61-63, 64-66 CHEVY TRUCK PACKAGE
BRACKET INSTALLATION SHEET
CONTENTS:
6 GAUGE KIT SPEEDO, TACH, FUEL (0-30) TEMP, PRES, VOLTS
PRESSURE SENDER
TEMP SENDER
BUSHING KIT
REMOTE BUTTON
SPEEDO HARNESS
BRACKET CONTENTS:
Use #6x 5/8: self tapping screws for
MAIN BRACKET ASSENBLY
clamp brackets
8x 6-3/8” SELF TAPPING SCREWS
All warning lamps/turn signals are 12V
INSTALLATION:
Remove original panel and gauges
Install new gauges in panel in any position
Install on back of original panel as shown
using fasteners included in kit
Turn signals/warning lamps are 12V LEDs,
wire as needed. Red is 12V+ black is
ground. Each LED is labelled by engraving
on the back of the assembly
Place gauges assembly in panel, adjust
gauge positions/rotation as needed.
Install hold down clamps using #6x5/8” self
tapping screws.
Fuel gauge in kit is a 0-30 factory match,
GM used this sender from 1930-1966
Wire gauges according to instruction booklet
Download PDF
Similar pages