I T V WAT E R F I LT R AT I O N S Y S T E M
Water quality plays an important role in food service. Not only does water quality determine the taste and quality
of all beverages served, it also has a dramatic effect on equipment performance, maintenance costs and equipment
longevity.
ITV Water Filtration systems provide high quality water resulting in:

Better ice and beverage quality.

Lower equipment maintenance costs.

Longer and more effective equipment operation.
ITV Water Filtration Systems remove:
SEDIMENT: Found in most water supplies contributing to cloudy water and equipment issues.
CHLORINE: Imparts an unpleasant taste and odor in water reducing the quality of beverages served. Also causes
evaporator and auger “pitting” and bin corrosion.
ITV’s Water Filtration Systems also address the first cause of equipment issues – mineral scale deposits that decrease productions and greatly increase equipment maintenance costs.
ITV filters deliver a specially formulated scale control product that is proven most effective in controlling mineral
scale especially in high water hardness environments. Unlike most competitive systems, ITV’s scale control product
is also delivered at a consistent rate ensuring predictable periods of mineral scale control resulting in mineral scale
protection for entire time between filter replacements.
CS - 101 K
CS - 112 K
CS - 102 K
CS - 111 K
ITV RECOMMENDATIONS
CS-101 K
CS-111K
Up To 250 Lbs./ 10,000 Gal. Up To 400 Lbs./ 15,000 Gal.
CS-102 K
CS-112 K
Up To 700 Lbs./ 20,000 Gal.
Up To 2,900 Lbs./ 30,000 Gal.
ALFA NDP 55
44 lbs.
ALFA NG 265
270 lbs.
ICE QUEEN 500
675 lbs.
ICE QUEEN 900
980 lbs.
ALFA NG 75
64 lbs.
ALFA NG 355
352 lbs.
SPIKA MS 440
494 lbs.
ICE QUEEN 1300
1,430 lbs.
1,430 lbs.
ALFA NG 95
95 lbs.
GALA NG 355
332 lbs.
ICE QUEEN
1300R
ALFA NG 135
130 lbs.
ICE QUEEN 300C
360 lbs
ICE QUEEN 2700
2,860 lbs.
ALFA NG 175
170 lbs.
ICE QUEEN 300
360 lbs.
ICE QUEEN
2700R
2,860 lbs.
GALA NG 75
59 lbs.
SPIKA NG 285
312 lbs.
SPIKA MS 880
GALA NG 95
90 lbs.
GALA NG 135
121 lbs.
GALA NG 175
158 lbs.
GALA NG 265
242 lbs.
IQ 100 C
95 lbs.
IQ 200 C
220 lbs.
SPIKA NG 125
143 lbs.
SPIKA NG 175
214 lbs.
SPIKA NG 215
239 lbs.
970 lbs.
I T V WAT E R F I LT R AT I O N S Y S T E M
USE DIRECTIONS
Do not use with water that is microbiologically unsafe or unknown quality without adequate disinfection before or
after the system.
Unit should be installed in compliance with state and local laws and regulations.
Install System in Cold-water line only. Water temperature must not exceed 100F
(37C).
Do not solder plumbing connections when attached to the filter head or manifold as the heat will damage the filter
head and/or valve components.
Do not over-tighten fittings into filter connections. Always use a back up wrench when making connections when
applicable.
Mount the system where the filters are easily accessible for filter replacement. Do not mount the system over
electrical wiring or where water may cause damage.
Recommended filter replacement is once, on average, every six months, depending on water quality which could
cause need for replacement sooner.
Position the filter system where the filter cartridges can be easily reached in order to facilitate filter change out.
Ensure that there is at least 3” inches of clearance below the filter cartridges to allow the filter change.
Rated Capacity Rated Service Flow Oper. Pressure
Oper. Temperature
Gal./ l.
Rate gpm./ cfs. Min - Max Psi./bar. Min - Max ⁰F/⁰C
Conn. Size
Inch./mm.
CS-10
10,000/37,900
1.75/0.003
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
REPLACEMENT CARTRIDGE
10
CS-11
15,000/56,850
2.00/0.004
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
REPLACEMENT CARTRIDGE
10
CS-101 K
10,000/37,900
1.75/0.003
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
3/8”/ 94
CS-10
10
CS-111 K
15,000/56,850
2.00/0.004
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
3/8”/ 94
CS-11
10
CS-102 K
20,000/75,800
3.50/0.007
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
1/2”/ 125
(2) CS-10
10
CS-112 K
30,000/113,700
4.00/0.008
20-125/1.4-8.6
35-100⁰F/1.5-38⁰C
1/2”/ 125
(2) CS-11
10
Model Number
Replacement
Cartridge
Micron
Rating*
Single Kits include single head with manifold/bracket, and Twin Kits include a manifold with
pressure gauge and one 1/2" plastic ball valve. Both Kits are available in the 10” (CS-10) or
16” (CS-11) cartridges depending on the ice machine daily production.
* Not Performance Tested by NSF
ITV ICE MAKERS, INC.
3325 NW 70th. Ave. Miami, FL 33122-1332
Ph. +1 786 369 7480. Ext. 2031
Fax. +1 786 369 7481
Toll Free. +1 888 ITV 1 ICE (+1 888 488 1423)
sales@itvice.com
service@itvice.com
www.itvice.com
Download PDF
Similar pages