Installation and Operating Instructions
MON-DDCH60 & MON-DDCH90
60cm & 90cm DOWN DRAUGHT COOKER HOODS
(Picture shown for indicative purposes only)
Please read these instructions carefully before attempting to install or use this appliance.
It is advisable to keep these instructions in a safe place for future reference.
N.B. Should your appliance require attention, our service agents will not be able to book
a service call without your unique serial number which can be found on the last page of
this manual.
1
Introduction
Thank you for choosing this Montpellier appliance. It has been
designed to give years of trouble-free use provided it is installed and
maintained correctly.
Please read these instructions carefully before installing or using your
appliance. It is advisable to keep your purchase and installation receipts
with these instructions in a safe place for future reference. Included is
some important safety information in addition to guidelines and
recommendations that will enable you to take full advantage of all the
functions available.
This quality appliance has been tested and certified to meet all applicable
UK electrical and safety standards.
This appliance must be installed and connected in accordance with
current regulations by a qualified electrician.
After unpacking the appliance ensure that there is no visible damage. If the
appliance has been damaged during transit, do not use it, contact your
retailer immediately.
2
Your 2 year Manufacturer's guarantee
THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Your new Montpellier appliance carries a free guarantee which protects you against the cost of
repairs during the first 24 months from date of purchase provided that:
Any claim is accompanied by evidence of the model reference, model serial number and proof
of purchase, such as a Sales Receipt, showing that the appliance was purchased within the 24
months prior to the date of claim.
What is not covered under the Guarantee:










Any appliance not correctly installed and operated in accordance with the manufacturer's
instructions.
Any appliance that is used for anything other than domestic purposes.
Any defect caused by accident, misuse, unauthorized modification or inexpert repair.
Cost of Call-out where a fault cannot be found with the appliance.
Cost of Call-out for work covering routine maintenance, such as, but not exclusively,
cleaning of filters or defrosting.
Cost of Call-out for work required to correct the alignment of doors following door
reversal procedures carried out by you.
Use of the appliance by anyone other than the Householder.
Use in any commercial environment.
Consumable items, such as, but not exclusively, fuses in plugs, bulbs and breakable
items which require routine replacement.
Repair costs incurred that have not been authorised by Repairtech and/or carried out by
a non-approved Repairtech engineer.
YOUR GUARANTEE IS VALID ONLY IN THE UK.
To Register your Appliance simply complete the card in your appliance pack and return it with a stamp
affixed or Alternatively you can Register online at www.repairtechuk.com
SERVICE HELP-LINE
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133
Please remember to have all your product details available, including the model number, serial number,
date of purchase and your retailer’s details before registering a fault.
Your service call cannot progress without this information.
3
Description of the Appliance
2.
1.
1.
3.
4.
1.
2.
3.
4.
Lights
Function Control Panel
Main Body Section
Base
4
CONTENTS:
Section 1. Installation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance
Section 5. Circuit Diagram
5
Section 1. Installation
 A qualified installer MUST carry out the installation.
 N.B. To ensure that your cooker hood operates efficiently the hose
length must not exceed 2m with a maximum of one bend.
 This appliance can be used fully ‘vented’ via a ducting hose and external wall
vent, or in ‘re-circulation’ mode by using the charcoal filter provided.
 The cooker hood should ideally be installed between 65-75cm above the
work surface/cooker hob. DO NOT INSTALL BELOW 65cm.
1.
3.
2.
 Mark & cut out the aperture in the work surface as per Pic.2 above (See
Section 5. Circuit Diagram & Product Dimensions for the Technical Drawing of
MON-DDCH60 and MON-DDCH90 showing actual dimensions).
 You must ensure a minimum gap of 15mm between the rear of the appliance
and the rear wall. See Pic.1 above.
 Use adhesive/seal (as shown in Pic.3 above) and lower the hood into the
work surface cut-out.
4.
5.
6
6.
 Secure the base of the hood into the cabinet using the screws provided as
shown in Pic. 4 above.
 Connect the outlet to the main casing as shown in Pic. 5 above.
 Connect the casing to the body of the hood with the screws provided as
shown in Pic. 6 above.
 Connect the vent hose to the appliance and the wall outlet.
N.B. Your installer will supply a wall outlet and may have to supply a
suitable alternative flexible duct to suit the wall outlet.
This appliance must not share the same air outlet as another appliance,
i.e. gas heating outlet.
 The mains lead should be connected to a suitably positioned fused electrical
spur, protected by a 3amp fuse.
 Ensure that dust and debris is cleaned up from the immediate area of the
appliance prior to it being switched on and tested for the first time.
 If you intend to use the unit in re-circulation mode, i.e. without external
ventilation, you must fit & use the charcoal filter as follows:
 Remove the aluminium filter
 Position the charcoal filter to the back of the aluminium filter using the metal
strips provided (3 on MON-DDCH60 & 4 on MON-DDCH90).
 Refit the aluminium filter.
Please note that the installation of the charcoal filter may reduce the suction power of
the appliance.
7
Section 2. Safety Advice
 A qualified installer must carry out the installation.
 This appliance is manufactured and intended for DOMESTIC use only. Any
guarantee offered with the appliance is not valid for any installation in a
commercial environment.
 This appliance incorporates stainless steel. Handle with care as some of the
edges may be sharp.
 The main filter must be cleaned on a regular basis in order to help maintain
the appliance in good working order.
 Always turn off the electricity supply before cleaning the filter or the appliance
exterior.
 When replacing the bulbs or charcoal filter, ensure that you fit a ‘like for like’
replacement.
 This appliance shall not be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction on how to use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
 If the power supply cord is damaged, it must be replaced by the
manufacturer, it’s service agent or similarly qualified persons in order to avoid
a hazard.
8
Section 3. Operating the Appliance
Timer
Light
Slide Control
Fan
Power
To operate the Cooker Hood, proceed as follows:
 Press & hold the Power button for 2 seconds to raise the main body





section of the hood – the fan will operate at low speed.
Touch the Fan button to turn the fan on and/or off.
Touch the fan button to turn the fan on and then use the Slide
Control to select fan speeds 1, 2, 3 or 4. N.B. that each 2 bars of the
slide equate to 1 speed, i.e. 2 bars = speed 1, 4 bars = speed 2 etc
Touch the Light button to turn the light on or off.
You can also increase/decrease the intensity of the light by using the
slide control. When the Light button indicator flashes use the slide to
vary the intensity of the light, i.e. 2 bars = low light, 8 bars = high light.
You can use the Timer button and slide control to set the time delay
after which the hood will close down automatically. To operate, press
the Timer button then use the Slide Control to set the delay time, i.e.
each bar = 5 mins providing you with a time range between 5 minutes
(min) to 40 minutes (max). Once the set time has elapsed, the hood
will automatically switch off the main body section will close.
For best results, we recommend that the Cooker Hood is switched on at
least 10 minutes prior to cooking and left to run for a period of 10 minutes
after cooking is finished.
9
Section 4. Maintenance
4.1. Cleaning the Main Filter
Periodically remove the aluminium filter (as shown below) and wash with warm
soapy water. Ensure the filter is dry before re-fitting.
The main body of the cooker hood should be cleaned with warm soapy water –
never use abrasive detergents on either the filter or main body.
4.2. Replacing the Lamps
To replace a LED Lamp, isolate the power, press and remove the lamp holder
as shown below. Replace it with the same type/wattage (1w) and refit.
10
4.3. Replacing the Charcoal Filter
To replace the charcoal filter(s), proceed as shown in Section 1. Installation.
4.4. What to do if something goes wrong
The light(s) does not work:
-
The LED lamp has probably blown. Replace the lamp as referred to in
Section 4.2. Please note that light bulbs/lamps are not covered by any
guarantee offered with this appliance.
Motor operates but level of extraction appears to be poor:
-
Check and clean the filter as detailed in Section 4.1. Dirty filters will
cause a noticeable drop in performance. If you are using the appliance
on ‘re-circulation’ mode the charcoal filter may require changing as
detailed in Section 4.3.
There is no power to the appliance:
-
Check there is not a power cut
Check there is power to the electric socket/appliance
Check the fuse in the plug and/or spur (3amp)
YOUR GUARANTEE IS VALID ONLY IN THE UK.
To Register your Appliance simply complete the card in your appliance pack and return it with a
stamp affixed or Alternatively you can Register online at www.repairtechuk.com
SERVICE HELP-LINE
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133
Please remember to have all your product details available, including the model number, serial
number, date of purchase and your retailer’s details before registering a fault.
Your service call cannot progress without this information.
DOMESTIC APPLIANCE DISTRIBUTORS;
HENRY JOHN HOUSE
NORTHWAY LANE
ASHCHURCH
TEWKESBURY
GLOUCESTERSHIRE
GL20 8JH
11
Section 5. Circuit Diagram & Product Dimensions
MON- DDCH60
12
MON-DDCH90
13
Important Note:
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The symbol on the product, or on the documents accompanying the
product, the Crossed Out Wheelie Bin, indicates that this appliance
may not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical
and electronic equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information
about treatment, recovery and recycling of this product, please
contact your local authority, your household waste disposal service
or the retailer where you purchased the product.
We continuously try to improve our products for the benefit of our customers.
For this reason we reserve the right to make changes to any product at any time,
without notice
Issue: 03/01-03-2016
14
Download PDF
Similar pages