ROUND COFFEE TABLE
Thank you for purchasing our Round Coffee Table.
Assembly of this product requires a Phillips screwdriver
and a 7/16” wrench.
2258
STEP 1
Read through these instructions
thoroughly. We have found this to be of
great value when first assembling this
product.
STEP 2
Remove all parts and hardware from
packing material. Place wooden parts on
non-abrasive surface (like carpet or
carton) to prevent damage to finish.
Identify all parts using diagram at right.
STEP 2
(A) Top
(B) Shelf
(C) Leg w/Hanger Bolt (4x)
STEP 3
Identify and count hardware using
diagram at right.
Assembly of this product requires
a Phillips screwdriver and a 7/16”
wrench.
STEP 4
Attach Leg (C) to Shelf (B) by
threading Leg attached hanger bolt
through countersunk hole in Shelf (B)
and into one of the predrilled holes
along the edge of Shelf (B). Fasten with
washer and lock nut. Repeat this step
until all four Legs (C) have been
attached.
STEP 5
Turn assembled Legs (C) and Shelf (B)
upright so that holes in the ends of each Leg
(C) are facing up.
STEP 6
Attach Metal Bracket to the top of ALL
Legs (C) by inserting 1 1/2” #8 Screws
through center hole of Metal Brackets, and
into predrilled hole in the top of Legs (C).
Repeat for each Leg (C).
Note: Ensure each Metal Bracket sits at a
90-degree angle on the Leg (C) before fully
tightening the screw. Refer to the photo to
the right for the proper placement of the
Metal Bracket.
STEP 7
Place Top (A) face down on non-abrasive
surface (carpet or carton) so that the inlays
and holes are facing up as shown in photo to
the right.
STEP 8
Place assembled Legs (C) and Shelf (B)
facing down on Top (A) where Metal
Brackets insert into inlays on Top (A).
Fasten 1/2" #8 Screws through Metal
Bracket holes into predrilled holes on Top
(A).
CARE
Dust as needed with soft cloth. Clean with
damp cloth and mild solution of dish soap.
Polish with soft cloth and polish that
contains no pigment or silicone.
www.manchesterwood.com
Product Support 1-800-660-6930
Download PDF
Similar pages