Log Set Assembly: LOGS-CFXG Model: CFX

LOG PLACEMENT INSTRUCTIONS
Log Set Assembly: LOGS-CFXG
Model: CFX-GRAND
Carefully remove the logs from the packaging.
CAUTION: LOGS ARE FRAGILE! Handle with care.
Model CFX-GRAND requires placement of air deflector and
grate assembly prior to installing the logs.
Position the air deflector behind the burner assembly such
that it positions left to right on locating notch with the burner
inlet tube. Proper placement REQUIRES that the air deflector is placed flush against the back of burner.
Position the grate assembly above the burner such that locating tabs align with pilot holes in burner surface. See
Figure 2.
Figure 2.
This model uses location pins to positively locate the logs
with respect to mating the logs and the grate assembly.
The steel locating pins can be found in the manual bag assembly shipped with the fireplace. Refer to pin locations on
the grate assembly. See Figure 3.
2
3
4
5
1
6
Figure 3. Pin Locations
Figure 1.
Hearth & Home Technologies • LOGS-CFXG Log Instructions • 568-935 Rev. C • 3/15
1
7
6 5 4 3 21
Figure 4. Log Set Components
1
Log #1 (SRV573-701): Place locating pins into holes 1 and 2 on the grate assembly. Place Log #1 onto grate such that
locating pins mate with holes on bottom surface of the log. Push log down until it sits flush on the grate bars.
2
Log #2 (SRV568-705): Place a locating pin in grate hole #3. Position Log #2 onto grate such that pin mates with hole
on bottom surface log.
2
Hearth & Home Technologies • LOGS-CFXG Log Instructions • 568-935 Rev. C • 3/15
3
Log #3 (SRV573-704): Place locating pins into holes #4 and #5 on grate assembly. Position Log #3 onto grate such
that pins mate with holes on bottom surface of log. Push down until log is sitting flat on grate.
4
Log #4 (SRV573-705): Place locating pin into surface of Log #3 (on the flat area). Place Log #4 into position such that
pin mates with hole on bottom surface of log.
FLAT SPOT FOR
LOG #6
1
5
LOCATING BAR
Log #5 (SRV568-705): Place locating pin into hole #6 on grate. Position Log #5 in place such that pin mates with hole
on bottom surface of log. Left end of Log #5 should rest on grate bar against the end of the locating bar.
Hearth & Home Technologies • LOGS-CFXG Log Instructions • 568-935 Rev. C • 3/15
3
6
1
Log #6 (SRV573-702): Position Log #6 on flat spot on Log #1.
7
Log #7 (SRV568-706): Place locating pins into holes on top surfaces of Log #5 and Log #6. Position Log #7 in place
such that pins mate with holes on bottom surface of log.
4
Hearth & Home Technologies • LOGS-CFXG Log Instructions • 568-935 Rev. C • 3/15
Download PDF
Similar pages