S U B - Z E R O W I N E S TO R AG E U S E & C A R E
CLEANING
CONDENSER CLEANING
C O N D E N S E R L O C AT I O N
Clean the condenser area every three to six
months. The cleaning schedule will depend on
the amount of dust and lint that accumulates
in this area.
Models 424 and 424FS: On these models the
condenser is located behind the kickplate. First,
remove the kickplate to expose the condenser
area. Refer to the illustration below.
To access the condenser on your specific Wine
Storage model, see Condenser Location. Use a
soft bristle brush and vacuum hose to remove
dust and lint from the condenser area. NOTE:
To avoid bending the condenser fins, be sure
to vacuum in the direction of the fins (up and
down).
Models 427 and 427R: On these models the
condenser is located behind the kickplate / grille.
Remove the screws holding the kickplate / grille.
This assembly will slide forward easily, giving
you access to the condenser area. Refer to the
illustration below.
Before cleaning the condenser, shut the
electricity off at the control panel. When
you clean the condenser, wear gloves to
avoid injury from the sharp condenser fins.
Failure to clean the condenser could
result in temperature loss or mechanical
failure or damage.
Model 430: The condenser is located behind
the grille at the top of the unit. To remove the
louvered grille, first open the door to access
three Phillips head screws. Remove the three
grille screws. Tilt the grille forward at the top
and release the springs from behind the grille,
and then lift off the grille. Refer to the illustration below.
To remove a panel grille on Model 430, lift the
grille up, then pull out at the bottom and down
to release it from its mounting bracket.
Grille Springs
Grille
Screws
(inside door)
Kickplate
Condenser location – Models 424
and 424FS
16
Condenser location – Models 427
and 427R
Condenser location – Model 430
Download PDF
Similar pages