Daphne Commercial Style Kitchen
DAPHNE COMMERCIAL STYLE
KITCHEN
Polished Chrome
Satin Nickel
8 14"
ITEM #
1
2
3
4
5
6
7
8
100MK10
100MK75
8
4 14"
DESCRIPTION
QTY
Faucet body
Rubber washer
Plastic spacer washer
Lock nut
Cold supply line hose
Hot supply line hose
Shower
Small rubber washer
1
2
1
1
1
1
1
1
7
Note.
Before proceeding with the assembly, it is highly
recommended to purge the hot and cold water
piping to prevent accumulation of dirt and residue
which could cause malfunctioning of the mixer.
1
2
3
2
21 8"
3
5 7 8"
6”
4
Recommended water pressure
=
28 psi ~ 71 psi
Suitable dimension of sink hole
=
13 8" ~ 112"
5
6
Faucet Installation
Remove washers, plastic spacer washer and lock nut from the faucet body.
max 1 7 8" 13 7 8"
Apply a ring of silicone caulking around hole designated for spout.
DO NOT USE PLUMBER’S PUTTY WHICH CAN DAMAGE THE
FINISH OF YOUR FAUCET.
From the top of the counter, insert the spout threaded shank through the center hole
of the sink.
From below, slip rubber washers and plastic spacer washer and attach the lock nut
and tighten it.
Connect hoses to the supply liness.
After the connections have been made, turn on the water supply and check for
leakages at all joints. If water leaks from any of the connections, tighten the
connection until the leakage stops.
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within 30 days of purchase.
Santec reserves the right to request additional documents before servicing warranty requests.
01
If no leakage, remove shower assembly being careful not to lose small rubber washer.
Then turn the handle to the full open position and let the water flush for 45 seconds.
After flushing line, reattach the shower head. This can prevent damages to the
ceramic cartridges caused by debris in the supply line.
02
Daphne Commercial Style Kitchen
USAGE
SANTEC LIFETIME LIMITED WARRANTY
Close
Cold
Hot
Switch Button
1.
Finishes: Santec Polished Chrome, Polished Orobrass and Satin Nickel finishes
carry a Lifetime Limited warranty against manufacturing defects and tarnish to
the original purchaser with the exclusion of kitchen drain assemblies which,
due to the nature of their use, are not warranted. Santec recommended
custom finishes carry a ten (10) years limited warranty against manufacturing
defects and tarnish to the original purchaser with the exclusion of kitchen and
pop-up drain assemblies which, due to the nature of their use, are not
warranted. Kitchen products carry a three (3) year limited warranty.
2.
Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing
defects for the life of the product to the original purchaser.
3.
Parts: Santec parts carry a ten (10) year limited warranty against manufacturing
defects, to the original purchaser. Kitchen products carry a five (5) year limited
warranty.
4.
Warranty exclusions and limitations: This warranty does not cover: damage due to
negligence, accident, abuse, improper installation, or improper maintenance such as,
but not limited to: heat from soldering during installation, the use of plumbers putty,
damage from tools used during installation, the use or exposure to chemicals or
cleaning products either abrasive or non abrasive or the use of any cleaning tool or
product other than a soft, clean cloth. This warranty does not cover: changes in the
finish or in the product due to normal wear or aging and does not cover any products
or parts which have been altered or used in a manner not typical for the product. This
warranty does not cover and Santec will not be held liable for damage to products
caused by the freight carrier and a claim should be made immediately to the freight
carrier should this occur. This warranty does not cover any cost involved in the
installation, repair, or replacement of any Santec product or part. This warranty does
not cover and Santec will not be held liable for any loss, damages, or expenses,
incidental or consequential whatsoever, originating from the purchase, installation,
use, repair, failure, or replacement of any Santec product or part, as allowed by law.
The product or components of the covered product will either be repaired, refinished
or replaced, at the sole discretion of Santec. Santec reserves the right to examine any
product claimed defective prior to any warranty claim being accepted or processed,
at its sole discretion. This warranty gives you specific legal rights and you may have
other rights which may vary from state to state.
Open
Lever
Effective 01/01/08 - Replaces and supersedes any previously issued warranty
FINISH CARE INFORMATION
For clear coated or enamel color finishes:
For non-clear coated and specialty finishes:
We recommend that all faucets, drains, etc
be gently wiped dry with a soft cloth after use
to avoid water spotting and water deposit
buildup. A mild liquid hand soap, such as Ivory
may be used occasionally if desired. Use of
non-abrasive carnauba wax will add
protection to the finish and should be used if
the faucets will not be dried after use.
We recommend that all faucets, drains, etc be
gently wiped dry with a soft cloth after use to
avoid water spotting and water deposit
buildup. Use of a non-abrasive carnauba wax
is required occasionally.
PLEASE REGISTER YOUR PRODUCT ONLINE FOR WARRANTY SERVICES
www.santecfaucet.com/registration
03
04
Download PDF
Similar pages