Safety First!
Hints for Great-tasting Coffee
When using electrical appliances, basic safety precautions should always be
followed to reduce the risk of fire, electrical shock and/or personal injury.
1. A clean coffee maker is essential for making great-tasting coffee. Regularly
clean the coffee maker as specified in the Cleaning and Maintenance
section. Always use fresh, cold water in the coffee maker.
2. Store unused ground coffee in a cool, dry place. After opening a package of
ground coffee, reseal it tightly and store it in a refrigerator to maintain its
3. For an optimum coffee taste, buy whole coffee beans and finely grind them
just before brewing.
4. Do not reuse ground coffee since this will greatly reduce the coffee’s flavour.
Reheating ground coffee is not recommended as coffee is at its peak flavour
immediately after brewing.
5. Clean the coffee maker when over-extraction causes oiliness. Small oil
droplets on the surface of brewed, black coffee are due to the extraction of
oil from the ground coffee.
6. Oiliness may occur more frequently if heavily roasted coffees are used.
• Read all the instructions carefully before using this appliance and keep them
for future reference.
• Retain the manual. If you pass the appliance on to a third party, make sure to
include this manual.
• Make sure that your outlet voltage corresponds to the voltage stated on the
rating label of the appliance.
• Unplug the appliance from the mains socket when not in use, or before
cleaning any part of the appliance.
• Do not operate any appliance with a damaged mains cable or mains plug, or
in an abnormal state. If the mains cable is damaged it must be replaced by
the manufacturer, its service agent, or similarly qualified persons in order to
avoid a hazard.
• Do not use an extension cable, it may result in fire, electrical shock and/or
personal injuries.
• Do not let the mains cable hang over edge of the table or counter, or touch hot
• To disconnect, remove the mains plug from the mains socket. Never pull the
mains cable to remove the mains plug from mains socket.
• Do not immerse the appliance, mains cable or mains plug in water or other
• Be careful not to get scalded by the steam.
• Use handles or knobs only. Accessible surfaces may get hot.
• Do not touch the appliance whilst in use as there are hot surfaces on this
• Never use the appliance if the jug shows any signs of cracks. Only use the jug
supplied with this appliance. Handle the jug with caution as it is very fragile.
• Never leave an empty jug on the warming plate otherwise the jug is liable to
• Never switch your appliance on without water in it.
• Stand the appliance on a stable flat surface before use.
• This appliance is intended for household use only. Do not use outdoors.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
Remove all packaging from the coffee maker. Retain the packaging. If you
dispose of it please do so according to any recycling regulations.
The packing includes
• The coffee maker appliance
• Jug (Part number: XQ685T, 35-44)
• Funnel (Part number: XQ685T, 55-59)
• Filter (Part number: XQ685T, 35-44)
• Instruction Manual (Part number: XQ685T-1)
If items are missing or damaged, please contact Partmaster (UK only)
Tel. 0870 6001 338 for assistance.
Unit not working
No coffee dripping into
the jug
Possible Causes
Fuse blown
Check plug fuse
Nozzle blocked on funnel
Clean nozzle
Coffee goes cold after
a short while
Water will not heated up
Coffee maker is not
plugged in
Fuse blown
Connect coffee maker to
the mains socket
Check plug fuse
Mains supply: 230V~50Hz
Power consumption: 1000W
We continually strive to improve our products, specifications may change without
prior notice.
This symbol on the product or in the instructions means that
your electrical and electronic equipment should be disposed at
the end of its life separately from your household waste. There
are separate collection systems for recycling in the EU.
For more information, please contact the local authority or your
retailer where you purchased the product.
Visit today for the easiest way
to buy electrical spares and accessories.
With over 1 million spares and accessories available
we can deliver direct to your door the very next day.
Or call
0870 6001 338
(UK customers only)
Calls charged at National Rate.
DSG Retail Ltd. Maylands Avenue Hemel Hempstead
Hertfordshire HP2 7TG England
GB - 1
GB - 5
Instruction Manual
Knowing your Coffee Maker
Tank cover
Water tank
Funnel support
Control panel
Jug lid
Open lid button
Making Coffee Immediately (Cont.)
Funnel Assembly
7. Do not open the tank cover when the coffee maker is operating. This will
result in hot splashes of water.
• Water will overflow if funnel is not locked firmly and properly.
• The funnel should not move when locked properly.
8. You can remove the jug to serve when brewing is finished (about one
minute after the coffee stops dripping into the jug.)
Note: The amount of coffee you get will be less than the water you have
put in the tank, as some water is absorbed by the ground coffee.
9. Always turn the coffee maker off and unplug the mains cable from the
mains socket when the coffee maker is not in use.
The brewed coffe in the jug and the grounds in the filter are very hot.
Handle them with care to avoiding scalding.
Using for the first time
Automatic Start Function
Fill the tank with clean water up to the maximum lever 10, follow the steps in
Making Coffee Immediately (without adding ground coffee) once or twice,
then pour out the hot water. Clean the jug, lid and funnel thoroughly with
warm water. You may now use your coffee maker making coffee.
If you do not want the coffee maker to start immediately, for example it is
now 8:10 am, and you want the coffee maker to automatically start at
1:00 pm, first follow steps 1 to 5 in Making Coffee Immediately, then set the
automatic start function as follows:
Making Coffee Immediately
1. Open the tank cover of the coffee maker and fill with the correct amount
of water into the tank. The water level should not exceed the maximum
lever 10.
2. Add ground coffee into the filter. Usually a cup of coffee needs a level
spoonful of ground coffee, but you may adjust according to your taste.
3. Place the filter with the ground
coffee in the funnel. Then place
them into the funnel support of
the coffee maker, making sure
it is assembled correctly, see
Funnel Assembly for details.
4. Place the jug on the warming plate horizontally.
5. Plug the mains cable into the mains
socket, the LCD will display 12:00
(see Control panel).
1. Press PROG button, the LCD will display CLOCK.
Set the current time by pressing the HOUR and
MIN button (Fig.1).
Note: The time cycle is 24 hours. Select desired
time by pressing the HOUR and MIN button
2. Press PROG button again, the LCD will display
TIMER, then set the automatic start time by
pressing the HOUR and MIN button (Fig.2).
3. Press ON/OFF button twice, the AUTO indicator will be illuminated in
green. The LCD will display the current clock after about 10 seconds, you
may see the automatic start time by pressing PROG button.
You may cancel the automatic start function by pressing ON/OFF
button. If you want to change the automatic start time, repeat the
above 1-3 steps again.
At 1:00 pm, the AUTO indicator will be extinguished, and the RUN
indicator will be illuminated in red. The appliance will then start automatically. After brewing, you can replace the jug on the warming plate. Whilst
the coffee maker is connected to the mains, the coffee can be kept warm.
6. Press ON/OFF button, the RUN indicator will be illuminated in red.
The appliance will begin working.
Note: You can remove the jug, pour and serve at any time once the
coffee is made. The coffee maker will stop dripping automatically. The
jug must be replaced within 30 seconds.
GB - 2
Locate the tabs on the funnel
and lower the funnel into the
coffee maker with the handle
As a safety concern, keep the lid of the jug closed when pouring. This
can also keep the coffee warm.
Jug handle
Warming plate
With the tank cover open,
locate the slot on both sides
of the coffee maker.
If the coffee maker is left unattended for 2 hours, the power will be cut
off automatically.
GB - 3
Firmly press the funnel into the
coffee maker till the tabs lock
under the slots, while holding
the handle upright.
Lower the handle down.
Cleaning and Maintenance
Be sure to unplug this appliance before cleaning. To protect against
electrical shock, do not immerse the mains cable, mains plug or the
appliance in water or liquids. After each use, always make sure the
mains plug is first removed from mains socket.
1. Clean the filter, jug and jug lid after each use in hot, soapy water.
2. Wipe the appliance’s exterior surface with a soft, damp cloth to remove
stains. Do not use strong detergent or aggressive cleaners.
3. Water droplets may build up in the area above the filter and drip onto the
product base during brewing. To control the dripping, wipe off the area with
a clean, dry cloth after use.
4. Use a damp cloth to gently wipe the warming plate. Never use abrasive
cleaner to clean it.
Cleaning Mineral Deposits
To keep your coffee maker operating efficiently, you should clean away the
mineral deposits left by the water regularly depending on the water quality in
your area and the frequency of use.
Fill the jug with one part of white vinegar and three parts of cold water. Then
pour the water and vinegar mixture into the tank (do not place any coffee
ground in the appliance), heat the water-vinegar solution as per Instruction
Manual, repeat it until no yellow liquid comes out, then pour out the mixture,
rinsing with tap water until no vinegar odor is left.
GB - 4
Download PDF
Similar pages