Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
User manual
AJ3400/05
Contents
1Important
3
2 Your clock radio
4
4
3 Get started
4
4
5
5
4 Listen to FM radio
6
6
6
6
6
5 Other features
7
7
8
8
6 Product information
8
8
7Troubleshooting
9
What's in the box
Install battery
Connect power
Set time
Tune to FM radio stations
Store FM radio stations manually
Select a preset radio station
Adjust volume
Set alarm timer
Set sleep timer
Adjust brightness
Specifications
8Notice
10
EN
2
1Important
•
•
•
•
•
•
•
•
•
•
•
3
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the clock radio.
Only use attachments/accessories specified
by the manufacturer.
Unplug this clock radio during lightning
storms or when unused for long periods
of time.
Refer all servicing to qualified service
personnel. Servicing is required when
the clock radio has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the clock radio, the
clock radio has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
clock radio:
• Install the battery correctly, + and - as
marked on the clock radio.
• Remove the battery when the clock
radio is not used for a long time.
• The battery shall not be exposed to
excessive heat such as sunshine, fire or
the like.
This clock radio shall not be exposed to
dripping or splashing.
EN
•
•
Do not place any sources of danger on the
clock radio (e.g. liquid filled objects, lighted
candles).
Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
2 Your clock radio
3 Get started
Congratulations on your purchase, and
welcome to Philips! To fully benefit from the
support that Philips offers, register your product
at www.philips.com/welcome.
Always follow the instructions in this chapter in
sequence.
What's in the box
(Fig.
)
a
Install battery
If there is power interruption, the clock
memory backup allows your alarm and clock
settings to be stored for up to a day. The display
backlight will be off.
Caution
•• Risk of explosion! Keep the battery away from heat,
sunshine or fire. Never discard battery in fire.
•• The battery contains chemical substances, so it should
be disposed of properly.
Insert 2 x 1.5V AAA battery (not supplied) with
correct polarity (+/-) as illustrated. (Fig. )
b
EN
4
Connect power
Set time
Caution
•• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
•• Risk of electric shock! When you unplug the power
adapter, always pull the plug from the socket. Never
pull the cord.
Note
•• The type plate is located at the bottom of the clock
Note
•• You can only set time in standby mode.
(Fig.
d
1
2
PRESET/
SET TIME
radio.
(Fig.
)
HOUR
2 sec
)
c
3
MIN
5
EN
4
PRESET/
SET TIME
4 Listen to FM
radio
Store FM radio stations
manually
You can store up to 10 FM radio stations.
1
2
Note
•• Keep the clock radio away from other electronic
devices to avoid radio interference.
3
•• For better reception, fully extend and adjust the
position of the FM antenna.
4
5
Tune to FM radio stations
(Fig.
Tune to an FM radio station.
Press and hold PRESET for two seconds.
»» The preset number begins to blink.
Press TUNING
number.
repeatedly to select a
Press PRESET again to confirm.
Repeat steps 1 to 4 to store other stations.
Tip
)
•• To remove a pre-stored station, store another station
in its place.
e
1
Select a preset radio station
2
RADIO
ON/OFF
TUNING
MIN
2 sec
In tuner mode, press PRESET repeatedly to
select a preset number.
Adjust volume
4
3
TUNING
HOUR
2 sec
- VOLUME +
While listening, press - VOLUME + to adjust
volume.
»» The volume level (1~15) shows in the
display.
EN
6
5 Other features
Tip
•• The clock radio exits alarm setting mode when being
idle for 10 seconds.
Set alarm timer
Select alarm source
Set alarm
You can select FM radio or buzzer as the alarm
source. (Fig. )
»» The corresponding alarm icon lights up.
• The AL2 setting is the same as AL1.
Note
•• You can only set the alarm in standby mode.
•• When alarm sounds, volume rises gradually. You cannot
adjust the alarm volume manually.
•• Make sure that you have set the clock correctly.
Follow the illustration to set the first alarm. (Fig.
)
• AL1: set the first alarm.
• AL2: set the second alarm.
f
g
AL1 FM
AL1
AL1
1
2
AL1
2 sec
HOUR
Activate/deactivate alarm timer
3
4
MIN
7
Press AL1 or AL2 repeatedly to activate or
deactivate the alarm timer.
»» If the alarm timer is deactivated, the
alarm indicator turns off.
EN
AL1
»» The alarm repeats ringing for the next
day.
Snooze alarm
When alarm sounds, press SNOOZE.
»» The alarm snoozes and repeats ringing
nine minutes later.
6Product
information
Note
Set sleep timer
•• Product information is subject to change without prior
notice.
This clock radio can switch to standby mode
automatically after a preset period. (Fig. )
h
Specifications
SLEEP
Amplifier
Total Output Power
0.4W RMS
Tuner (FM)
120
90
60
30
15
OFF
To deactivate the sleep timer:
• Press SLEEP repeatedly until [OFF]
(off) appears.
Tuning range
Tuning grid
Sensitivity
- Mono, 26 dB S/N Ratio
- Stereo, 46 dB S/N Ratio
Total Harmonic Distortion
Signal to Noise Ratio
Adjust brightness
General information
Press BRIGHTNESS repeatly to adjust display
brightness.
AC power (power
adapter)
i
BRIGHTNESS
Operation Power
Consumption
Standby Power
Consumption
87.5-108
MHz
50 KHz
<22 dBf
<49.5 dBf
<2%
>50 dBA
Brand name: Philips;
Model: AS030-050EI050;
Input: 100-240 V~,
50/60 Hz; 0.15 A;
Output: 5.0 V 0.5 A
1.2 W
<1 W
EN
8
Dimensions:
Main Unit
(W x H x D)
Weight:
-Main Unit
7Troubleshooting
191 x 104 x 69 mm
0.33 kg
Warning
•• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•• Ensure that the AC power plug of the unit
is connected properly.
•• Ensure that there is power at the AC
outlet.
No sound
•• Adjust the volume.
No response from the unit
•• Disconnect and reconnect the AC power
plug, then turn on the unit again.
Poor radio reception
•• Increase the distance between the unit and
your TV or VCR.
•• Fully extend the FM antenna.
Alarm does not work
•• Set the clock/alarm correctly.
Clock/alarm setting erased
•• Power has been interrupted or the power
plug has been disconnected.
•• Reset the clock/alarm.
9
EN
8Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
Community.
Disposal of your old product
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU. Inform yourself about the local
separate collection system for electrical and
electronic products. Follow local rules and never
dispose of the product with normal household
waste. Correct disposal of old products
helps prevent negative consequences for the
environment and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
EN
10
Specifications are subject to change without notice
2014 © WOOX Innovations Limited.
All rights reserved.
Philips and the Philips’ Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used by WOOX
Innovations Limited under license from Koninklijke Philips N.V.
AJ3400_05_UM_V3.0
Download PDF
Similar pages