Caution:this plane is not a toy!
Before use ,please carefully read this
manual.
Wing Span:66.9in/1700mm;Flying Weight:3000g;
Wing Area:50sq.dm;
Radio:4channels 5servos;
Length:57in/1450mm;
Engine:2cycle 60 or 4cycle 91
KIT CONTENTS
AILERON SERVO INSTALLATION
Cut away covering film for
the servo.
Glue the servo to prepared
servo plywood,then put the
servo into the servo hole.
Pull out the servo extention
from main wing.
Fixup the servo by the screws,
then adjust the horn and servo
arm.
Fix the horn in place firmly.
MAIN WING INSTALLATION
Find out the horns in each
sides of the fuselage,
then cut the film.
Insert the joiner into the
fuselage,and find the left
and right main wing in the
right position.
Fasten the wings by the
screws provided.
Pull the servo extentions
into the fuselage from the
main wing.
ELEVATOR & RUDDER SERVO INSTALLATION
Find and cut the hole for
stabilizer.
Find and Cut the hole for
vertical tail.
Find and cut the hole for
elevator servo.
ADJUSTMENT
Cut away the film along the
edges.
Glow the stabilizer to
the fuselage.
Cut away the film for the
rudder servo.
TAIL WHEEL INSTALLATION
Cut the hole for hinge
assembly.
Screw the tail landing gear
to the tail wheel by the
screw provided.
Insert the tail wheel into
the vertical fin as shown.
Insert the Vertical Fin to
the tail fuselage.
Install the tail wheel and
fasten the presser of the
tail wheel to the stabilizer
by screws.
Connect the control horn to
the linkage of the servo.
Assemble the elevator control
horn.
Assemble the other side
elevator servo as shown.
Assemble the rudder control
horn.
MAIN LANDING GEAR INSTALLATION
Screw the wheel to the
landing gear.
Be assured that the screw
is fixed up.
Install the wheel cover,
and fix it up to landing
gear with TP screw.
Fixup the landing gear
strut to fuselage with 3
bolts.
ENGINE INSTALLATION
Line up the template with the
firewall thrust lines and
mark the location of the
engine mounting holes.
Use a drill to dill the
engine mounting holes.
If use 4cycle 91 size.
Install the engine mount
on both sides with four
3mm screws.
If use 2cycle 60 size.
Use the same method to this
size engine.
FUEL TANK INSTALLATION
Install the trottle servo
as shown.
Install the fuel tank into
the fuselage, and fixup it
with belt.
Fuel tank detail assembly
picture as shown.
Install the elevator and
rudder servo and throttle
into fuselage as shown.
COWL INSTALLATION
Install the cowling with
4pcs TP screws.
CANOPY INSTALLATION
Assemble the movable canopy.
Make sure it is securitly
CONTROL THROWS & CG POSITION
Download PDF
Similar pages