Hestan Outdoor Faucet_Installation Instructions_5_18_17.cdr

LIMITED LIFETIME WARRANTY
STANDARD MAINTENANCE AND TROUBLESHOOTING
INSTALLATION MANUAL
& PRODUCT WARRANTY
AGOF Pull-Down Prep Faucet
(Hestan Part Number: AGOF)
Replacing the Cartridge
1. Shut off the water supply to the faucet
2. Turn on the faucet briefly to relieve any pressure inside the faucet
3. Move the faucet handle to the “OFF” position
4. Remove set screw from handle using an allen key
5. Pull the lever handle H from the faucet body
6. Unscrew the cartridge cap G
7. Unscrew the cartridge nut F
8. Lift ceramic disk cartridge E from the body and replace it with
new cartridge. Ensure the 2 lugs on the bottom of the cartridge
sit properly in the locating holes in the faucet body.
9. Re-assemble faucet in reverse order
10. Test for leakage
General Maintenance
• Clean aerator periodically for any buildup
• Do not use harsh detergents, solvents, chemical agents,
especially any containing CHLORINE, or metallic sponges as
these can damage the surface finish
• Clean only with soft sponge and soapy water
• ATTENTION! For outdoor installation product must be
protected from freezing temperatures. Disconnect hot and
cold supply hoses from home, open the handle to drain out all
water. Cover faucet with protective covering to keep warm.
Spare/Replacement Parts List
A. F3507
Spray Hose Assembly
B. F3303
Spray Head Assembly
C. F3305
Aerator and O-ring
D. F3306
Aerator Key
E. F206502 Cartridge
F. F3505
Cartridge Nut
G. F3504
Cartridge Cap
H. F3301
Handle Assembly
I. F3415
Fastening Set
J. F3508
Cold Supply Hose
K. F3507
Hot Supply Hose
L. F3510
Spray Supply Hose
M. F205514 Weight
The HHC AGOF faucet installed in a private residence will carry a
limited lifetime warranty on all mechanical parts to be free of
manufacturing defects in material and workmanship under normal
usage. This faucet is also warranted for outdoor installations for a
period of ten (10) years from the original date of purchase. All chrome
finishes carry a limited lifetime warranty; all other finishes are
warranted for five (5) years from the original date of purchase.
This warranty applies only to the original owner, providing the
product has been installed in accordance with our installation
instructions, used as recommended and in a normal residential
application. In the event of a warranty claim, the owner will be
required to provide proof of purchase - save sales receipt. This
warranty covers all components which make the product operational.
HCC, at its option, may repair or replace the product or
components necessary to restore the product to good working
condition. HCC reserves the right to inspect the installation prior
to the actual replacement of the product or component part. This
warranty does not cover misuse or abuse, accidental damages,
scuffs or scratches, improper installation, abnormal usage, negligence
or damage caused by improper maintenance or cleaning. Normal
wear of parts is excluded from the warranty. Damage caused by
impurities or acts beyond our control are not covered. Any product
or part which has been repaired or altered in any manner outside of
HCC’s factory, unless previously authorized in writing by HCC,
will void warranty. Any replacement excludes transportation and
any labor re-installation costs. This warranty does not allow
recovery of incidental or consequential damages such as loss of
use, delay, property damage or other consequential damage,
and HCC accepts no liability for such damages.
The HCC warranty on this faucet is limited to the above conditions
and to the warranty period specified herein and is exclusive. HCC
DISCLAIMS all other warranties, expressed or implied, including
IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS
FOR A PARTICULAR PURPOSE. This warranty gives you specific
legal rights that may vary from state to state.
B.
C.
E.
Hestan Commercial Corporation (”HCC”) extends the following
warranty to the original purchaser of the AGOF faucet effective
April 20, 2017.
F. G. H.
Further information
For any further information about our products, about the installation
of them or about the guarantee, please contact Hestan Commercial
Corporation at: 1-888-905-7463
D.
I.
M.
A. L. K. J.
P/N 012591 Rev A
TECHNICAL DATA
INSTALLATION INSTRUCTIONS
•
•
•
•
•
1. Remove all contents from the package and check for
completeness.
Flow rate –1.75 gpm at 60 psi
Recommended water pressure – 30-85 psi
Max water pressure – 115 psi
Max water temperature – 158 oF
Hole size for faucet – 1 3/8"
2. Turn off water supply.
3. Remove faucet (1) and hardware from its protective packaging –
faucet comes assembled. Remove fixing hardware.
Note
Contact us immediately if you see inconsistencies:
• Phone: 1-888-905-7463
4. Cut mounting hole 1-3/8" in diameter (35mm) in the desired
position (if one isn’t available).
5. Ensure rubber o-ring (2) is in the base of the faucet and install
faucet into mounting hole – DO NOT use putty or other sealant
at this location.
Contents in Box
A. Faucet assembly
B. Supply hoses
C. Allen wrench
D. Weight
E. Aerator wrench
F. O-ring
G. Plastic flange
H. Rubber and steel washer
I. Fixing nut
J. Spray hose
1
2
6. Install the mounting hardware to the base of the faucet body in
the following order: Rubber washer (3), plastic flange (4), steel
washer (5), and fixing nut (6). Tighten screws in fixing nut to
secure faucet.
7. Connect spray hose (7) to the spray hose supply in the
base of the faucet (9).
8. Attach the clip-on weight (8) to the spray hose approximately 2"
above the bend in the bottom of the spray hose.
3
9. Connect the supply hoses (10 & 11) to the water supply in the
home.
4
5
A.
10. Remove the aerator using the aerator wrench, turn on the water
and flush the faucet for any debris. Check for leaks, and
reinstall the aerator.
6
F.
7
J.
9
B.
G.
8
H.
C.
I.
D.
E.
2"
10
11
Download PDF
Similar pages