Physical Description Functional Description Web Configuration

16 x 10/100Base-TX PoE + 2 x Gigabit SFP Combo Ports Web-Smart Ethernet Switch
This quick start guide describes how to install and use the 16-port 10/100Base-TX + 2 x Gigabit SFP
Combo Ports Web-Smart PoE Ethernet Switch. This is designed to provide power to PoE driven devices.
Physical Description
The Port Status LEDs and Power Inputs
LED
State
10/100Base-TX
Indication
A valid network connection
established.
Link/ACT
Transmitting or receiving data.
Flashing
ACT stands for ACTIVITY.
Steady Power Device (PD) is connected.
PoE
Power
Device
(PD)
is
Off
disconnected.
Steady
LED
State
Indication
10/100/1000Base-TX, Gigabit SFP
A valid network connection
Steady
established.
Link/ACT
Transmitting or receiving data.
Flashing
ACT stands for ACTIVITY.
Valid
port
connection
at
Steady
1000Mbps.
1000M
Valid
port
connection
at
Flashing
100Mbps.
Off
Valid port connection at 10Mbps.
•
Enter the factory default login ID: admin. Enter the factory default password: admin. Then click on the
“OK” button to log on to the switch.
Functional Description
•
Supports IEEE802.3af Power over Ethernet (PoE) Power Sourcing Equipment (PSE).
•
Full PoE Power supplies up to 15.4W per port.
•
4096 MAC addresses. 2.75M bits buffer memory.
•
PoE (Power status, Link status) through the Web browser interface.
•
Administrator, Port Management, VLAN Setting, Per Port Counter, QoS Setting, Security, Trunking,
Rack-mount Kits
Backup/Recovery, Miscellaneous, and Logout through the Web browser Interface.
•
10/100Mbps, 10/100/1000Mbps, Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX.
•
Full wire-speed forwarding rate.
•
100~240VAC, 50~60Hz Internal Universal PSU.
•
0℃ to 45℃ (32℉ to 113℉) operating temperature range.
•
Metal case. Supports Rack Mounting installation.
•
The ITE is to be connected only to PoE networks without routing to the outside plant.
Web Configuration
•
Login the switch:
Specify the default IP address (192.168.2.1) of the switch in the web browser. A login window will be
•
Install the rack-mount kits with eight screws.
•
Use four screws to install the unit in a 19” cabinet. We suggest using two screws per ear to install in
a 19” cabinet.
shown as below:
•
The heads of the screws should be less than 5 mm in diameter, and the shafts should be less than
2.93 mm in diameter, as show in the figure above.
1
V1
Download PDF
Similar pages