Cup-Warmer - Santa Lucia Estate Coffee

English
English
Daily Switch-On
!
“Before switching on the machine, ensure the
following:
The mains switch is on.
The water mains tap is open”.
Turn the master switch (1) to position 1. The indicator light
“machine on” (5) switches on.
If the water level in the boiler is less than the minimum
required, the boiler is filled up to the correct level.
Turn the master switch (1) to position 2.
“Heating” now begins.
At the end of the day, turn the machine OFF by turning the
main ON/OFF switch (1) to position 0.
5
1
Cup-Warmer (when provided)
Place only coffee cups, cups and glasses to be used in
conjunction with the coffee machine on the cup-warming
plate.
Ensure that the coffee cups are completely drained before
placing them on the cup-warming plate.
No other objects shall be placed on the cup-warming plate
(11).
Press the button (12) and check to see that the light turns on.
11
12
Heating phase
During heating, if one of the coffee dispensing push buttons
is pressed, the machine dispenses a coffee at the
temperature reached at the time.
18
18
Heating is completed when the boiler gauge indicator (14)
remains stable in the green area.
The machine is now ready to dispense coffee, steam and
hot water.
10
To make sure that the dispenser unit and the filter holder
(10) are at similar temperatures, press the coffee dispensing
push button (18) and let the machine dispense coffee for a
few seconds. Then press again the push button (18) to stop
dispensing.
14
30
10
English
English
Delivery of the coffee
Remove the filter holder (10), empty out any coffee grouts
and fill it up with 1 or 2 servings of ground coffee, depending
on the filter holder used.
Press the ground coffee in filter down uniformly, using the
grinder/doser presser.
Remove any residues of ground coffee from the filter rim.
Fit and tighten the filter holder (10) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (10).
Press the coffee dispensing push button (16, 17, 19, 20) for
the required serving; the machine will stop automatically.
Press the push button (18) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by pressing
the STOP push button (18).
16
10
17
18
19
20
10
Steam dispensing
Completely immerse the right or left steam nozzle (6) into the
container with the liquid to be heated and push the steam
control lever (7) upwards.
Wait until the liquid has reached the desired temperature,
then lower the steam command lever (7) to stop the issue of
steam.
7
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
6
Hot water dispensing
DOSED FUNCTION
After having positioned the appropriate container under the
hot water nozzle (8), raise the hot water dispensing lever (9):
afterwards, the lever automatically returns to the original
position. The hot water will be dispensed and will stop
automatically.
The water can be interrupted at any time by raising the hot
water lever again (9).
9
8
31
Download PDF
Similar pages