2. Aqua Smarte Plus CANNONBALL!™
After Aqua Smarte Plus Shine and Aqua Smarte Plus
Optimize have dispensed, test the water before adding Aqua
Smarte Plus Cannonball! for a 90-day algae-protection guarantee. When the pH is between 7.2 and 7.8 and the chlorine
level is no more than 4.0 ppm, follow steps 1-8 below.
90
MIN
6. To remove Aqua Smarte Plus
CANNONBALL!, turn pump off, turn dial to
lowest setting, remove system cap.
1. Turn off pump and turn dial to
lowest setting and remove cap from
the Aqua Smarte or Aqua Smarte
Plus System.
7. Lift Aqua Smarte Plus CANNONBALL!
up and allow any water in the container to
drain through the system before recycling
or discarding in trash.
NOTE: If water shows more than a hint of
blue inside Aqua Smarte or Aqua Smarte
Plus System, replace the cap, turn dial
to Setting 5 and run the pump for one
minute.
8. If pool size requires additional Aqua
Smarte Plus CANNONBALL!, repeat steps
1-7.
2. Remove cap from Aqua Smarte
Plus CANNONBALL! without removing
seal.
3. Insert upside down into center of
Aqua Smarte Plus Mineral Activator
pushing down firmly on key to
puncture seal.
4
4. Replace cap by hand only.
DO NOT OVER TIGHTEN. Turn control
dial to Setting 5.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095;
6,948,510 and other U.S. and Foreign patents pending.
5. Turn pump on for 90 minutes allowing Aqua Smarte Plus CANNONBALL! to
circulate through pool.
NOTE: Avoid adding other chemicals until this
product has been circulated (filtered) for at least
24 hours.
Ensure a worry free off season as your pool sleeps
away the winter months.
553081243R2N 20-48-0263
Pool Asleep™
Operation Instructions
For Fall Closings
The 1-2 Winterizing Punch!
1.Aqua Smarte Plus Shine™ removes
contaminants to keep
water crystal clear
2.Aqua Smarte Plus
CANNONBALL!™
prevents algae to
prepare the pool for a smoother spring start-up
SHINE “
Eliminates Contaminants for
Crystal Clear Water
King Technology, Inc.
530 11th Ave S, Hopkins, MN 55343
952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
2. Aqua Smarte Plus CANNONBALL!™
After Aqua Smarte Plus Shine and Aqua Smarte Plus
Optimize have dispensed, test the water before adding Aqua
Smarte Plus Cannonball! for a 90-day algae-protection guarantee. When the pH is between 7.2 and 7.8 and the chlorine
level is no more than 4.0 ppm, follow steps 1-8 below.
1. Turn off pump and turn dial to
lowest setting and remove cap from
the Aqua Smarte or Aqua Smarte
Plus System.
2. Remove cap from Aqua Smarte
Plus CANNONBALL! without removing
seal.
3. Insert upside down into center of
Aqua Smarte Plus Mineral Activator
pushing down firmly on key to
puncture seal.
4
4. Replace cap by hand only.
DO NOT OVER TIGHTEN. Turn control
dial to Setting 5.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095;
6,948,510 and other U.S. and Foreign patents pending.
90
MIN
5. Turn pump on for 90 minutes allowing Aqua Smarte Plus CANNONBALL! to
circulate through pool.
6. To remove Aqua Smarte Plus
CANNONBALL!, turn pump off, turn dial to
lowest setting, remove system cap.
7. Lift Aqua Smarte Plus CANNONBALL!
up and allow any water in the container to
drain through the system before recycling
or discarding in trash.
NOTE: If water shows more than a hint of
blue inside Aqua Smarte or Aqua Smarte
Plus System, replace the cap, turn dial
to Setting 5 and run the pump for one
minute.
8. If pool size requires additional Aqua
Smarte Plus CANNONBALL!, repeat steps
1-7.
NOTE: Avoid adding other chemicals until this
product has been circulated (filtered) for at least
24 hours.
Ensure a worry free off season as your pool sleeps
away the winter months.
553081243R2N 20-48-0263
Pool Asleep™
Operation Instructions
For Fall Closings
The 1-2 Winterizing Punch!
1.Aqua Smarte Plus Shine™ removes
contaminants to keep
water crystal clear
SHINE “
Eliminates Contaminants for
Crystal Clear Water
King Technology, Inc.
530 11th Ave S, Hopkins, MN 55343
952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
2.Aqua Smarte Plus CANNONBALL!™
prevents algae to
prepare the pool for a smoother spring start-up
1. Aqua Smarte Plus Shine™
Before lowering the water level and discarding the used Aqua Smarte Plus Mineral
Activator, insert Aqua Smarte Plus Shine
using steps 1 through 8.
COLORED
CAPS
1. With the circulation
system off, set control
dial to lowest setting and
remove the cap to the
Aqua Smarte or Aqua
Smarte Plus System.
2. Remove caps from Aqua
Smarte Plus Shine with a
pliers or other suitable tool.
3. Turn Aqua Smarte Plus
Shine over so open ends
face down and insert into
the center of the Aqua
Smarte Plus Mineral
Activator. The ends of the
pac will align with an
L-shaped key in the
system. DO NOT FORCE.
SHINE “
Eliminates Contaminants for
Crystal Clear Water
2
1. With the circulation
system off, set control
dial to lowest setting and
remove the cap to the
Aqua Smarte or Aqua
Smarte Plus System.
1. Aqua Smarte Plus Shine™
Before lowering the water level and discarding the used Aqua Smarte Plus Mineral
Activator, insert Aqua Smarte Plus Shine
using steps 1 through 8.
4
4. Replace cap on Aqua
Smarte or Aqua Smarte
Plus System and set dial to
Setting 5.
SHINE
™
Eliminates Contaminants for
Crystal Clear Water
SHINE
™
ts for
Contaminan
Eliminates
Clear Water
Crystal
6. Remove the empty Aqua
Smarte Plus Shine and
discard or recycle.
WE RECYCLE
1
HOUR
5. Turn on pump and allow
1 hour for the product to
slowly dispense into the
pool. If after 1 hour, the pac
still contains some ingredient, re-insert, replace cap
and run the circulation for
an additional 30 minutes.
7. Replace cap on Aqua
Smarte or Aqua Smarte
Plus System and allow
circulation to run at least
15 minutes before inserting any other Aqua Smarte
Plus pac products.
8. Repeat steps 1-7 if
additional Aqua Smarte
Plus Shine is required.
All components are recyclable when finished dispensing.
3
4
4. Replace cap on Aqua
Smarte or Aqua Smarte
Plus System and set dial to
Setting 5.
SHINE
™
Eliminates Contaminants for
Crystal Clear Water
SHINE
™
ts for
Contaminan
Eliminates
Clear Water
Crystal
6. Remove the empty Aqua
Smarte Plus Shine and
discard or recycle.
WE RECYCLE
COLORED
CAPS
2. Remove caps from Aqua
Smarte Plus Shine with a
pliers or other suitable tool.
SHINE “
Eliminates Contaminants for
Crystal Clear Water
2
3. Turn Aqua Smarte Plus
Shine over so open ends
face down and insert into
the center of the Aqua
Smarte Plus Mineral
Activator. The ends of the
pac will align with an
L-shaped key in the
system. DO NOT FORCE.
1
HOUR
5. Turn on pump and allow
1 hour for the product to
slowly dispense into the
pool. If after 1 hour, the pac
still contains some ingredient, re-insert, replace cap
and run the circulation for
an additional 30 minutes.
7. Replace cap on Aqua
Smarte or Aqua Smarte
Plus System and allow
circulation to run at least
15 minutes before inserting any other Aqua Smarte
Plus pac products.
All components are recyclable when finished dispensing.
3
8. Repeat steps 1-7 if
additional Aqua Smarte
Plus Shine is required.
Download PDF
Similar pages