D100-DC - Aion LED

DRIVER | DC BLUE | D100-DC
D100-DC
96 WATT MLV DRIVER
™
Premium Class 2 Dimming
LED Driver
Magnetic Low Voltage Transformer
Pure DC MOSFET Supply
Fully Regulated
0.1% DIMMING*
MADE IN USA
Multiple Inputs Available:
120, 240, 277 VAC
UL LISTED 8750,
CSA Approved
™
D50-DC
DIMMING LED DRIVER
PRIMARY (INPUT)
SECONDARY (OUTPUT)
24VDC, 2A, 48VA MAX
120VAC, 50/60HZ, .63A
(BLK= HOT, WHT=COMMON)
(RED=POS, BLK=NEG)
WARNING:
Refer to the “MOUNTING
AND INSTALLATION
INSTRUCTIONS” Included
with this unit.
For Grounding Conductor, Use
18AWG minimum.
Risk of Electric Shock. Install
Only on a circuit protected by a
Class A GFCI.
CLASS 2 POWER UNIT
3YZ3
U
DATE
03/13/14 MADE IN USA CU L
CODE
www.AionLED.com
NEMA 3R Outdoor Case
Rainproof
UL1012/1310
S LISTED
E466920
Manual reset overload protection
5 Year Warranty
Electrician Installed - Strictly adhere to NEC & local code. Requires
minimum 4” space in all directions. Requires adequate ventilation. Use
dedicated circuit Isolated from other appliances. Load 40 - 90%
DO NOT USE PHASE ADAPTIVE
Requires Aion LED brand lighting fixture and approved dimmer
or switch. Sold separately, not included
*SEE APPROVED
CONTROLS FORWARD PHASE MLV
CONTROLS ONLY
CONTROLS LIST
E348513
Component of a complete system including: Aion LED A-Track Light Engine, Aion LED A-Track housing with diffuser lens, & Aion LED driver (power supply). Dimmer
not included. Approved dimmers, controls, power supplies, cable, & other components only. Contact Aion LED for questions regarding compatibility. Electrician
installed. Strictly adhere to NEC & local building code. Limited 5-year warranty against manufacturing defects only, does not cover labor; voided by: inadequate
ventilation, field modifications, installation by unqualified personnel, unapproved controls, drivers, cabling, other devices, not following installation guidelines & protocol,
general negligence. Installer assumes all liability with regard to property & safety. This product is UL listed. See separate “Aion LED Warranty Terms” & additional
instructional materials for more information. Authorized installers only. Systems tested prior to shipping.
AIONLED.COM | (415) 255-AION
Modified: September 11, 2017
© 2017 Aion LED. All Rights Reserved
DRIVER | DC BLUE | D100-DC
D100-DC
96 WATT MLV DRIVER
™
Premium Class 2 Dimming
LED Driver
Magnetic Low Voltage Transformer
Pure DC MOSFET Supply
BACK
11.25
FRONT
SIDE
Fully Regulated
0.1% DIMMING*
10
MADE IN USA
UL LISTED 8750,
CSA Approved
NEMA 3R Outdoor Case
3.37
3.25
Manual reset overload protection
Max Lengths
Model
D100-DC
Watts
96
Standard Input Voltage
120 VAC
Dimensions ”
11.25 X 3.37 X 3.25
3000 Series
60 ft.
(2 x 30)
Output Voltage Loaded
24 VDC
Input Current
1.12A
4000 Series
30 ft.
Output Current
4A, 96W
Input Frequency (Hz)
50-60
8000 Series
15 ft.
Current Limit
2.5/4.5 +/- 0.25
Efficiency
80%
Load Regulation
2%
MTBF
100,000
18 AWG
27 ft.
Line Regulation
5%
Operating Environment
-30 to +60
16 AWG
44 ft.
Function Surface Temp
-40 to +80
14 AWG
70 ft.
12 AWG
112 ft.
10 AWG
180 ft.
8 AWG
286 ft.
DO NOT USE PHASE-ADAPTIVE CONTROLS
FORWARD PHASE MLV CONTROLS ONLY
*SEE APPROVED CONTROLS LIST
Component of a complete system including: Aion LED A-Track Light Engine, Aion LED A-Track housing with diffuser lens, & Aion LED driver (power supply). Dimmer
not included. Approved dimmers, controls, power supplies, cable, & other components only. Contact Aion LED for questions regarding compatibility. Electrician
installed. Strictly adhere to NEC & local building code. Limited 5-year warranty against manufacturing defects only, does not cover labor; voided by: inadequate
ventilation, field modifications, installation by unqualified personnel, unapproved controls, drivers, cabling, other devices, not following installation guidelines & protocol,
general negligence. Installer assumes all liability with regard to property & safety. This product is UL listed. See separate “Aion LED Warranty Terms” & additional
instructional materials for more information. Authorized installers only. Systems tested prior to shipping.
Max Wire Distance
AIONLED.COM | (415) 255-AION
Modified: September 11, 2017
© 2017 Aion LED. All Rights Reserved
DRIVER | DC BLUE | D100-DC | WIRING
WIRING DIAGRAM
D100-DC
Building Power
120/240/277 VAC
Primary
™
D50-DC
DIMMING LED DRIVER
PRIMARY (INPUT)
SECONDARY (OUTPUT)
24VDC, 2A, 48VA MAX
120VAC, 50/60HZ, .63A
(BLK= HOT, WHT=COMMON)(R
ED=POS, BLK=NEG)
WARNING:
Refer to the “MOUNTING
AND INSTALLATION
INSTRUCTIONS” Included
with this unit.
For Grounding Conductor, Use
18AWG minimum.
Risk of Electric Shock. Install
Only on a circuit protected by a
Class A GFCI.
Rainproof
CLASS 2 POWER UNIT
3YZ3
U
DATE
03/13/14 MADE IN USA CU L
CODE
www.AionLED.com
D50-DC (1 x 48W)
D100-DC (1 x 96W)
UL1012/1310
S LISTED
E466920
24 VDC
Installation Instructions
1. This unit must be located 1 foot or greater above
the deck or ground level. 4” space required between
units.
•
For connection, use No. 12-18 AWG wires insulated
for a minimum of 90C, rated for 600V. Tightening
torque 7 in-lbs for output terminal block.
2. Mount this unit on a suitable vertical surface with
conduit openings down.
•
Use wire connectors suitable for the number and
size conductors being connected and applied in
accordance with the manufacturer’s instructions.
•
Minimum 20 amp supply side branch circuit.
•
A disconnect device shall be located in the field
wiring.
3. Using a ruler, measure the vertical mounting point
distance for the brackets provided on the back of the
enclosure.
4. Mark the mounting surface and drill a minimum of 2
holes to match the bracket hole centers. Size the drill
to accommodate #10 mounting hardware.
5. If keyhole mounting brackets are provided, insert the
hardware at the mounting point to allow for 3/16”
spacing between the screw head and the mounting
surface to accommodate the bracket thickness.
6. Refer to the product labeling for detailed line and load
wiring procedure.
Aion LED DC Blue Series drivers have been factory tested for use with
specific 120 VAC dimmers designed for magnetic (MLV) forward-phase
loads.
PLEASE SEE APPROVED DIMMERS PAGE FOR COMPATIBLE
CONTROLS. DO NOT ATTEMPT CONNECTING UNAPPROVED
DIMMERS OR CONTROLS. DAMAGE TO THE DIMMER, FIXTURE
AND/OR THE POWER UNIT WILL RESULT; THE POWER UNIT
WARRANTY WILL BE VOIDED.
Please load 40–90% MAX. Please see specifications page for fixturespecific max load/ run length information.
Component of a complete system including: Aion LED A-Track Light Engine, Aion LED A-Track housing with diffuser lens, & Aion LED driver (power supply). Dimmer
not included. Approved dimmers, controls, power supplies, cable, & other components only. Contact Aion LED for questions regarding compatibility. Electrician
installed. Strictly adhere to NEC & local building code. Limited 5-year warranty against manufacturing defects only, does not cover labor; voided by: inadequate
ventilation, field modifications, installation by unqualified personnel, unapproved controls, drivers, cabling, other devices, not following installation guidelines & protocol,
general negligence. Installer assumes all liability with regard to property & safety. This product is UL listed. See separate “Aion LED Warranty Terms” & additional
instructional materials for more information. Authorized installers only. Systems tested prior to shipping.
AIONLED.COM | (415) 255-AION
Modified: September 11, 2017
© 2017 Aion LED. All Rights Reserved
DRIVER | DC BLUE DIMMER LIST
Lutron
Testing completed by Aion LED and
MAESTRO:
MRF2-6ND
0.1-1%*
(DO NOT
RECOMMEND
MALV-600)
NOVA:
NTLV-600
0.1-1%*
HE TRIM
ensure compatibility.
(DO NOT
RECOMMEND
RPM-4A)
MLV FORWARD PHASE ONLY.
HOMEWORKS QS:
RPM-4U
HQRD-10ND
HQRD-6ND
HQRD-6CL (H2)
HQRA-6CL (H2)
0.1-1%*
DO NOT SHARE WITH OTHER LOADS
HE TRIM
(DO NOT
RECOMMEND 6NA)
various controls manufacturers to
DO NOT USE ADAPTIVE PHASE
CONTROLS
HE TRIM
HOMEWORKS:
HxD-6ND
HW/LP RPM -4U-120 †
0.1-1%*
RADIO RA2:
RRD-10ND
RRD-6CL(R3)
0.1-1%*
(DO NOT
RECOMMEND 6NA)
HE TRIM
GRAFIK EYE QS:
QSGRJ-3P
QSGRJ-4P
QSGRJ-6P
0.1-1%*
HE TRIM
GRAFIK EYE 3000:
HWI-WPM-6D-120
0.1-1%*
HE TRIM
STANZA:
SZ-6ND
0.1-1%*
HE TRIM
PHPM-PA
FORWARD-PHASE ONLY
PHPM-PA-120-FP-WH-CPN6366
PHPM-PA-DV-FP-WH-CPN6366
0.1-1%*
HE TRIM
USE WITH UP & RP
PHPM-WBX
0.1-1%*
HE TRIM
may recommend setting LE Trim
PANEL MODULE:
GP (Harrier) Card
0.1-1%*
HE TRIM
higher to increase start time when
CASETA WIRELESS:
PD-6WCL (SD11)
0.1-1%*
HE TRIM
necessary.
† (DO NOT RECOMMEND
RPM-4A) DO NOT SHARE WITH OTHER
LOADS
ETC
D20AF
0.1%
Forbes &
Lomax
ROTARY DIMMER :
FLRLV603-P
0.1%
Vantage
STANDARD DIMMER MODULE
SDM12-EM
0.1%
HE TRIM
WIRELINK SCENEPOINT
DIMMER:
DS15TE-AWYA
0.1%
HE TRIM
RADIOLINK SCENEPOINT
DIMMER:
RD15TE-AWYA
0.1%
HE TRIM
Crestron
GLX-DIM6
0.1%
HE TRIM
Le Grand
ADORN:
ADTP703TU(W4)
0.1%
HE TRIM
ADORN WIRELESS:
ADTG700MMTU(W2)
0.1%
HE TRIM
Low-end dimming minimum threshold
varies by control and can be set when
programming trim levels.
Use high-end trim (HE Trim) to
eliminate dead travel, set low trim to
lowest level dimmer will allow.
*Lowest dim levels achieved with little
or no LE Trim. Dimmer manufacturers
SENSOR RACK
Component of a complete system including: Aion LED A-Track Light Engine, Aion LED A-Track housing with diffuser lens, & Aion LED driver (power supply). Dimmer
not included. Approved dimmers, controls, power supplies, cable, & other components only. Contact Aion LED for questions regarding compatibility. Electrician
installed. Strictly adhere to NEC & local building code. Limited 5-year warranty against manufacturing defects only, does not cover labor; voided by: inadequate
ventilation, field modifications, installation by unqualified personnel, unapproved controls, drivers, cabling, other devices, not following installation guidelines & protocol,
general negligence. Installer assumes all liability with regard to property & safety. This product is UL listed. See separate “Aion LED Warranty Terms” & additional
instructional materials for more information. Authorized installers only. Systems tested prior to shipping.
AIONLED.COM | (415) 255-AION
Modified: September 11, 2017
© 2017 Aion LED. All Rights Reserved
Download PDF
Similar pages