initial installation button identification 1. volume/off 2. 3. al on/off 4. al

GB-2
INITIAL INSTALLATION
ALARM SETTING
1.
BUTTON IDENTIFICATION
SET VOLUME/OFF KNOB AT OFF POSITION. PRESS AL ON/OFF
1.
VOLUME/OFF
2.
MODE
3.
AL ON/OFF
INDICATOR WILL TURN ON AND THE [:] WILL STOP BLINKING.
4.
AL SET
PRESS THE TWO BUTTONS UNTIL THE DESIRED HOUR APPEARS,
5.
LIGHT / TIME
THEN PRESS AL SET AND MINUTE BUTTON TOGETHER TO SET
6.
AM/FM
THE DESIRED MINUTE.
7.
HOUR
8.
MINUTE
BUTTON TO ACTIVATE THE ALARM FUNCTION
2. PRESS AL SET AND HOUR BUTTON SIMULTANEOUSLY AND THE AL
3. IF NO ALARM ICON “
”APPEARS ON LCD, PLEASE PRESS AL
ON/OFF TO TURN ON ALARM ON AND THE ALARM ICON WILL
SHOW ON UPPER RIGHT CORNER.
9.
LCD DISPLAY
10.
TUNING
11.
MIRROR
OFF TO STOP THE ALARM OR IT WILL STOP AUTOMATICALLY IN
12.
HANDLE
THREE MINUTES.
13.
ADJUSTABLE STAND
5. TO CANCEL THE ALARM FUNCTION JUST PRESS AL ON/OFF
14.
BATTERY DOOR
BUTTON.
15.
HANGER SLOT
4. IT WILL ACTIVATE THE ALARM AT THE PRESET TIME.
PRESS AL
NOTE: TO VIEW THE ALARM TIME, PRESS AL SET BUTTON.
RADIO OPERATION
1.TURN THE VOLUME TO YOUR DESIRED LISTENING LEVEL AND
SET THE BAND SELECTOR TO YOUR FAVOURITE BAND(AM/FM).
THEN ROTATE TUNING KNOB TO CHOOSE RADIO STATION THAT
YOU WANT.
2.ON RADIO MODE
PRESS THE MODE BUTTON AND THE CURRENT
TIME WILL SHOW ON THE DISPLAY.
GB-1
NOTE:
BOTH FM AND AM ANTENNA ARE BUILT-IN
IN THE UNIT.
GB-3
BACKLIGHT
PRESS LIGHT/TIME BUTTON TO TURN ON THE
BACKLIGHT TO SEE
THE DISPLAY FOR FEW SECONDS.
MOUNTING
USING THE ADJUSTABLE STAND:
Loosen the screw with a
THE UNIT CAN STAND ON THE TABLE AT TWO DIFFERENT ANGLES
screwdriver and remove
BY PULLING OUT THE ADJUSTABLE STAND.
IT WILL STOP AT ONE
OF THE TWO CLICKS IN THE CABINET.
USING THE HANDLE :
TAKE OUT THE HANDLE AND HOOK IT SECURELY ON THE WALL.
USING THE HANGER HOLE:
HANG THE UNIT ON THE WALL USING THE HANGER SLOT AT THE
BACK OF THE UNIT .
install batteries to its
replace the cover
SPLASH PROOF:
correct polarity
to fasten the screw
THE UNIT IS DESIGNED FOR SPLASH PROOF (IPX4) IN THE SHOWER.
BUT DO NOT IMMERSE IT IN WATER.
NORMAL TIME SETTING
1.
PRESS THE KEY COMBINATION OF
OR [MINUTE]
[LIGHT/TIME]
[HOUR]
TO ENTER THE TIME SETTING.
2. ONE DIGIT WILL BE INCREMENTED .
CORRECT TIME APPEARS.
KEEP PRESSING UNTIL THE
VENTILATION WARNING:
THE NORMAL VENTILATION OF THE PRODUCT SHALL NOT BE
IMPEDED FOR INTENDED USE.
GB-4
TECHNICAL SPECIFICATIONS
Recycling
POWER: 6V DC; 4LR06
This product bears the selective sorting symbol for
AM FREQUENCY RANGE:
waste electrical and electronic equipment(WEEE)
520(+/-10KHZ)-1640(+/-20KHZ)
This means that this product must be handled pursuant to European
FM FREQUENCY RANGE:
Directive 2002/96/EC in order to be environmentally friendly.
87.5(+/-0.4MHZ)-108(+/-0.4MHZ)
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are
potentially dangerous for the environment and human health due to the
presence of hazardous substances.
Net weight……265.2g
GB-5
Download PDF
Similar pages