1
2
INSTRUCTION MANUAL
LITHIUM-ION POLYMER MINI JUMP STARTER (KIT SET)
SC POWER SCB15
Technical Specifications SCB15
Battery Type: Lithium-Ion Polymer
Battery Capacity: 1500 mAh (12V DC)
Crancking Ampere: 150 A
Peak Current: 350 A
USB 2.1 Outlet: 5V@2.1A Maximum
Super Bright LED: Yes
Optional Data back up: No
Gasoline Vehicle Application: crank up to 1.2 liters
Operating Temperature:
l
-20°C to + 45°C
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. MAKE CAREFUL
NOTE OF SAFETY INSTRUCTIONS, WARNINGS & CAUTIONS.
l
THIS PRODUCT SHOULD ONLY BE USED FOR ITS INTENDED PURPOSE. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY CAUSE DAMAGE AND/OR PERSONAL INJURY.
l
PLEASE KEEP THIS INSTRUCTION MANUAL FOR FUTURE USE.
l
PLEASE FULLY CHARGE THIS PRODCUT BEFORE INITIAL USE AND RECHARGE EVERY 3 MONTHS
FOR MAINTAINING GOOD BATTERY LIFE IF NOT USED REGULARLY.
l
DO NOT STORE THE DEVICE IN DAMP OR WET LOCATIONS OR WHERE THE TEMPERATURE MAY
BELOW 3
OR EXCEED 40 .
WARNING! RISK OF EXPOSIVE GASES. Working in the vicinity of a LEAD ACID battery is
dangerous because it can generate gases. It is important to remember that batteries generate
explosive gases during normal operation.
1 /9
JUMPSTARTERSCPOWERSCB15
1
2
ATTENTION!
Neglecting the instructions & cautions below might cause personal injury and harm or influence
the function of the device.
CAUTION:
- Use the device exclusively for those purposes for which it has been developed.
- Do not use the device under the rain or in damp conditions. The functionality of the device
might be affected.
- Keep the device away from inflammable material.
- Always make sure the device is properly used and safely stored.
- Keep the device away from children & infirm access.
- Do not expose the device directly to solar radiation and / or other sources of heat.
- Never throw or drop this product to avoid causing damages.
- The appliance is not intended for use by people (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction. Children should be supervised to ensure that they do not play
with the appliance.
- If you do not plan to use the product, please disconnect the DC connector of the universal
adaptor from the Mini Jump Starter. The Mini Jump Starter will change to power save mode to
conserve the battery.
- Never attempt to alter or disassemble the product. If there is any problem with the product
please contact your dealer or place of purchase for further assistance.
- Repairs and maintenance may only be accomplished by authorized specialists, who are familiar
with the dangers/ regulations which go along with this equipment.
- The Mini Jump Starter must be recharged every 3 months for maintaining good battery life if not
used regularly.
2 /9
JUMPSTARTERSCPOWERSCB15
1
2
SCB15 PACK CONTENT
Main unit
L158 X H48.5 X D85mm
ACCESSORIES INCLUDED:
AC/DC Adapter
Booster Cable
Carry Bag
In Car Charger
Charging the device
1.
Charge via AC adapter
2.
Charge via DC charger
a)
a)
Connect the AC adapter to the 12VDC input of the device.
b)
Attach the adapter to AC mains, the adapter will
automatically commence charging the battery.
Connect the charger to the 12VDC input of the device.
b)
Attach the DC charger to car lighter socket. The red light of the
DC charger will light on and the charge will automatically
commence.
c)
3 /9
JUMPSTARTERSCPOWERSCB15
1
2
Charging indication
Capacity Spectrum
Please refer to the table of light indication for
showing the charge status and the battery
capacity (shown on right).
Green light on
81%—100%
Yellow light on
61%—80%
Orange light on
41%—60%
Red light on
21%—40%
Red light flashing
20% below
LED process for charging
Red (flash) → Red (on) → Orange (flash) → Orange (on) → Yellow (flash) →Yellow (on) → Green (flash) → Green (on) →
Completed
ATTENTION
Recharge the device immediately if the red light of the battery indicator is flashing.
ATTENTION!
1. USE ONLY THE AC TO DC ADAPTER AND THE DC CHARGER INCLUDED IN THE PACKAGING. NEVER
TRY TO ATTEMPT TO USE OTHER CHARGING UNITS, OTHERWISE THE BATTERY MIGHT BE
DAMAGED.
2. DO NOT CRANK THE CAR WHEN CHARGE IS ON PROCESS. OTHER FEATURES, SUCH AS USB
OUTPUT CAN BE USED DURING THE CHARGING PROCESS.
3. ONCE THE CHARGE IS FINISHED, PLEASE DISCONNECT THE CHARGER FROM THE POWER SOURCE
AND DETACH THE DC PLUG FROM THE DEVICE.
4. THE DEVICE IS PROTECTED FROM EXTREME TEMPERATURE, SO IT IS NOT RECOMMENDED TO
OPERATE AT AMBIENT TEMPERATURE LOWER THAN -20 OR HIGHER THAN +45 . IN FACT THE
OPERATION MAY NOT BE ACTIVATED OR MORE CRANK ATTEMPTS MAY BE NECESSARY.
MOREOVER, THE CHARGING PROCEDURE WILL NOT START IF THE TEMPERATURE OF THE
BATTERY PACK IS EXCEEDING THE RANGE FROM 3 TO 40 .
5.
MALFUNCTION – BATTERY INDICATOR WILL BE FLASHING SIMULTANEOUSLY AS PROTECTION
CIRCUIT HAS BEING ACTIVATED. PLEASE FIX THE PROBLEM BEFORE TURN ON THE DEVICE AGAIN.
4 /9
JUMPSTARTERSCPOWERSCB15
1
2
CONDITION BEFORE USE
Ensure the below conditions are guaranteed before pressing the JUMP START button.
1.Ensure the capacity of the battery is full.
3.Ensure the contact terminals of the car battery are clean.
Jump Start can only be used when the spectrum lights
up to GREEN or YELLOW.
Erase any corroded substance from battery terminals and ensure
correct contact point at the clip. Please note that the battery
terminals must be properly connected before pressing the JUMP
START button.
4.Ensure the cable is properly wired and well connected.
Jump Start can’t be used when the spectrum of
ORANGE, RED light is illuminated or RED light is
Detach by removing the plug only & DO NOT pull the cable to
flashing, fully charge the device immediately.
detach it from the device.
2.Ensure the polarity is properly connected.
DO NOT bend the cable when carrying the device.
Indication:
In case of reversed polarity, the battery indicator will be
will be flashing simultaneously once the power is turned
on.
5 /9
JUMPSTARTERSCPOWERSCB15
1
2
ILLUSTRATIONS:
Front Panel
Left side panel (DC jack for charging)
Right side panel (Booster terminal & side light)
6 /9
JUMPSTARTERSCPOWERSCB15
1
2
OPERATION OF CAR CRANKING
Step 1
Step 2
Connect the Battery.
Press power button for 1 second to turn the device on.
Attach the red positive clamp (+) to the positive (+) battery
Fully charged condition as indicated on left is important
post, then attach the black negative clamp (-) to the car
for cranking the car successfully.
chassis or to the negative pole of the battery.
Indication:
Jump Start can only be used when the spectrum lights up to
GREEN or YELLOW.
Step 3
Step 4
Cranking the car.
Cranking up the car then turn power off.
Once the car engine has started, press power button again to
turn the power off.
Remove the clips (negative clip first) from the battery as soon
as possible.
Press JUMP START button to turn on the JUMP START
function.
Indication:
JUMP START red light is on.
Note: Red light is flashing, the voltage of car battery is too
low or it is short circuiting or dead.
7 /9
JUMPSTARTERSCPOWERSCB15
1
2
ATTENTION!
1.
The activity of engine cranking will last for 4 seconds and the device will automatically cut the power off. If the vehicle has not
started within this time, wait for 15 seconds and repeat again. (Maximum 5 cranking attempts are recommended, otherwise
the device might be damaged.)
2.
Once the car engine has successfully started, please press the power button to turn off the device A.S.A.P.
3.
Always re-charge the device after use and/or make sure it is fully re-charged before use.
4.
In case of reversed polarity or if you try to crank an engine exceeding its capability, the device will be automatically protected
and all functions will be terminated. The red LED of Jump Start will flash. Please turn off the device immediately and try the
next attempt until the conditions are clear.
OPERATION OF CAR WITH A WEAK BATTERY (EXTREMELY LOW VOLT.)
Indication: Jump Start red light is flashing
Power on the Mini Jump Starter. To energize the output manually, hold the Jump Start and Weak Battery Jump Start
simultaneously for 3 seconds. The Jump Start light is flashing and the clamps will be live in this condition. Please make sure
the polarity is properly connected before these 2 buttons are pressed, otherwise the device will be severely damaged. Turn the
vehicle’s starter over until the engine starts, the device will turn off after cranking for 4 seconds. If the vehicle has not started
within this time, wait for 15 seconds and repeat again. (Maximum 5 cranking attempts are recommended, otherwise the device
might be damaged.)
ATTENTION:
1.
Once the car engine has successfully started, please press the power button to turn off the device A.S.A.P.
2.
The device will automatically shut down when idled for 2 minutes.
3.
Always re-charge the device after use or have it fully re-charged before use.
4.
Even though the device has a protection, please avoid trying to crank an engine exceeding its capability.
5.
In case the operation on a car with a weak battery has failed and Jump Start red light is flashing, the car battery is short
circuiting or dead. Please replace the battery as soon as possible or get in contact with a professional engineer to
examine the car.
8 /9
JUMPSTARTERSCPOWERSCB15
1
2
SIDE LIGHT
Press SIDE LIGHT BUTTON to turn it on. The light must be turned off after use, otherwise the battery power will be depleted.
5V USB PORT
Connect the electronic appliance to the USB port of the device and turn the power on. It can deliver 5.0VDC 2.1A to power up
most 5VDC input digital devices like mobile-phone, tablet PC as well as other 5V USB products. ( Original cable is required for
delivering maximum current )
Recommendation:
l
If it is anticipated that the Jump Starters is to be used in very cold conditions, it is recommended that it is kept indoors in a
warm environment. Furthermore, it is recommended that to keep the device on charge for overnight prior to use. It is also
recommended that when preparing for a Jump Start in extremely cold weather that you connect the clips to disabled
vehicle battery and turn the POWER on, then activate the JUMP START feature by depressing the Jump Start button
(JUMP START red light on), then wait for 3-4 minutes prior to cranking the vehicle. This will help activate or “warm” the
disabled vehicle battery for best possible results.
l
Sometimes it may happen that the car engine does not start at the first crank, so we recommended to take several attempts
(no more than 5), so that the battery is warmed up and its performances result enhanced.
l
To grant the best possible performance of the device, it is recommended to recharge it every 3 months, or to refresh it at
least one time within 6 months. If the battery is not fully recharged after use and not regularly charged at the above stated
intervals, the device will not operate properly and may quickly deteriorate.
l
The device is protected from extremely high temperatures, anyway it is not recommended to store it inside the car
compartment during summer time, and recharge it at high ambient temperature. (Please refer to page 4 at point 4 of this
user manual).
9 /9
JUMPSTARTERSCPOWERSCB15
Download PDF
Similar pages