IceAssure® Water Filtration Systems Product Features

IA3
Application
IceAssure® Water Filtration Systems
• Ice Machine Equipment
Spec No. _________________________________________________
Quantity _________________________________________________
Product Features
1/2” NPT inlet and outlet with 1/2” to 3/8”
bushing for easy connection to existing piping.
Valve-in-head design simultaneously shuts off
and vents water with 1/4 turn, allowing for
simple and trouble-free cartridge change outs.
SQC™ - Sanitary Quick Change encapsulated
design reduces contamination during changeouts and are disposable and incinerable.
IceAssure 3 systems supply a continuous
flow of water to equipment during cartridge
change-outs.
Unibody manifold provides higher flow rates
and gallon capacities for high water usage
applications.
Pressure gauge with red follower needle
allows the filter pressure to be monitored and
indicated when the cartridges are reaching
the end of their service life.
IceAssure 3
FDA CFR-21 and/or NSF compliant materials
provides peace of mind that this product is
suitable for potable applications.
IceAssure® water filtration systems are designed to reduce service calls associated with sediment, chlorine taste
and odor, and scale build-up in commercial ice cubers and flakers. Premium activated carbon reduces chlorine
that may cause corrosion and the chlorine smell commonly found in the ice bin. Built-in scale inhibitor reduces
the ability of calcium and magnesium to precipitate on the evaporator plates as hard scale. The filtration media
reduces sediment particles that can clog solenoid valves and distribution tubes. Two filtration media technologies
address varying water conditions.
Product Specifications
Model
Number
Part
Number
Reduction
Claims
Micron
Rating
IA3-1
55967-01
1
IA3-5
55967-02
Sediment,
Chlorine,
Scale
5
Capacity
30,000 gallons
(113,562 liters)
14,400 gallons
(54,510 liters)
Service
Replacement
Application
Qty
Flow Rate
Cartridge
4.5 gpm
(17 lpm)
Standard
Water
High
Turbidity
CFS8112-S
3
CFS8720-S
3
Visit www.nsf.org for the
claims associated with
products that are NSF listed.
Sizing
Low flow cubers over 1,400 lbs (635 kg)
High flow cubers to 1,350 lbs (612 kg)
Flakers over 2,400 lbs (1,089 kg)
Spec No. _________________________________________________
IA3
IceAssure® Water Filtration Systems
Quantity _________________________________________________
Model Number ____________________________________________
Part Number ______________________________________________
Physical Specifications:
13 1/8"
(33.3 cm)
• System to incorporate a unibody manifold design.
• Each individual filter head to incorporate an internal automatic
1/4 turn shut-off valve.
• System must supply a continuous flow of water to equipment
during cartridge change-outs.
• System to be manufactured from FDA CFR-21 and/or NSF
compliant materials.
• System to carry an NSF Performance Data Sheet*.
• Filter cartridges to be non-activation type.
• Filter cartridges to be double o-ring seal type.
• Cartridges to have a built-in, time released scale inhibitor.
• Cartridges to incorporate a graded density, multi-composite
carbon block or granular activated carbon.
• System to have a built-in pressure gauge.
• System to have a maximum operating pressure of 125 psi (862
kPa) and operating temperature of 100°F (38°C).
18 3/16"
(46.2 cm)
• Cartridges to be sanitary in design requiring no contact with the
filter media during cartridge change-out.
• Each system to have a ____ micron nominal particle reduction
capability.
• Each system will reduce chlorine taste and odor for ________
gallons (liters).
• System to have a service flow rate of 4.5 gpm (17 lpm).
* For NSF listed products.
Installation Tips:
• Shut off downstream equipment prior to installation of the system.
2" (5.1 cm)
Cartridge
Clearance
• Do not exceed operating parameters for temperature or pressure.
• Do not install outdoors.
• For cold water use only.
• For commercial use only.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
CUNO Incorporated recommends regularly scheduled maintenance
and replacement of the filter cartridge(s) in order for the product to
perform as advertised/sold.
Limited 5 Year Warranty
CUNO Incorporated warrants to the original purchaser-consumer that this product is free from defects in materials and workmanship. This warranty, together with any and all warranties implied
by law, shall be limited to a period of five (5) years from the date of original purchase by the consumer. This warranty does not apply to failures that result from abuse, misuse, alteration or
damage not caused by CUNO. This warranty is subject to exclusions and limitations. Please refer to the Warranty Card provided with the product for details.
China
CUNO Filtration Shanghai Co. Ltd.
No. 2 Plant East Side
Xin Miao San Road
XinQiao Town SongJiang District
Shanghai, China 201612
Australia
CUNO Pacific Pty Ltd.
140 Sunnyholt Road
Blacktown, N.S.W. 2148
Australia
Europe
CUNO Limited
21 Woking Business Park
Albert Drive
Woking, Surrey
GU21 5JY, England
Japan
CUNO K.K.
Hodogaya Station Building 6F
1-7, Iwai-Cho, Hodogaya-Ku
Yokohama 240-0023, Japan
Brazil
CUNO Latina Ltda
Rua AMF do Brazil - 251
18120 Mairinque-SP, Brazil
Singapore
CUNO Filtration Asia Pte Ltd
18 Tuas Link 1
3rd Floor
Singapore 638599
© 2003 CUNO Incorporated
LITFS210 0603
CUNO Incorporated
400 Research Parkway
Meriden, CT 06450, USA
Toll Free: 1-888-218-CUNO
Worldwide: 203-237-5541
Fax: 203-238-8701
www.cunofoodservice.com • www.cuno.com
Download PDF
Similar pages