bellevue bridge kitchen faucet installation

BELLEVUE BRIDGE KITCHEN FAUCET INSTALLATION
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
faucet, plumbing, sink, counter top, or for personal injury
during installation.
TOOLS AND MATERIALS:
Plumbers
Tape
Thread
Sealant
Adjustable
Wrench
Observe all local plumbing and building codes.
Unpack and inspect the faucet for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
Basin
Wrench
Small
Bucket
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the old
faucet has been completely removed and any
necessary repairs or modifications to the water
supply have been completed.
Bellevue Bridge Kitchen Faucet Installation Instructions
1
BELLEVUE BRIDGE KITCHEN FAUCET INSTALLATION
Installation
1. Ensure that the water supply below your sink is
completely shut off by turning the shutoff valves all the
way to the right.
3. Slide the decorative escutcheon onto the center
post, as shown. Insert the faucet into its designated
mounting holes on the mounting surface.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
OFF
2. Attach the provided threaded shanks into each
handle base, with the tapered side of the threads
facing up. Apply thread sealant or plumber’s tape to
the threads before attaching. Tighten firmly using an
adjustable wrench.
4. From beneath the counter, slide the provided metal
washers onto each of the threaded shanks. The
beveled side of the washer should face up, as shown.
Secure the faucet to the counter by threading the
provided lock nuts onto each threaded shank. Hand
tighten, then finish tightening using a basin wrench.
Bellevue Bridge Kitchen Faucet Installation Instructions
2
BELLEVUE BRIDGE KITCHEN FAUCET INSTALLATION
5. Remove the plastic lock nut from the hand sprayer
cradle. Insert the cradle into its designating mounting
hole, and tighten the lock nut from underneath to
secure.
7. From beneath the counter, attach the hand sprayer
hose by threading it onto the center post. Apply a bit of
thread sealant or plumber’s tape to the threads before
tightening. Use an adjustable wrench to tighten firmly.
6. Insert the provided rubber O-ring into the end of
the hand sprayer hose, and attach it to the hand
sprayer assembly. Hand tighten firmly. Insert the hose
and hand sprayer into its cradle from above the
counter.
8. Attach the main water lines to the threaded shanks
on the faucet. Ensure that the hot and cold lines are
being connected appropriately. Apply plumber’s tape or
thread sealant to the threads before tightening. Hand
tighten the connections, then finish tightening with a ¼
turn using an adjustable wrench.
Tip: If needed, use the provided lock nuts and rubber
cone washers to make the connections.
Bellevue Bridge Kitchen Faucet Installation Instructions
3
BELLEVUE BRIDGE KITCHEN FAUCET INSTALLATION
9. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
10. Remove the aerator from the spout and turn the
faucet on. Ensure that both hot and cold water are
running properly, and check for any leaks. Allow the
water to flow for approximately 60 seconds to remove
any dust or sediment within the water lines. Reattach
the aerator and turn on the sprayer. Allow the sprayer to
run for another 60 seconds, and check for any leaks.
ON
60 sec
Bellevue Bridge Kitchen Faucet Installation Instructions
4
Download PDF
Similar pages