Wired Internal Colour Dome Camera CCTV Kit

Wired Internal Colour Dome
Camera CCTV Kit
CA8
Installation and Operating Instructions
These instructions should be retained in a safe place for future reference.
INTRODUCTION
Section 1
The Response Wired Internal Dome Camera is a colour, day camera. The camera easily
connects to your TV / VCR / DVR for the protection of your home or office, etc.
Please read before you start:
Always use discretion when installing CCTV surveillance equipment especially
when there is perceived policy. Enquire regarding local regulations applicable
to the lawful installation of video recording / surveillance. Third party consent
may be required.
SAFETY AND INSTALLATION TIPS:
Do not attempt to open or expose the camera unit with the power adaptor plug connected
to avoid any risk of personal injury.
When installing CCTV camera(s), always follow manufacturer’s advice when using power
tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety goggles) when
drilling holes. Before drilling holes through a ceiling check for hidden electricity cables and
water pipes. The use of a cable/pipe detector is advisable.
When installing any cameras with this unit, it is advisable to use cable conduit to protect any
video / power extension cables from being exposed and to prevent/reduce the chances of the
cables being tampered with.
To prevent a fire or electrical shock hazard, do not attempt to open the housing of the unit
while it is exposed to rain, water or wet conditions. The dome camera should only be
installed in dry internal conditions as it is not weatherproof. There are no user serviceable
parts inside. Refer servicing to qualified service personnel.
2
KIT CONTENTS
Section 2
1 x Wired Internal Dome Colour Camera
1 x 10m BNC (male plug) to BNC (male plug) extension cable
1 x BNC (female) to RCA (male) adaptor
1 x 12V DC power supply adaptor
1 x Camera fixings kit - ceiling plugs and screws
For the dome cameras mounting base - 2 x Ø 3.5mm x 19mm screws
and 2 x No.7, 29mm ceiling plugs
1 x Installation and operating manual
1 x Window sticker
Tools Required:
Electric drill
5mm masonry drill bit
20mm masonry drill bit
No. 2 Philips screwdriver
3mm flat blade screwdriver
3
INSTALLATION
Section 3
Note: The Response Dome Camera is only suitable for internal use and should not be
installed outside. It is also recommended to install the extension cables for the dome
camera in the ceiling and passed down the wall through a cable conduit.
1.
Unscrew the rim part of the dome cover
from its base as shown below. Once the
cover is removed, take care not to touch
any of the exposed electronic circuitry to
avoid any possible damage to the
camera (Fig. 1).
2.
Use the base of the camera to mark out
the key hole mounting holes and the
Fig. 1.
cable connector’s hole on the ceiling.
Mounting Holes
Cable connectors
entry hole position
in ceiling
Fig. 2.
3
Drill 2 x 5mm holes for the mounting bracket’s ceiling plugs and 1 x 20mm hole for
the camera’s video and power plugs to pass through the ceiling.
4.
Once the cable hole and mounting holes have been made in the ceiling, feed the
connectors of the extension cables through the ceiling, the largest one first. The
camera is supplied fitted with a short piece of cable terminated with a video BNC
female plug and a female power plug. Connect the male end of the video BNC
plug and male power plug from the extension cable into the camera end. Push the
cables into the ceiling before mounting the base.
4
5.
Mount the base to the ceiling using the supplied fixing screws and plugs. Adjust
the tilt and panning positions of the camera lens as shown (Fig. 3).
Loosen Screw to Adjust
Panning Position
Adjust Tilt
Fig. 3.
6.
Refit the cover of the camera on to its base.
7.
If required, fit the BNC to RCA adaptor into the other end of the extension cable to
allow you to plug directly into the video input of your TV/VCR. Connect the 12VDC
power supply plug into the extension cable also.
Note: If you are using this camera with a CCTV 4 channel DVR where the video
input channels use BNC female connectors, then simply plug the other end of the
extension cable in without using the supplied adaptor.
8.
Tune your TV/VCR/DVR to auxiliary (AUX), A/V or video mode to view the camera.
(Note: Refer to your TV/VCR/DVR’s owner’s manual for setting this up).
9.
If the position of the camera needs further adjusting after the system is powered
up, ensure the power is isolated from the cameras when removing the cover again
to prevent the risk of any shock.
5
Connection Summary
Extension Cable
Ceiling
TV / MONITOR
DOME CAMERA
Wall
VCR / DVR
Video Signal
to Input
12VDC Power
Supply Adaptor
Note: If the supplied extension cable is not long enough, the extension cable for this
camera can only be extended up to 30m in total length due to power loss.
6
TROUBLE SHOOTING
Section 4
PROBLEM
SOLUTION
No picture can be viewed
The power supply adaptor is not plugged in.
The TV / VCR / DVR is not tuned to view the
correct channel.
Poor picture quality
Clean the camera lens.
Adjust the contrast/brightness on the TV.
7
TECHNICAL SPECIFICATION
Section 5
ITEM
DOME CAMERA
Image sensor
1/4” Sharp CCD
Video format
PAL / NTSC
Pixel resolution
PAL:
NTSC:
Horizontal resolution
420 TV lines
Viewing angle
72°
Lens size
3.6mm
Night vision range
N/A
IP rating
IP40 - Internal use only
Operating temperature
- 10°C to 50°C
Power supply
12 V DC / 300mA
Cable type connections
Fitted with 1m cable terminated with female BNC
(video) and female jack (power) plugs
Dimensions (diameter x height)
100 x 65mm
Weight
800g (with bracket fitted)
8
512 (H) x 582 (V)
510 (H) x 492 (V)
ACCESSORIES IN THE RANGE
Section 6
There are a range of accessories available in the Response CCTV product range to expand
your system:
CWK1
Wired Colour Camera CCTV Kit
CA1
2 Channel Digital Video Image Recorder
CA2
LCD Screen for Wireless / Wired CCTV Kits
CWFK1
Wireless Colour Camera CCTV Kit
CA3
Wireless Colour Accessory Camera
(requires CWFK1 CCTV KIT to operate)
CA5
Professional Heavy Duty Camera CCTV Kit
CA6
Dummy Professional Heavy Duty Camera
CA7
4 Channel Digital Video Image Recorder
CA9
Dummy Internal Dome Camera
CA10
Heavy Duty Colour Camera CCTV Kit
CA11
Dummy Heavy Duty Camera
CA4
10m Extension Cable Kit
CA12
20m Extension Cable Kit
Note: The maximum extension cable length for any wired camera with this system is 30m
without reducing the picture quality of the video.
9
DISPOSAL – RECYCLING INSTRUCTIONS
Directive (2002/96/EC)
This product is classified by the Waste Electrical or Electronic
Equipment (WEEE) Directive. It should not be disposed of with other
household or commercial waste.
At the end of its useful life the
packaging and product should be disposed of via a suitable recycling
centre.
For information on available facilities, please contact your
local authority or the retailer from where the product was purchased.
10
Section 7
GUARANTEE
Section 8
Novar ED&S undertakes to replace or repair at its discretion goods (excluding non
rechargeable batteries) should they become defective within 1 year solely as a result of
faulty materials and workmanship.
If the product has not been installed, operated or maintained in accordance with the
instructions, has not been used appropriately or if any attempt has been made to rectify,
dismantle or alter the product in any way the guarantee will be invalidated.
The guarantee states Novar ED&S entire liability. It does not extend to cover consequential
loss or damage or installation costs arising from the defective product. This guarantee does
not in any way affect the statutory or other rights of a consumer and applies to products
installed within UK and Eire only.
If an item develops a fault, the product must be returned to the point of sale with:
1. Proof of purchase.
2. A full description of the fault.
3. All relevant batteries (disconnected).
Response is a trademark of Novar ED&S.
CUSTOMER HELPLINE
Most issues can be solved over the phone in a few minutes.
Please contact our Helpline Team on the number below for any
installation and general advice regarding our products:
0844 736 9149
Lines open 9.00am to 5.00pm, Monday to Friday.
Calls charged at service providers national rate.
11
Novar Electrical Devices and Systems Limited. (A Honeywell Company)
The Arnold Centre, Paycocke Road, Basildon, Essex SS14 3EA. UK
www.friedland.co.uk
© Novar Electrical Devices and Systems Limited. 2009
50043913 Rev.B
Download PDF
Similar pages