AVX
Specifications
EKP AVX
21 mm
81 mm
51 mm
SKM AVX/SKM AVX-S
ca. 275 mm
40 mm
24
m
m
SK AVX
100 mm
65 mm
AVX
Specifications
System
AF frequency response
Dynamic range
THD (1 kHz)
Audio sampling
Signal-to-noise ratio
RF frequency ranges
Modulation
Transmission method
Latency
Relative air humidity
Temperature range*
20 to 20,000 Hz
> 120 dB (A)
typ. 0.1 %
24 bit/48 kHz
> 90 dB (A)
1,880 to 1,930 MHz
(country-specific)
GFSK with back channel
TDMA
fast switching antenna diversity
19 ms
max. 95 %
Operation: –10 °C to +55 °C
Storage: –20 °C to +70 °C
* The temperature range is influenced by the battery characteristics
EKP AVX
RF sensitivity
RF output power back
channel
Audio output
XLR, balanced
Power supply
Operating time
AF connection socket
Weight (incl. BA 20)
< –90 dBm
typ. 15 dBm e.i.r.p.
adjustable
–30 dBu to 0 dBu in 4 steps
BA 20 (Li-Ion 3.7 V DC)
>4h
XLR, male
approx. 87 g
SKM AVX
RF output power
AF frequency response
Input sensitivity
Power supply
Operating time
Display
Weight (w/o accupack)
adaptive, up to 250 mW
(country-specific)
50 to 20,000 Hz
automatic sensitivity adjustment
Accupack: BA 10 (Li-Ion, 3.6 V)
Batteries*: 2 x AA size battery (1.5 V)
Accupack: typ. 15 h
Batteries*: typ. 10 h
LCD
approx. 282 g incl. microphone head
* optional accessory
1
SK AVX
RF output power
AF frequency response
Max. input level
Line input impedance
Input sensitivity
Power supply
Operating time
AF connection socket
adaptive, up to 250 mW
(country-specific)
50 to 20,000 Hz
Mic: Line: 20 to 20,000 Hz
1.5 V RMS
Mic: 3.1 V RMS
Line: 1 MW
automatic sensitivity adjustment
Accupack: BA 30 (Li-Ion, 3.7 V)
Batteries*: 2 x AA size battery (1.5 V)
Accupack: typ. 15 h
Batteries*: typ. 11 h
3.5 mm jack socket, lockable
connector assignment:
Mic
Weight (w/o accupack)
Line
approx. 87 g
* optional accessory
MMD 835-1 MMD 42-1
Microphone type
Sensitivity
Pick-up pattern
Max. SPL
2.1 mV/Pa
cardioid
154 dB SPL
dynamic
1,8 mV/Pa
omni-directional
154 dB SPL
ME 2-2
Microphone type
Sensitivity
Pick-up pattern
Max. SPL
pre-polarized condenser microphone
20 mV/Pa
omni-directional
130 dB SPL
MKE 2
Microphone type
Sensitivity
Pick-up pattern
Max. SPL
2
pre-polarized condenser microphone
5 mV/Pa
omni-directional
142 dB SPL
In compliance with
Europa
Radio
EMC
Safety
EN 301406
EN 301489-1/-6
EN 60950-1
EN 62311 (SAR)
EN 50581
RoHS
FCC 47 CFR 15
Industry Canada RSS 210
CAN ICES-3 (B)/NMB-3(B)
USA
Canada
Approved by
USA
SKM
SK
EKP
Canada
SKM
SK
EKP
Australia/New Zealand
FCC ID: DMOSKM1G9WE
FCC ID: DMOSK1G9WE
FCC ID: DMOEKP1G9WE
IC: 2099A-SKM1G9WE
IC: 2099A-SK1G9WE
IC: 2099A-EKP1G9WE
Japan
SKM R 202-SMC049
SK
R 202-SMC050
EKP R 202-SMC051
NT 5-10U
Nominal input voltage
Power frequency
Nominal output voltage
Output current
Standby power consumption
Energy efficiency level
Operating temperature
Storage temperature
Relative air humidity
Weight
100 to 240 V~
50 or 60 Hz
5V
1A
≤ 0.1 W
V
0 °C to +40 °C
–20 °C to +70 °C
max. 90 %
approx. 55 g
In compliance with
Europe
USA/
Canada
Australia
EMC
EN 55022, EN 55024
Safety
EN 60950-1
RoHs
EN 50581
Commision Regulation (EC) No. 1275/2008
EMC
FCC 47 CFR 15 B
ICES 003, CAN ICES-3(B)/NMB-3(B)
Safety
UL 60950-1
CAN/CSA-C22.2 No. 60950-1
EMC
AS/NZ CISPR 22
Safety
AS/NZL 60950.1
Certified by
Europe
USA/Canada
ENEC 22 SIQ
C
US
Australia/New Zealand
Japan
3
Accupacks
Charging capacity
Output voltage
BA 10
2200 mAh
3.6 V
BA 20
430 mAh
3.7 V
BA 30
2030 mAh
3.7 V
In compliance with
Europe
EMC
EN 301489-1/-6/-17
Safety
IEC/EN 62133
USA/Canada
Rechargeable
battery cells
UL 1642
Accupack
UL 2054
Japan
DENAN Ordinance Article 1;
Appendix 9 Lithium Ion
Korea
Safety
K 62133
UN transportation test according to UN Manual of Tests and
Criteria, Part III, section 38.3 Lithium-Ion
batteries
Certified by
USA/Canada
Japan
Korea
Manufacturer Declarations
Warranty
• Sennheiser electronic GmbH & Co. KG gives a warranty of 24 months on
this product.
• For the current warranty conditions, please visit our website at www.
sennheiser.com or contact your Sennheiser partner.
FOR AUSTRALIA ONLY
Sennheiser goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the goods repaired or replaced if
the goods fail to be of acceptable quality and the failure does not amount
to a major failure.
This warranty is in addition to other rights or remedies under law. Nothing
in this warranty excludes, limits or modifies any liability of Sennheiser
which is imposed by law, or limits or modifies any remedy available to the
consumer which is granted by law.
To make a claim under this warranty, contact Sennheiser Australia Pty Ltd,
Unit 3, 31 Gibbes Street Chatswood NSW 2067, AUSTRALIA. Phone: (02)
9910 6700, email: service@sennheiser.com.au.
All expenses of claiming the warranty will be borne by the person making
the claim.
The Sennheiser International Warranty is provided by Sennheiser Australia
Pty Ltd (ABN 68 165 388 312), Unit 3, 31 Gibbes Street Chatswood NSW
2067 Australia.
4
In compliance with the following requirements
• WEEE Directive (2012/19/EU)
Please dispose of the products at the end of their operational
lifetime by taking them to your local collection point or recycling
center for such equipment.
• Battery Directive (2006/66/EC)
The supplied batteries or rechargeable batteries can be recycled. Please
dispose of them as special waste or return them to your specialist
dealer. In order to protect the environment, only dispose of exhausted
batteries or rechargeable batteries.
CE Conformity
•
•
•
•
•
0682
R&TTE Directive (1999/5/EC)
RoHS Directive (2011/65/EU)
EMC Directive (2004/108/EU)
Low Voltage Directive (2006/95/EU)
The declarations are available at www.sennheiser.com. Before putting the
products into operation, please observe the respective country-specific
regulations.
FCC
NOTICE:
These devices comply with Part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved
by Sennheiser Electronic Corporation may void the FCC authorization to
operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
These class B digital devices comply with the Canadian ICES-003.
Japanese Radio Law and Japanese Telecommunications Business
Law Compliance.
This device is granted pursuant to the Japanese Radio Law (電波法)
This device should not be modified (otherwise the granted designation
number will become invalid)
5
Licenses
CELT Codec
Copyright (c) 2014 IETF Trust and the persons identified as authors of the
code. All rights reserved.
Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions are met:
• Redistributions of source code must retain the above copyright notice,
this list of conditions and the following disclaimer.
• Redistributions in binary form must reproduce the above copyright
notice, this list of conditions and the following disclaimer in the
documentation and/or other materials provided with the distribution.
• Neither the name of Internet Society, IETF or IETF Trust, nor the names
of specific contributors,may be used to endorse or promote products
derived from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND
CONTRIBUTORS “AS IS“ AND ANY EXPRESS OR IMPLIED WARRANTIES,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR
CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,
OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
(INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF
THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH
DAMAGE.
Ubuntu Font License
Version 1.0
Preamble
This license allows the licensed fonts to be used, studied, modified and
redistributed freely. The fonts, including any derivative works, can be
bundled, embedded, and redistributed provided the terms of this license
are met. The fonts and derivatives, however, cannot be released under
any other license. The requirement for fonts to remain under this license
does not require any document created using the fonts or their derivatives
to be published under this license, as long as the primary purpose of the
document is not to be a vehicle for the distribution of the fonts.
Permission & Conditions
This license does not grant any rights under trademark law and all such
rights are reserved.
Permission is hereby granted, free of charge, to any person obtaining a
copy of the Font Software, to propagate the Font Software, subject to the
below conditions:
1. Each copy of the Font Software must contain the above copyright
notice and this license. These can be included either as stand-alone text
files, human-readable headers or in the appropriate machine-readable
metadata fields within text or binary files as long as those fields can be
easily viewed by the user.
2. The font name complies with the following:
1. The Original Version must retain its name, unmodified.
2. Modified Versions which are Substantially Changed must be renamed
to avoid use of the name of the Original Version or similar names
entirely.
3. Modified Versions which are not Substantially Changed must be
renamed to both
1. retain the name of the Original Version and
2. add additional naming elements to distinguish the Modified
I
Version from the Original Version. The name of such Modified
Versions must be the name of the Original Version, with „derivative
X“ where X represents the name of the new work, appended to that
name.
3. The name(s) of the Copyright Holder(s) and any contributor to the
Font Software shall not be used to promote, endorse or advertise any
Modified Version, except
1. as required by this license,
2. to acknowledge the contribution(s) of the Copyright Holder(s) or
3. with their explicit written permission.
4. The Font Software, modified or unmodified, in part or in whole, must
be distributed entirely under this license, and must not be distributed
under any other license. The requirement for fonts to remain under this
license does not affect any document created using the Font Software,
except any version of the Font Software extracted from a document
created using the Font Software may only be distributed under this
license.
Termination
This license becomes null and void if any of the above conditions are not
met.
Disclaimer
THE FONT SOFTWARE IS PROVIDED „AS IS“, WITHOUT WARRANTY OF
ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE
AND NONINFRINGEMENT OF COPYRIGHT, PATENT, TRADEMARK, OR OTHER
RIGHT. IN NO EVENT SHALL THE COPYRIGHT HOLDER BE LIABLE FOR ANY
CLAIM, DAMAGES OR OTHER LIABILITY, INCLUDING ANY GENERAL, SPECIAL,
INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, WHETHER IN AN
ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF THE
USE OR INABILITY TO USE THE FONT SOFTWARE OR FROM OTHER DEALINGS
IN THE FONT SOFTWARE.
II
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com
Publ. 01/15, 554644/A03