Installation and Troubleshooting Guide
All rights reserved. Reproduction or use of content, in any manner, without express written permission by CDI Electronics, Inc., is prohibited.
CDI P/N 413-9915
This unit will replace P/N’s: 582061, and 583005
WARNING! This product is designed to be installed by a professional marine mechanic. CDI Electronics cannot
be held liable for injury or damage resulting from improper installation, abuse, neglect or misuse of this product.
Installation
1.
2.
3.
4.
5.
6.
Disconnect battery.
Remove original wiring harness. Be sure to make note of wire routing.
With old wiring harness removed clean all connection points to verify good connection of new wiring harness.
Install new wiring harness in the same position as original wiring harness.
Verify proper placement of all wires. Reconnect battery.
Wire color chart.
A) Red/Purple- Power side of starter solenoid
B) Red- Splits off of Red/Purple, goes to terminal block then to rectifier
C) Yellow/Red- Switched power to starter solenoid
D) Black- Ground wire
E) Gray- Tach wire from rectifier
F) Black/Yellow- Plugs into Power Pack connector
G) Violet/White- Choke solenoid
H) Tan- Temperature sensor
Starter
Black
Temp Sender
Starter Solenoid
Tan
Yellow/Red
Violet/White
Red/Pur
Fuse
Red
Red
Black/Yellow
Power Pack Connector
Gray - Tach
Terminal Block
CDI Electronics • 353 James Record Road SW • Huntsville, AL 35824
Web Support: www.cdielectronics.com • Tech Support: 1-866-423-4832 • Order Parts: 1-800-467-3371
All rights reserved. Reproduction or use of content, in any manner, without express written permission by CDI Electronics, Inc., is prohibited.
Rev B • 7/23/13
Page - 1 of 1
QF-319
Download PDF
Similar pages