Copyright © 2017 Exablaze Pty Ltd. All Rights Reserved. www

Copyright © 2017 Exablaze Pty Ltd. All Rights Reserved.
www.exablaze.com
ExaNICV5P
HIGH DENSITY NETWORK APPLICATION CARD
HARDWARE
PERFORMANCE
16nm Xilinx Virtex Ultrascale+ FPGA:
- XCVU5P-2 (A2104)
- 1.3M System Logic Cells, 1.2M CLBs
- 36Mb block RAM
- 133.2Mb UltraRAM
- 16x 32.75Gb/s transceivers
- XCVU7P and XCVU9P available
PCS/MAC (TX + RX)2:
- 9.6ns (min) @ 10Gbps,
- 1Gbps/100Mbps also supported
SERDES/PCS/MAC/CDC (TX+RX)2:
- Packet trigger, 39ns (min)
- Full loopback, 51ns (min)
QDR IV SRAM:
- 144MBit
- dual 36-bit interface, up to 1066MHz
- 30ns read using Exablaze IP
Software latency (raw frame, ½RTT)1:
- 60 bytes – 780ns
- 300 bytes – 999ns
GENERAL
DDR4 DRAM:
- 9GByte
- 72-bit interface, up to 2666MHz
Oscillators:
- 161MHz crystal
- 10MHz temperature compensated crystal
- 10MHz – 750Hz programmable (I2C) crystal
Head Office:
EXABLAZE PTY LTD
Level 5, 443 Little
Collins Street
Melbourne VIC 3000,
Australia
+61 3 9111 1773
info@exablaze.com
Input/output:
- PPS in/out via MCX connector, 3.3V CMOS,
selectable 50ohm termination
- 8x 1.8V CMOS GPIO via header
- 2x bi-color port LEDs
- 12V external supply (GPU adapter) for >25W designs
Programming / Debugging:
- Software based PCIe flash programming utility
- Easy access, front panel USB to JTAG port
- JTAG header on board (auto select)
- 1Gbit onboard flash (space for 2x full images)
Form factor:
- Low profile PCI Express Card
- 168x69mm (6.6x2.7in)
Host Interface3:
- PCIe x8 Gen 4 @ 16.0 GT/s per lane
Data rates4:
- 100GbE, 50GbE, 40GbE, 25GbE, 10GbE,
1GbE, 100M Fast Ethernet
Supported Media1,4:
- Fiber ( 100GBASE-SR4, 100GBASE-LR4,
40GBASE-SR4, 40GBASE-LR4), QSFP/28
Direct Attach breakout
Operating Systems:
- Linux x86_64 (all distributions)
- Windows (limited software support)
Engineering Office:
EXABLAZE PTY LTD
Level 6, 76-80 Clarence St
Sydney NSW 2000,
Australia
+61 2 8668 3008
info@exablaze.com
Notes
Notes
1.
2.
3.
4.
Preliminary results only. Final results to be confirmed.
9.6ns latency currently only supported for 10GbE operation.
PCIe Gen 4 functionality coming soon via firmware upgrade.
25/50/100GbE functionality coming soon via firmware upgrade.
Copyright © 2017 Exablaze Pty Ltd. All Rights Reserved.
Rev 1.1
www.exablaze.com
Download PDF
Similar pages