LED
15710
WARNINGS AND SAFETY PRECAUTIONS
LED MINI STEP LIGHT
CAUTION: For your safety and proper operation of this fixture, read instructions
carefully before you start. Note and understand all safety information in bold print.
r_�'\
IMPORTANT SAFETY INFORMATION
(
FOR YOUR PROTECTION, READ CAREFULLY
\
1) WARNING: RISK OF SHOCK
Electric current can cause serious injury unless handled properly. For your safety always remember to:
-Turn off the power supply at the fuse or circuit breaker box before you install the fixture.
-Turn off the power supply again when you change lamps or perform other maintenance.
-Ground the fixture to avoid potential electric shocks and to ensure reliable starting.
-Double check all connections to be sure they are all tight and correct.
-Wear rubber-soled shoes and work on a sturdy wooden ladder.
2) This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also designed
to be installed in accordance with local electrical codes. If you are unsure about the wiring,
consult a qualified electrician and check your local electrical code.
3) Account for small parts and destroy packing material, as these may be hazardous to children.
4) WARNING: RISK OF FIRE
°
Wire must be suitable for at least 60 C . Consult a qualified electrician before installing.
5) Installation environment : suitable for wet location (caulking around the face plate is required),
able to install inside power box of shelter, indoors or outdoors.
6) Installation postion : install within1.2m (4ft) of the ground.
7) This unit is to be used at AC120V 60Hz power supply only.
8) Make sure the louver always faces down when installing this fixture.
INSTALLATION INSTRUCTIONS
WARNING:
Before wiring to the power supply, turn off the electricity at fuse or circuit breaker box. Ensure grounding
to avoid potential electrical shock and to ensure reliable lamp starting. INSTALL THIS FIXTURE ONLY IN A SINGLE
GANG BOX.
PREPARATION OF LIGHT FIXTURE FOR INSTALLATION
1) Connect House Black (HOT) wire to Black (LINE) wire with connector.
Connect House White (Neutral) wire to White ( NEUTRAL) wire with connector
Connect Green/Yellow wire to Bare (ground) wire with connector
HOT (BLACv)
120V / 60Hz
1
o-------,
NEUTRAL
HITE I
GROUND(GREEN/YELLOW)
-�----
@
,.,------
@
1/
&''
GREEN/YELLOW
2) Insert Fixture into the Wall Single-Gang Box. Secured with mounting screws(2).
3) Choose either the Vertical or Horizontal Face Plate. Secure to the bracket
4) Turn Power On.
Download PDF
Similar pages