to make any kind of contact with any inside
part of this product.
Ce symbole a pour but d’alerter toute personne qu’un
contact avec une pièce interne de ce produit, sous
tension et non isolée, pourrait être suffisant pour
provoquer un choc électrique. Il est donc dangereux
d’être en contact avec toute pièce interne de ce produit.
WARNING: Avoid electric shock and fire hazard!
Do not locate an outside antenna system in the vicinity of
overhead power lines or power circuits. Touching power
lines or circuits might be fatal.
This product may contain a tuner capable of receiving off-the-air
broadcasts.
Protect the Product from Lightning
CAUTION: To reduce the risk of electric shock, do not remove
cover (or back). No user-serviceable parts inside. Refer servicing
to qualified service personnel.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert you of the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying this product.
Ce symbole a pour but de vous avertir qu’une documentation
importante sur le fonctionnement et l’entretien accompagne ce
produit.
In addition to disconnecting the AC power from the wall outlet,
disconnect the signal inputs.
Verify the Power Source from the On/Off Power Light
When the on/off power light is not illuminated, the apparatus may
still be connected to the power source. The light may go out when
the apparatus is turned off, regardless of whether it is still plugged
into an AC power source.
Eliminate AC Power/Mains Overloads
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12)
Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination
to avoid injury from tip-over.
WARNING: Avoid electric shock and fire hazard! Do
not overload AC power/mains, outlets, extension cords,
or integral convenience receptacles. For products that
require battery power or other power sources to operate
them, refer to the operating instructions for those products.
Handling Disposable Batteries
This product may contain disposable batteries. Heed the
following warning and follow the Battery Safety and Battery
Disposal instructions below.
WARNING: There is danger of explosion if the battery
is mishandled or incorrectly replaced. Replace only with
the same type of battery. Do not disassemble it or attempt
to recharge it outside the system. Do not crush, puncture,
dispose of in fire, short the external contacts, or expose to
water or other liquids. Dispose of the battery in accordance
with local regulations and instructions from your service
provider.
Battery Safety
• Insert batteries correctly. There may be a risk of explosion if the
batteries are incorrectly inserted.
• Do not attempt to recharge ‘disposable’ or ‘non-reusable’
batteries.
• Please follow instructions provided for charging ‘rechargeable’
batteries.
• Replace batteries with the same or equivalent type that we
recommend.
13) Unplug this apparatus during lightning storms or when
unused for long periods of time.
• Do not expose batteries to excessive heat (such as sunlight or
fire).
14) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as a power-supply cord
or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
• Do not expose batteries to temperatures above 100°C (212°F).
Battery Disposal
• The batteries may contain substances that could be harmful to
the environment.
• Recycle or dispose of batteries in accordance with the battery
manufacturer’s instructions and local/national disposal and
recycling regulations.
Power Source Warning
A label on this product indicates the correct power source for this
product. Operate this product only from an electrical outlet with
the voltage and frequency indicated on the product label. If you are
uncertain of the type of power supply to your home or business,
consult your service provider or your local power company.
The AC inlet on the unit must remain accessible and operable at
all times.
Ground the Product
• The batteries may contain perchlorate, a known hazardous
substance, so special handling and disposal of this product might
be necessary. For more information about perchlorate and best
management practices for perchlorate-containing substance,
see www.dtsc.ca.gov/hazardouswaste/perchlorate
Provide Ventilation and Select a Location
• Remove all packaging material before applying power to the product.
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
WARNING: Avoid electric shock and fire hazard! If this
product connects to coaxial cable wiring, be sure the cable
system is grounded (earthed). Grounding provides some
protection against voltage surges and built-up static charges.
• Do not place this apparatus on an unstable surface.
• Do not install this apparatus in an enclosure, such as a bookcase
or rack, unless the installation provides proper ventilation.
• Do not block ventilation openings.
Connecting to an SDTV with RCA Cable
Back of Set-Top
CVBS
Operating Environment
This product is designed for operation indoors with a temperature
range from 32° to 104° F (0° to 40°C). Each product should
have adequate spacing on all sides so that the cooling air vents on
the chassis are not blocked.
Protect from Exposure to Moisture and Foreign
Objects
L
R
Manufactured under license from
Dolby Laboratories. Dolby and the
double-D symbol are trademarks of
Dolby Laboratories.
CABLE IN
ETHERNET
Y
PB
PR
S/PDIF
HDMI
USB
IR
To
Wall
Jack
Cable
Input
Back of
SDTV
Y
RF IN
T15855
• Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
SCART VIDEO IN
PB
WARNING: Avoid electric shock and fire hazard! Do
not expose this product to dripping or splashing liquids,
rain, or moisture. Objects filled with liquids, such as vases,
should not be placed on this apparatus.
L
R
L
R
RF OUT
PR
VIDEO
IN
AUDIO
IN
VIDEO
OUT
AUDIO
OUT
Connecting to an HDTV with HDMI Cable
Back of Set-Top
WARNING: Avoid electric shock and fire hazard!
Unplug this product before cleaning. Do not use a liquid
cleaner or an aerosol cleaner. Do not use a magnetic/static
cleaning device (dust remover) to clean this product.
WARNING: Avoid electric shock and fire hazard!
Never push objects through the openings in this product.
Foreign objects can cause electrical shorts that can result
in electric shock or fire.
CVBS
L
R
Manufactured under license from
Dolby Laboratories. Dolby and the
double-D symbol are trademarks of
Dolby Laboratories.
CABLE IN
ETHERNET
Y
PB
PR
S/PDIF
HDMI
USB
IR
To
Wall
Jack
Cable Input
Back of
HDTV
AUDIO
CENTER
CHANNEL IN
HDMI
IN
SCART VIDEO IN
Service Warnings
ON
R
ANT (75 )
VIDEO
Y
VIDEO
L/
MONO
AUDIO
Check Product Safety
L
PB
L
PR
AUDIO
L/
MONO
R
Y
ANT-1
PB
L
PR
AUDIO
OUT
R
R
Upon completion of any service or repairs to this product, the
service technician must perform safety checks to determine that
this product is in proper operating condition.
R
HD 1
IN
HD 2
IN
OUT
ANT-2
IN
T15856
WARNING: Avoid electric shock! Do not open the
cover of this product. Opening or removing the cover may
expose you to dangerous voltages. If you open the cover,
your warranty will be void. This product contains no userserviceable parts.
OFF
AUDIO IN
DVI/HDCP
SCART VIDEO OUT
S-VIDEO
Protect the Product When Moving It
Open Source License Statement
Always disconnect the power source when moving the apparatus
or connecting or disconnecting cables.
20110316_Cable_Safety
Cisco PDS3121 set-top(s) may contain, in part, certain free and/
or open source software (“Open Source”) under separate license
terms. Examples of such licenses may include all versions of the
GNU General Public License (GPL), GNU Lesser General Public
License (LGPL), BSD license, MIT license, Mozilla Public License,
Eclipse Public License, Apache license, and others. To find
specific information regarding the Open Source in your product,
including copies of the applicable license documentation and
related information, go to: (i) for North America http://www.cisco.
com/web/consumer/support/open_source.html, or (ii) for outside
North America http://www.cisco.com/web/consumer/support/
open_source.html#international. Once at the site, search for the
product listing and click the related items identified. If you have any
questions or problems accessing any of the links, contact: spvtgexternal-opensource-requests@cisco.com.
Cisco PDS3121 Series HD Interactive Set-Top
Model: PDS3121
Manufactured by:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134 USA
www.cisco.com/go/contacts
Notice to Consumers
The Cisco® PDS3121 Set-Top receives digital signals from your
service provider and delivers programs in standard definition (SD)
and high definition (HD) formats (720p and 1080i).
You must have an HDTV to display HD programming. Programming
must originate in HD format and be broadcast in HD format.
Please read the safety instructions before connecting your set-top.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco’s
trademarks, go to this URL: www.cisco.com/go/trademarks.Third-party trademarks mentioned are the property of their respective owners. The use of the word
partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing
LLC in the United States and other countries.
© 2014 Cisco and/or its affiliates. All rights reserved.
Printed in Mexico
Last Updated: July 2014
Part Number 78-100448-01A0
Download PDF
Similar pages