User manual - Centre du Rasoir

Always here to help you
Register your product and get support at
www.philips.com/welcome
HC7450/80
HC5450/80
HC5450/16
HC5450/15
User manual
1
6
English
Introduction
Congratulations on your purchase and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Cutting unit
2 Zoom wheel adjustment ring
3 On/off button
4 Charging light
5 Trimming comb
6 Beard comb (HC7450/80, HC5450/80 only)
7Adapter
8 Socket for small plug
9Brush
10 Case (HC7450/80, HC5450/80 only)
11 Comb (HC7450/80 only)
12 Scissors (HC7450/80 only)
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Danger
-- Keep the adapter dry. 
Warning
-- The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
-- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
-- Children should be supervised to ensure that they do not play with the
appliance.
Caution
-- Never immerse the appliance in water or rinse it under the tap. Only
the cutting unit can be rinsed under the tap.
-- Use, charge and store the appliance at a temperature between 5°C
and 35°C.
-- Only use the adapter supplied.
-- If the adapter is damaged, always have it replaced with one of the
original type in order to avoid a hazard.
-- Do not use the appliance if the cutting unit or the trimming comb is
damaged or broken, as this may cause injury.
Electromagnetic fields
This Philips appliance complies with all standards and regulations regarding
exposure to electromagnetic fields (EMF).
English
7
General
-- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages from 100 to 240 volts.
-- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
Charging
Charge the appliance fully before you use it for the first time or after a long
period of disuse.
It takes approximately 1 hour to fully charge the appliance.
When it is fully charged, the appliance has a cordless operating time of up
to 75 minutes (HC5450) or up to 120 minutes (HC7450/80).
Note: After charging the appliance once fully for the first time, you can also
use the appliance directly from the mains. Simply connect the appliance to the
mains.
Charging indications
Battery low indication
-- When the battery is almost empty, the charging light starts to flash
orange.
Charging
-- When the appliance is charging, the charging light flashes green.
Battery fully charged
-- When the battery is fully charged, the charging light lights up green
continuously.
Note: After 30 minutes, the charging light automatically switches off.
8
English
Charging the appliance
1Make sure the appliance is switched off.
2Insert the appliance plug into the appliance.
3Put the adapter in the wall socket.
4After charging, remove the adapter from the wall socket and pull the
appliance plug out of the appliance.
Optimising the lifetime of the rechargeable battery
When you have charged the appliance for the first time, we advise you to
use it until the battery is completely empty. Continue to use the appliance
until the motor almost stops operating during a session. Then recharge the
battery. Follow this procedure at least twice a year.
Using the appliance
The hair length settings are indicated in millimeters, the comb cuts the hair
to a length of 1mm to 23mm. The settings correspond to the remaining
hair length after cutting.
When you trim for the first time, be careful. Do not move the trimmer
too fast. Make smooth and gentle movements.
Tip: Start trimming at a high length setting and reduce the length setting
gradually until you have reached the desired hair length.
Trimming with comb
1Attach the comb onto the appliance.
English
2Turn the adjustment ring to the desired length setting.
Note:When you trim for the first time, start at the highest length setting
to familiarise yourself with the appliance.
3Switch on the appliance.
4To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in contact
with the skin.
Trimming without comb
Use the trimmer without the trimming comb to clip hair close to the skin
(0.5mm) or to contour the neckline and sideburns.
Be careful when you trim without comb because the cutting
element removes every hair it touches.
1Push the comb off the appliance.
2Switch on the appliance.
9
10
English
3Make well-controlled movements. Touch the hair lightly with
the trimmer.
Using the beard comb (HC7450/80, HC5450/80 only)
The hair length settings are indicated in millimeters, the comb cuts the hair
to a length of 1mm to 23mm. The settings correspond to the remaining
hair length after cutting.
1Attach the comb onto the appliance.
2Turn the adjustment ring to the desired length setting.
3Switch on the appliance.
4To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in contact
with the skin.
English
11
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Never immerse the appliance in water or rinse it under the tap.
Note: Only the cutting element and the comb can be cleaned with water.
1Make sure the appliance is switched off and disconnected from the
mains.
2Wipe the housing of the appliance with a dry cloth.
3Remove the comb and clean it with the brush or rinse it under the
tap.
4Press the release button (1). The cutting unit comes off the appliance
(2).
5Clean the cutting unit with the brush or rinse it under the tap.
6Clean the inside of the appliance with the brush.
Never immerse the appliance in water or rinse it under the tap.
7Shake off excess water. To reattach the cutting unit, insert the lug of
the cutting unit into the guiding slot.
8Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
12
English
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1Press the release button (1). The cutting unit comes off the appliance
(2).
2Insert the lug of the new cutting unit into the guiding slot (1) and
push the cutting unit back onto the appliance (2).
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer
Care Centre in your country (see the worldwide guarantee leaflet for
contact details).
Environment
-- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
-- The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before you discard and
hand in the appliance at an official collection point. Dispose of the
battery at an official collection point for batteries. If you have trouble
removing the battery, you can also take the appliance to a Philips
service centre. The staff of this centre will remove the battery for you
and will dispose of it in an environmentally safe way.
Removing the rechargeable battery
Only remove the rechargeable battery if it is completely empty.
English
13
1Disconnect the appliance from the mains and let the appliance
operate until the motor stops.
2Press the release button (1) and remove the cutting unit (2).
3Insert the screwdriver between the motor unit and the back panel of
the appliance. Press down the screwdriver as far as it will go
4Tilt the handle of the screwdriver downwards (1) and separate the
back panel from the appliance (2).
5Remove the side panels. Pull the bottom part of the printed circuit
board with the rechargeable batteries attached from the appliance.
6Cut the wires to separate the rechargeable batteries from the
appliance.
Do not connect the appliance to the mains again after you have opened
it.
Guarantee and support
If you need information or support, please visit
www.philips.com/support or read the separate worldwide
guarantee leaflet.
8222.002.1000.1
Download PDF
Similar pages