FI SY TAP REV D2 - Victorian Plumbing

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care to preserve the
visible surfaces.
All surface finishes will wear if not cleaned correctly, the only safe way to clean your
mixer is to wipe with a soft damp cloth. Stains can be removed using washing up
liquid. All bath cleaning powders and liquids will damage the surface of your fitting,
even the non-scratch cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5 year guarantee
covers any defect in manufacture.
As gold and special effect finishes are softer than chromium plate,
special care must be taken when cleaning, a 3 year guarantee covers these
finishes.
NOTE: The 5-year guarantee on the cartridge is invalidated if damaged by any
waterborne debris.
In the interests of continuous product development we reserve the right to alter
specification as necessary
Spray Basin
Tap
PRODUCT CODE: SY ON ½ C CD & SY SL ½ C CD
PRODUCT IDENTIFICATION CODE LASER ETCHED ON PRODUCT
Installer please fill in code here
.
Fitting Instructions
& Contents List
TELEPHONE HELPLINE! +44 (0)844 701 6273
Bristan Group Limited
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Website: www.bristan.com
Telephone:+44 (0) 844 701 6274
Facsimile: +44 (0) 844 701 6275
Email: enquire@bristan.com
(FI SY TAP)
(Rev.D2)
This product has been approved by the Bathroom
Manufacturers Association (BMA) under it’s labelling Water
Efficient Product Labelling Scheme. By installing this
product, you will be able to reduce the amount of water you
use in your home and the amount of energy you use to heat
it; a boost for the environment and your pocket.
Please keep these instructions for future reference and request of
replacement part
WATER PRESSURE
These taps are suitable for use at all supply pressures. If the taps are installed at low pressure (tank fed), then the minimum height from the
outlet of the nozzle to the underside of the cold tank should be at least
2 metres to ensure adequate performance.
1
These taps should be installed incompliance with Water Regulations. For
further details contact your Local Water Authority.
INSTALLATION
1. Identify all components and check for completeness, particularly before arranging fitting.
2. Install the taps into the basin, using the washers (6) and backnuts (7)
provided.
3. Connect the hot and cold water supplies.
4. Un-screw the spray guides (8,9 &10) from the taps.
5. Turn on the water supplies. Open both taps letting the water flow for a
few minutes to flush the system.
6. Refit the spray guides (8,9 &10) to the taps.
7. Check all joints and connections for leaks.
8. See over the page fo
r aftercare instructions.
MAINTENANCE
If the fitting begins to drip
1. Turn off the water supply.
2. Prise off the head cap (1), unscrew the head retaining screw (2).
3. Remove fitting head (4) and unscrew the valve (5) from the body.
4. Carefully clean seating and rubber washer and check the ceramic discs
for damage.
5. Replace valve and turn on the water supply.
6. Contact our helpline if problem persists.
10
Download PDF
Similar pages