Berner Drive thru Unit 03 Air Curtain Quick Setup

Parts Diagram
Spanning Bracket
Wall Mounting
Holes
Drive-Thru Unit Air Curtain
or
™
Standard
Mounting
Bracket
Air Intake Grill
End Cap
1-800-343-7991
www.berner.com
Quick Setup Guide
Drive-Thru Unit Quick Setup Guide
For Models: DTU03-1018AA, DTU03-2026AA, DTU03-1018EA, DTU03-2026EA
!
B EFOR E M OU N T I NG
1-800-343-7991
Unit will arrive with Standard Mounting Brackets
attached & a set of Spanning Brackets.
Before setup and operation of this Air Curtain, please see the
safety instructions in your Installation Instruction document.
How the Standard Mounting Bracket works
Standard
Mounting
Bracket
Compact
Mounting
Hole:
Allows unit to
mounted closer
to the wall
™
Pivot Thumbscrew:
Affixes mounting bracket
to Air Curtain
*See back page for parts diagram
Spanning
Bracket
Position Lock
Thumbscrew:
Can be loosened and
reset to any of the
holes on the end cap
of the unit.
NET WEIGHT
AMBIENT (lbs)
NET WEIGHT
ELECTRIC (lbs)
DTU03-1018
DTU03-1026
10
13
11
14
Use the Spanning Brackets when there is no suitable place to attach the
Standard Brackets above or behind the unit. Or stated another way, when
the only suitable attachment surface is out to the side of the unit.
2. Choose mounting method: above the unit, behind the unit
(Standard or Compact Mounting Hole), to the sides with the
Spanning Brackets, or with the Adjustable Extension Brackets.
STEP
Note: Adjustable Extension Brackets are an accessory that can be
purchased to replace the Standard Brackets and allow for a mounting
distance of up to 9” from the Air Curtain.
3. Before drilling holes in the wall to attach the mounting bracket,
mark drilling points by holding the whole Air Curtain up to the
wall and positioning the brackets where you would like them to
be mounted. Make drilling points by marking the wall through
the holes of the brackets.
4. Remove the brackets from the unit, and back out the Position Lock
Thumbscrews so they will not be in the way in step 6.
AIR
Discharge
Nozzle
18” minimum
r
Ai
Air Split
Location
5. Attach the brackets to the wall.
6. Position the unit in between the mounted brackets and reinstall
the Pivot Thumbscrews.
2
After mounting, use the Position Lock Thumbscrew
to achieve the proper angle of air flow.
r
Ai
M OU NT IN G S TE P S
1. Remove Air Curtain and Spanning Brackets from packaging.
MODEL
Attaching Standard Bracket
to Spanning Bracket
STEP 1
M O U N T I NG NOT ES
• Mount as close to the top of the window opening as possible.
• The supporting structure and mounting hardware should be
capable of supporting a minimum of three times the weight of
the unit.
When is it appropriate to use the Spanning Brackets?
Exterior
Interior
Rotate the Air Curtain by
adjusting its position in
the mounting brackets so
the split location is at the
base of the window.
Download PDF
Similar pages